View Single Post
Old 03-03-2010, 08:40 AM
Double D's Avatar
Double D Double D is offline
MC Addict
Join Date: Sep 2004
Boat: 1994 Mastercraft, ProStar 205, 350 Indmar with 275 hp
Location: UCLA (Upper Canton, Lower Akron)
Posts: 6,674
Originally Posted by Jesus_Freak View Post
DD, thank you for posting as you are going along. You have saved me needless work. Does the Hardin bolt pattern match up? I dont think I'm going to bother going through with it if I have to drill a new round of holes in the hull.
JF, good question and I don't have the answer yet. I was told that the three holes are at 120 degrees to each other. So a little work with a protractor should tell us something.
I can tell you that I was concerned that I would be going from a 8 screw (bolt) pattern to a 3 screw pattern. But then I saw the picture of the back of an X-something and remembered my original photo on this post (below), and they both have only three (3) attachment points.

First person with a protractor and time to check, let us all know. I used to have one in my board drafting days..... I wonder where its at.....
Attached Images
If its not a competition ski boat, its always second best.

1994 MasterCraft ProStar 205
275 HP 350 Chevy Indmar
Monster Tower & PerfectPass

Check out the MasterCraft Buckeye Bash on Facebook!

"In my many years I have come to a conclusion that one useless man is a shame, two is a law firm and three or more is a congress." - John Adams
Reply With Quote