View Single Post
  #120  
Old 01-27-2010, 07:04 PM
americanskierJim's Avatar
americanskierJim americanskierJim is offline
MC Fanatic
 
Join Date: Jul 2009
Boat: 1980 Mastercraft S&S Powerslot, 351 Windsor
Location: Michigan, Lapeer
Posts: 617
Send a message via AIM to americanskierJim
MrMC. My good friend has one big leathe. He has been making part's for years on it. He put it on the machine found the angle to set the cutter for the tapper side then with the flat side of the post he went stright on with the cutter and turned it down. It did take sometime to get the angle I think it was right around 62.3 degree's off center. I think if we had to we could make new one's right from round stock now that would be a fun project to do too. I was going to polish mine I think I am going to leave it like it is.
Reply With Quote