Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: curver900
Forum: General Discussion Yesterday, 04:31 PM
Replies: 43
Views: 1,065
Posted By curver900
oh I have to go look for this warning label mine...

oh I have to go look for this warning label mine must be missing!
Forum: Engine / Drive Train Yesterday, 04:07 PM
Replies: 30
Views: 381
Posted By curver900
mmmmm Margarita... one of my favorites... those...

mmmmm Margarita... one of my favorites... those new ritas they have in a little 8oz can are my wifes new fav.. I am sure they cost way more than they are worth.. but she likes them...

Garage bad...
Forum: Electrical Yesterday, 03:59 PM
Replies: 7
Views: 131
Posted By curver900
move to Canada or Europe... then it will work...

move to Canada or Europe... then it will work right.. :D:D:D:D:D:D:rolleyes:
Forum: General Discussion Yesterday, 03:56 PM
Replies: 43
Views: 1,065
Posted By curver900
when that tub dives into the water I can feel the...

when that tub dives into the water I can feel the boat slow like it has an anchor on it... if it was on the tower I would be worried either of stressing it, spider cracks or worst a failure of the...
Forum: General Discussion Yesterday, 03:51 PM
Replies: 64
Views: 3,885
Posted By curver900
Agreed... Stupid batteries.... :mad:

Agreed... Stupid batteries.... :mad:
Forum: General Discussion Yesterday, 03:36 PM
Replies: 5
Views: 215
Posted By curver900
I say the Sammy for $11... with allot of elbow...

I say the Sammy for $11...

with allot of elbow grease buffer and such you can make it look good

wait till after august 1st then start at $10k.. there isn't much interest after Aug starts...
Forum: Engine / Drive Train Yesterday, 03:32 PM
Replies: 30
Views: 381
Posted By curver900
you can re-use them but I would get a new set...

you can re-use them but I would get a new set after you are all done those don't last forever... make sure you leave your blower on all the time

The bolts that hold the pump into the tank have...
Forum: General Discussion Yesterday, 12:13 PM
Replies: 64
Views: 3,885
Posted By curver900
a 1" open pipe under pressure of say 0 to 5 psi...

a 1" open pipe under pressure of say 0 to 5 psi would be right around 960 to 1200 GPH... a couple of 750GPH pumps should keep up... but one would not... a valiant effort though... :mad:
Forum: Electrical Yesterday, 12:01 PM
Replies: 7
Views: 139
Posted By curver900
so fuel, oil pressure, speedometer pegged Temp...

so fuel, oil pressure, speedometer pegged

Temp no movement

they all move when you move the ignition to run before you start it...

1 battery set up or 2 ?

What is the voltage at the battery?
What...
Forum: Off Topic Discussion Yesterday, 11:31 AM
Replies: 2,234
Views: 338,714
Posted By curver900
now that was funny thanks!!!!

now that was funny thanks!!!!
Forum: Engine / Drive Train Yesterday, 11:18 AM
Replies: 15
Views: 229
Posted By curver900
this plug should be right on top a 2 prong plug...

this plug should be right on top a 2 prong plug if I recall..
Forum: Electrical Yesterday, 11:15 AM
Replies: 7
Views: 139
Posted By curver900
Questions... did they work before you bought it?...

Questions... did they work before you bought it?

Did you do anything after you bought it?
Forum: Electrical Yesterday, 10:28 AM
Replies: 7
Views: 139
Posted By curver900
don't buy a new MDC... my .02 Look up how to...

don't buy a new MDC... my .02 Look up how to replace the gauges without it ...
Forum: General Discussion Yesterday, 10:25 AM
Replies: 64
Views: 3,885
Posted By curver900
wow... a total loss...that is very sad... Leaving...

wow... a total loss...that is very sad... Leaving it in the water did he have the bilge pump on? probably wouldn't have run forever I suppose... :(:(:(:o
Forum: General Discussion Yesterday, 10:14 AM
Replies: 18
Views: 523
Posted By curver900
I have ordered many parts from SKIDIM and never...

I have ordered many parts from SKIDIM and never had an issue.. I even ordered a strut as you did and had to do some minor modifications to make it fit.. it is a cast part...

BUT the customer is...
Forum: Trailers Yesterday, 10:05 AM
Replies: 4
Views: 178
Posted By curver900
update... I used a chisel and a hammer.. medium...

update...

I used a chisel and a hammer.. medium tapping and the wear rings just come off didn't even have to split them...

I do not have an o-ring channel in the spindle.. the video shows a...
Forum: Engine / Drive Train Yesterday, 09:55 AM
Replies: 30
Views: 381
Posted By curver900
Did you get new rubber seals for the pump and the...

Did you get new rubber seals for the pump and the bolts too???
Forum: Engine / Drive Train Yesterday, 09:53 AM
Replies: 30
Views: 381
Posted By curver900
I wish i could help but if i recall (boat at lake...

I wish i could help but if i recall (boat at lake on lift) I could get right to mine from underneath.. You probably have to take part of the dash apart maybe someone here can enlighten...

Sounds...
Forum: General Discussion Yesterday, 09:46 AM
Replies: 20
Views: 780
Posted By curver900
well those are all of what 2 years old now...so...

well those are all of what 2 years old now...so start watching for a used one to come up.. heck they are practically new and you can see what issues they have been having.. (I haven't heard much) but...
Forum: General Discussion 07-21-2016, 03:43 PM
Replies: 20
Views: 780
Posted By curver900
what are you looking for? what do you want out...

what are you looking for? what do you want out of it? wakeboard? surf? skiing, combination? what percentage? New boats from what I read are anywhere from 20-30% off of MSRP... but depends on your...
Forum: For Sale: Boats 07-21-2016, 03:31 PM
Replies: 3
Views: 215
Posted By curver900
even checked the CL add is it free????

even checked the CL add is it free????
Forum: Towers 07-21-2016, 03:15 PM
Replies: 2
Views: 173
Posted By curver900
put anti seize on the bolts....

put anti seize on the bolts....
Forum: Engine / Drive Train 07-21-2016, 03:02 PM
Replies: 30
Views: 381
Posted By curver900
There may be 4 connections but only those 2 wires...

There may be 4 connections but only those 2 wires matter... mine are purple... I just twisted them together with a wire cap after the connector on the switch side then when i replaced the switch i...
Forum: Wanted to Buy 07-20-2016, 12:39 PM
Replies: 5
Views: 643
Posted By curver900
be prepared to drive if you have a specific model...

be prepared to drive if you have a specific model in mind.. nothing wrong with driving...
Forum: What is this boat worth? 07-20-2016, 12:37 PM
Replies: 7
Views: 342
Posted By curver900
depends on time of year too.. but I would think...

depends on time of year too.. but I would think somewhere in the $27-33k range... motor pics would help along with trailer pics....
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 07:38 AM.