View Single Post
  #4  
Old 10-19-2010, 11:41 AM
supturb89's Avatar
supturb89 supturb89 is offline
TT Enthusiast
 
Join Date: Jun 2010
Boat: '96 Prostar 205
Location: Southern IL
Posts: 318
Quote:
Originally Posted by Table Rocker View Post
There is a possibility that the sending unit is not well grounded to the block. Most sending units are shipped with an electrical conducting sealant on the threads. If during installation something like teflon tape was used to prevent leaks a poor ground could result.

You might try running a jumper wire from a good known ground and holding it against the side of the sending unit to see if it changes the reading on the gauge. If the reading changes, the sending unit body is not conducting a good ground from the block.

I hope this helps. Good luck!
So you should not install the sending unit with teflon tape? The previous owner of my boat had installed a "new" sending unit using it and my gauge didn't work correctly. I have since installed a new sending unit (with tape) and gauge. I have yet to confirm if it works properly but the gauge no longer pegs to the right like it was. You can see my problem here:

http://www.mastercraft.com/teamtalk/...ad.php?t=38088

***threadjack over***
__________________
-Aaron
RED 1996 Prostar 205
Indmar 350 TBI
Acme 541
PerfectPass Stargazer Wakeboard Edition
Reply With Quote