Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 7.52 seconds.
Search: Posts Made By: waterlogged882
Forum: General Discussion Yesterday, 06:45 PM
Replies: 5
Views: 107
Posted By waterlogged882
The 90 model will work for your needs. The 91-94...

The 90 model will work for your needs. The 91-94 is the next gen hull and has different wake characteristics for skiing but from what you say, the 90 will work for you. I just prefer the newer...
Forum: General Discussion Yesterday, 06:32 PM
Replies: 5
Views: 107
Posted By waterlogged882
If I recall correctly the Prostar 190 is 19'-6"...

If I recall correctly the Prostar 190 is 19'-6" by title designation.

Six inches over or six feet over....?? Just sayin'

Personally I'd look for a 91-94 190. Same 19'-6".
Forum: Restorations and Refurbishments 05-20-2018, 08:32 PM
Replies: 26
Views: 1,542
Posted By waterlogged882
You can get three applications from one 2 oz....

You can get three applications from one 2 oz. kit. It's a 1:1 ratio with hardener/resin. Use an estimated portion for 1/3. No need to use an entire kit unless you feel compelled. I use a plastic...
Forum: Restorations and Refurbishments 05-20-2018, 08:16 PM
Replies: 26
Views: 1,542
Posted By waterlogged882
I have worked in that area of the hull and...

I have worked in that area of the hull and stringers. You photograph looks the same as what I found when relocating the fuel filter from the side of the stringer to the rear hull area.

I'd repack...
Forum: General Discussion 05-20-2018, 07:06 PM
Replies: 3
Views: 156
Posted By waterlogged882
Your rudder is leaking. (I hope your router is...

Your rudder is leaking. (I hope your router is not leaking water. :D :D )

Common issue as such. Easy to fix. Remove the rudder, replace seals and/or o-rings. Reassemble.

How long have you had...
Forum: Restorations and Refurbishments 05-20-2018, 02:15 PM
Replies: 3
Views: 113
Posted By waterlogged882
The used carb from Jville may be a National Carb...

The used carb from Jville may be a National Carb special. I personally would not have it. Plenty of testimony about their work here. Some OK, most not OK. Your call. Get your new one back. That...
Forum: General Discussion 05-19-2018, 07:49 PM
Replies: 20
Views: 677
Posted By waterlogged882
That boom is bunk. A contoured boom is a...

That boom is bunk.

A contoured boom is a second generation boom design (1st gen - straight boom) to allow the boom to clear the extended length of the windshield onto the gunnel (beyond the...
Forum: General Discussion 05-18-2018, 12:06 PM
Replies: 20
Views: 677
Posted By waterlogged882
thanks

thanks
Forum: Restorations and Refurbishments 05-17-2018, 06:32 PM
Replies: 110
Views: 18,127
Posted By waterlogged882
Think outside the boat..... Get a color you...

Think outside the boat.....

Get a color you agree that may be close. You can also use another color of (for example) gray (or white, etc.) to soften the color by mixing a little bit to lighten (or...
Forum: General Discussion 05-17-2018, 04:26 PM
Replies: 3
Views: 124
Posted By waterlogged882
yes..

yes..
Forum: Engine / Drive Train 05-17-2018, 04:09 PM
Replies: 11
Views: 225
Posted By waterlogged882
You're on it.....Five pounds of pressure would...

You're on it.....Five pounds of pressure would have done the trick but for certain, you have eliminated any possibility of the heat exchanger leaking. You're good to go.
Forum: Engine / Drive Train 05-16-2018, 09:10 PM
Replies: 9
Views: 234
Posted By waterlogged882
I have the entire manual if you need it but the...

I have the entire manual if you need it but the file size limits here do not allow. I can email it.

Do not use any gasket sealer on the gaskets unless specifically directed by the manufacturer's...
Forum: Engine / Drive Train 05-16-2018, 08:50 PM
Replies: 11
Views: 225
Posted By waterlogged882
I was just going to post that. Spot on. I agree...

I was just going to post that. Spot on. I agree on the part number.

The way the diagram is drawn may indicate it is buried. I'd pull the lever off and see what's inside. It has to be very close...
Forum: Engine / Drive Train 05-16-2018, 08:49 PM
Replies: 9
Views: 234
Posted By waterlogged882
You are correct. Patience. I'll find the...

You are correct. Patience.

I'll find the specs and post up asap. I have a lot of info to rummage through.

Note: I have seen and read where some folks pull the engine and set it on a stand for...
Forum: Engine / Drive Train 05-16-2018, 08:14 PM
Replies: 11
Views: 225
Posted By waterlogged882
My take and approach. Look in the transmission...

My take and approach. Look in the transmission manual and study the parts list and assembly diagram. Best I recall there is an o-ring in there. Look at the parts diagram for certainty.

Secondly,...
Forum: Engine / Drive Train 05-16-2018, 05:49 PM
Replies: 9
Views: 234
Posted By waterlogged882
Just take it apart as logic dictates; risers,...

Just take it apart as logic dictates; risers, then exhaust hose (from the riser), plug wires (mark them for each cylinder), exhaust manifold, then the head. Same going back. There is a sequence...
Forum: Restorations and Refurbishments 05-15-2018, 06:43 PM
Replies: 5
Views: 163
Posted By waterlogged882
Several threads here on the forum for this issue....

Several threads here on the forum for this issue.

Any of the common marine suppliers will have them.
Forum: Engine / Drive Train 05-15-2018, 06:09 PM
Replies: 9
Views: 234
Posted By waterlogged882
Head gaskets are straight forward. ..... Buy a...

Head gaskets are straight forward. .....

Buy a gasket kit from Discount Inboard Marine, Summit Racing, etc., gather the torque specs, get a torque wrench and sockets, remove the risers, exhaust...
Forum: General Discussion 05-15-2018, 05:09 PM
Replies: 5
Views: 225
Posted By waterlogged882
For the most part, yes.. I will say this: when...

For the most part, yes..

I will say this: when you go to lift and set the carb onto the spacer (two gaskets are required), do not wait until last and try to force the metal fuel line under the...
Forum: Restorations and Refurbishments 05-14-2018, 09:20 PM
Replies: 6
Views: 183
Posted By waterlogged882
Thank you

Thank you
Forum: Electrical 05-13-2018, 08:25 PM
Replies: 16
Views: 400
Posted By waterlogged882
A photograph of your starter would help to be...

A photograph of your starter would help to be sure.
Forum: Trailers 05-13-2018, 02:51 PM
Replies: 2
Views: 99
Posted By waterlogged882
The deeper the trailer goes, the higher the rear...

The deeper the trailer goes, the higher the rear of the boat raises, the lower the bow ring goes, thus pulling it across the v-bunk. You'll sooner than later tear the bunk apart. The bow eye should...
Forum: General Discussion 05-13-2018, 01:17 PM
Replies: 20
Views: 963
Posted By waterlogged882
Does the wife back out of the throttle to make...

Does the wife back out of the throttle to make the turn to come back into the slalom course?

I'd also consider re-calibrating the RPM to the speed settings that you use (in slalom mode). Also add...
Forum: Restorations and Refurbishments 05-13-2018, 09:34 AM
Replies: 110
Views: 18,127
Posted By waterlogged882
There is no color code in the HIN.

There is no color code in the HIN.
Forum: Engine / Drive Train 05-10-2018, 04:31 PM
Replies: 4
Views: 176
Posted By waterlogged882
Several good threads on this topic already posted...

Several good threads on this topic already posted across the last few years.
Search and read will help a lot.
.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 01:12 AM.


2018