View Single Post
  #13  
Old 07-17-2012, 12:08 PM
SugarLake's Avatar
SugarLake SugarLake is offline
TT Regular
 
Join Date: Sep 2009
Boat: 88 Prostar 190 351W 1:1
Location: Minnesota
Posts: 38
Quote:
Originally Posted by thatsmrmastercraft View Post
There is a spec in the rebuild kit for measuring the distance between the float and the surface of the fuel bowl while inverted. Generically this laves the float surface level with the top of the fuel bowl while inverted, but there is a range of measurements (15/64"-1/2") by carb number. There is also a measurement for the secondary float that isn't always the same as the primary setting.

Holley 4160 carbs are a breeze to rebuild as long as you follow the instructions completely.
That's what I need is that spec sheet, my rebuild kit instructions I got from the MC dealer didn't have one. It shows you where to measure but nothing on what the measurement should be. These are the instructions I have, which are also the only ones I can find on the Holley site.

http://www.holley.com/data/Products/...l/199R8339.pdf
Reply With Quote