View Single Post
  #28  
Old 05-25-2012, 03:19 AM
Cloaked Cloaked is offline
MC Maniac
 
Join Date: Dec 2004
Boat: MasterCraft
Location: Kingston,TN USA
Posts: 4,602
Nice work. I have enjoyed seeing the progress. This goes to show me how biased in opinion I am about buying into boats and their issues that others inflict upon a new owner. I would have never considered doing this (lack of patience) but this goes to show how most anything can come back from the dead. Good work. I am wondering what you did to the heads for that engine? Were they reusable or did you replace them, and with what head(s)? The GT40 head is hard to find (for me anyway) so I was wondering...... or was that a standard 240 HP engine?

Marine grade plywood can be expensive. I have used builder grade plywood and covered it with epoxy resin which works quite well. Just a suggestion if you please.

I like seeing all of the engine work.

I assume that the parts you have bought on flea-bay are marine / USCG rated / approved? Auto components are not allowed for safe use (USCG). Just curious.

What carb did you buy?

Thanks for the pictures.

.

Last edited by Cloaked; 05-25-2012 at 03:24 AM.
Reply With Quote