View Single Post
  #29  
Old 12-08-2012, 09:26 PM
SWGA Boater's Avatar
SWGA Boater SWGA Boater is offline
TT Enthusiast
 
Join Date: Oct 2012
Boat: Not a MasterCraft
Location: Southwest Georgia
Posts: 203
Progressing slowly. I removed the engine harness, steering and throttle/trans cables last night. I was only able to work a few hours today. More hacking, cutting and prying with the foam. I would estimate I have removed about half of the bow foam. Right side is not stuck to the hull so it is easier to cut out large chunks. Hope to finish up with the foam in the next day or so. I'll post a few images when I finish up.

Does anyone know if a new or reman engine harness is still available. The harness is not in too bad of shape, but has a couple of wires with bad nicks and splices.
Reply With Quote