View Single Post
  #292  
Old 02-23-2014, 10:24 PM
MLA MLA is offline
TT Enthusiast
 
Join Date: May 2012
Boat: pontoon
Location: Lake Wylie Area
Posts: 413
Quote:
Originally Posted by _fng_ View Post
Forgive my ignorance but for "house loads" (top Left connection as shown on pdf below), all I have hooked up to the perko switch is my sub amp. What should be set up to the house loads connection? My single battery set up was 2awg from the engine ground and to the starter. Should there be more to the "house loads" connection other than the sub amp?

side note, both batteries read 12.7x on volt meter with engine off (without putting on trickle charger).

Thanks a lot for helping me out!

http://assets.bluesea.com/files/reso.../990310020.pdf
A "house load" is anything you want to run when the engine is off and have it draw off the newly installed "house bank"

Your head-unit should also be connected house bank. Odd are, its drawing off the cranking as it originally was.
Reply With Quote