View Single Post
Old 11-17-2012, 09:30 AM
reftech reftech is offline
TT Enthusiast
Join Date: Aug 2012
Boat: 1987 mastercraft prostar 190
Location: southeast
Posts: 149
I'm thinking the sand is from the bottom of the lake when they let the water level off for owners to do dock work.he never removed the boat from the water so the intake fitting was on the bottom of the lake possibly. I masked the rub rail with standard 3/4 inch 3m tape and that is plastic sheeting from Lowes.the white paper is standard paint masking paper on a roll.the motor also had a cracked block at cylinder 7 and two freeze plugs were out.luckily I already had a motor out of a supra ts6m with 500 hours on it so all I had to do was change over the marinization parts from PCM to indmar off of the original motor.I then put new belts hoses and all new ignition and tune up parts as well as new seal and impeller on the rwp.the tranny had a front seal leak which I replaced also.
Reply With Quote