View Single Post
  #8  
Old 07-29-2008, 06:24 PM
Roonie's's Avatar
Roonie's Roonie's is offline
MC Devotee
 
Join Date: Sep 2006
Boat: 2007 MC X2, RTP-1 5.7L 310 HP 1.5:1, 14.25 x 14.5 XMP OJ Prop, bimini, depth finder, and table, teak platform, White/viper red
Location: Pacific Northwest
Posts: 1,602
Fill-drain time set up (reprogramming the pump)

disconnect all batteries from main boat connections for at least 30 seconds. Disconnect plug between pump and active Intelligence box until prgramming is complete. Reconnect power from battery and immediately start toggling switch to enter program mode.

Push toggle to the fill position and toggle between fill and drain 5 times stopping in the off position each time (fill-off-drain-off-fill-off, etc). Do not rush. This should be done in a slow methodical 1 second at each postion pace. Unit will blink when you have entered program mode and the number of blinks will indicate the current fill time in 30 second intervals. The lowest default time is 2 minutes. Therefore 1 blink = 2 minutes, 2 blinks = 2 min 30 sec, 3 blinks = 3 min, etc.

To increase fill time - toggle between off and the fill position, each toggle increases the fill time by 30 seconds up to 6 minutes maximum.

To decrease fill time - toggle between off and drain position, each toggle decreases by 30 seconds.

Increments are 30 seconds (approx. 3.5 gallons per toggle) with minimum fill time of 2 minutes and maximum of 6 minutes. Also the pumps fill at approx 10 GPM.

Reconnect power to pump and run pump in drain cycle until pump stops automatically. This must be done to reset unit timer to zero after programming.

Last edited by Roonie's; 07-30-2008 at 08:57 AM.
Reply With Quote