View Single Post
Old 01-14-2010, 06:23 PM
thatsmrmastercraft's Avatar
thatsmrmastercraft thatsmrmastercraft is offline
MC Master Poster
Join Date: Sep 2008
Boat: 1977 Stars & Stripes
Location: St. Paul, MN
Posts: 16,819
Originally Posted by americanskierJim View Post
HAHAHA Mr.MC can I use yours out of your boat a see if they both would keep me from going under? LOL
I have both a battery and a bilge pump you are welcome to but their only value would be for ballast. Good work on the boat.

I haven't worked much on getting the gelcoat back to life on my boat yet, but there are quite a few threads on here where guys took quite a bit of time working from coarse to extremely fine while working on returning the original shine. Don't know if you have gone through any of the old threads yet but I suspect if you continued wetsanding to a much finer grit or used some compound following the wetsanding you should get the shine you are looking for without a clearcoat. Just passing along some of the info I have read on this site - not from any firsthand experience. Keep up the good work.

Two Chrome 10 hole wheels with Kenda Loadstar radials.
Mounted, balanced & delivered.
With ST205/75R14..........$309
With ST215/75R14..........$346

CARBURETOR REBUILDING - $199 Parts, labor & return shipping included
Holley Marine 4160 Freshly Rebuilt $349 - Delivered (no core charge)

Originally Posted by Bouyhead View Post
Installed my carb that was rebuilt by thatsmrmastsercraft, Thanks Peter!! Hot or cold this boat starts and runs like it fuel injected.
Reply With Quote