View Single Post
  #22  
Old 07-25-2012, 11:09 AM
jmhjgh jmhjgh is offline
TT Regular
 
Join Date: Apr 2010
Boat: Mastercraft,205,1996
Location: Midwest
Posts: 66
The Napa fuel filters look like the case is made of aluminum. I was planning to solder on a schrader valve to a new fuel filter so that I can use a regular fuel pressure gauge to check my fuel pump. However, the aluminum case poses a problem. JB Weld may work, but I am not sure that would hold up to 40-50 psi? Maybe the female threaded connector could be drilled and tapped for 1/8" pipe thread for the schrader valve? Any other ideas?
Reply With Quote