View Single Post
  #34  
Old 03-27-2008, 08:31 AM
skeeler's Avatar
skeeler skeeler is offline
MC Devotee
 
Join Date: Mar 2005
Boat: MasterCraft X-Star 2008 MCX
Location: Midwest
Posts: 1,219
This will help.
.
Ballast Timing Programming

ALL PUMPS INDEPENDENT OF EACH OTHER. (INCLUDES SWITCHES)
SYSTEMS HAVE AI MODULE FOR EACH PUMP. (3)
DEFAULT SETTING TIME FOR FILL IS 4 1/2 MINUTES.
DURING THE FILL OPERATION THE SYSTEM ONLY READS TIME.
DURING THE EMPTY OPERATION THE SYSTEM READS BOTH TIME
AND AMPS.

BLINK CODES:
1 = AUTO SHUT OFF
2 = PUMP OVER LOAD (POSSIBLE KINKED LINE OR CLOGGED VENT)
3 = POWER LOSS BETWEEN AI MODULE AND PUMP
4 = NO CURRENT OR LOW VOLTAGE.
5 = ?
6 = SYSTEM FULL


SYSTEM WILL REMEMBER LAST SWITCH OPERATION AND HOW LONG.

EXAMPLE: SYSTEM FULL. OPERATOR EMPTIES SYSTEM 1/2 WAY. TIME WAS
2 MINUTES. NOW OPERATOR TRIES TO FILL SYSTEM AGAIN BUT IT
WILL ONLY FILL FOR 2 1/2 MINUTES. SYSTEM DEDUCTED THE 2 MINUTES
FROM THE EMPTY TIME, GIVING ONLY 2 1/2 MINUTES OF FILL TIME.


COMPLETE SYSTEM RESET: BATTERY SWITCH OFF OR DISCONNECT BATTERY

SYSTEM CAN BE RE-PROGRAMED. SEQUENCE AS FOLLOWS:


FROM OFF POSITION. F O E, F O E, ETC. 4-5
TIMES UNTIL LIGHT ON SWITCH STARTS BLINKING
TO ADD TIME: FROM OFF POSITION, F O, F O,
EACH F O SEQUENCE IS 30 SEC. OF TIME.

REPEAT ABOVE, TO EMPTY SIDE OF SWITCH FOR LESS
TIME.

NOTE: RE-PROGRAMING MODE ONLY APPLIES TO THE FILL TIME.
Reply With Quote