View Single Post
  #25  
Old 08-07-2008, 09:46 AM
wakeX2wake's Avatar
wakeX2wake wakeX2wake is offline
MC Maniac
 
Join Date: Feb 2008
Boat: 2007 mastercraft x2
Location: Auburn, Al
Posts: 2,845
Quote:
Originally Posted by Roonie's View Post
need more info on where the wire was run from and too.

Great install and looks sharp. May be a winter project for me.
i jumped all the LEDs off my current interior courtesy lights... i wanted it all to work off the same switch and w/ LED pulling such a low amperage there's no problem w/ the number on the circuit... when i removed and replaced the existing courtesy lights i just added a "jumper off that which i could take to any where in the boat... i have both cupholders, port side main area speaker grille, and rear "courtesy" light off of the OEM power supply to the rear courtesy light and the rest of the speaker grilles and the 2 under the dash Pods from the OEM power supply to the front...

LEDs are great in the fact that you pretty much cannot over load the circuit... they're terrible in the fact that you have to make a LOT of really small wiring connections that have to be able to survive a marine environment
__________________
Current - '07 X2 blue on silver metal flake w/ switch graphics

MY LED INSTALL... CHECK IT OUT

MY WAKESIDE RIDE

"It's just water... not concrete or dirt... so just throw it"
-Parks Bonifay

"I feel sorry for people who don't drink... when they wake up that's as good as they're going to feel all day"
-Frank Sinatra

"Indecision may, or may not, be my problem"
-Jimmy Buffett
Reply With Quote