View Single Post
  #1  
Old 07-31-2009, 09:52 PM
GunmetalFlake
Guest
 
Posts: n/a
Question How to tighten the 2007 tower (X-45)

I have a 2007 X-45. Recently, my tower started to move around a lot (not just your usual shake), and it turns that the rear starboard mount (behind the driver) was crazy loose.

That mount is held down by two hex bolts that appear to be held down by a nut under the gunwale. I looked under the gunwale where the mount goes in, and there's a very small opening to reach in and access the bottom of the bolts. The problem is that the opening is right under the rear (aft) bolt, and it literally seems impossible that a hand with any conventional tool (e.g. a spanner wrench) can fit in there to grab the fore bolt.

Does anyone have tips on tightening this part of the tower?

Thanks.
Reply With Quote