View Single Post
  #16  
Old 02-20-2006, 11:15 AM
dichdoc dichdoc is offline
TT Enthusiast
 
Join Date: Jun 2005
Boat: 1984 Stars and Stripes powerslot
Location: Bozeman, MT
Posts: 190
Made pretty good progress yesterday. Removed all the carpet, cut hole in floor to "look" at bubble. It is similiar to other post on the subject. 3 rows of three holes aproximately 2 inches each covered in a layer of thin fiberglass tape. Foam got wet and degraded or froze and popped the 1/8" fiberglass floor loose from the black "W's". Looked like I had a layer of Glueish stuff troweled on with a notched trowel? My thought is to cut out the two area on either side of the motor (18" x72") where its bad and clean it up and reglass. Should I remove all the foam as long as I'm there and put new in? any thoughts? TB
Attached Images
 
Reply With Quote