Thread: WTB: Boat Buddy
View Single Post
  #18  
Old 02-27-2014, 07:56 PM
Ramp-N-Clamp's Avatar
Ramp-N-Clamp Ramp-N-Clamp is offline
TT Enthusiast
 
Join Date: Jan 2014
Boat: 2008 X2
Location: Southeast
Posts: 108
Quote:
Originally Posted by Skyskiguy View Post
If switching from Boat Buddy to R-N-C, will the position of the boat change or remain the same as where it sits with Boat Buddy?
The Ramp-N-Clamp latch mechanism is .4" further away from the mounting bolt center. The top surface of the Stoltz urethane cover is .3" taller from mounting bolt center.

Both of these measurement differences are really not noticeable unless you are looking at the drawings. The boat sits almost exactly the same with either latch.

On my X2 the winch post is about 2" short no matter if I have the roller, BB or RNC. I run a bow strap to pull it down when towing.

RNC

Last edited by Ramp-N-Clamp; 03-17-2014 at 08:55 PM.
Reply With Quote