Go Back   TeamTalk > Search Forums

Showing results 1 to 21 of 21
Search took 0.00 seconds.
Search: Posts Made By: brettpro
Forum: Engine / Drive Train 12-24-2011, 11:41 AM
Replies: 16
Views: 2,641
Posted By brettpro
Turns out, once the allen key loosened up, the...

Turns out, once the allen key loosened up, the rest was pretty straight forward. Used needle nose pliers to grab the tab that says "ATF" and it popped right off. Then the rubber gasket popped out...
Forum: Engine / Drive Train 12-24-2011, 10:01 AM
Replies: 16
Views: 2,641
Posted By brettpro
Thanking you! I'm getting after it today and...

Thanking you! I'm getting after it today and hopefully not cause too much damage.
Forum: Engine / Drive Train 12-23-2011, 08:00 PM
Replies: 16
Views: 2,641
Posted By brettpro
Mtajpa (or anyone who is more mechanically...

Mtajpa (or anyone who is more mechanically inclined than I am)- thanks for the pics!! I've been struggling for years with the same problem that wakescene has had. I've always sucked it out and...
Forum: Appearance 11-25-2007, 08:09 PM
Replies: 3
Views: 389
Posted By brettpro
JohnnyB, It looks like the previous owner had...

JohnnyB,
It looks like the previous owner had taken the seat out and then tried to screw it back into the same holes...The screws must not have taken b/c there are a few other holes that look like...
Forum: Appearance 11-25-2007, 03:15 PM
Replies: 3
Views: 389
Posted By brettpro
Front seat fix??

Ok, here are some pics of the bottom of the driver's seat - the screws are coming out and seem to be stripped out. Can I just drill some new holes into the fiberglass?? Is there anything I need to...
Forum: General Discussion 11-01-2007, 08:48 PM
Replies: 24
Views: 1,584
Posted By brettpro
JimN, Thanks for the words. I've had the boat...

JimN,
Thanks for the words. I've had the boat for a couple of seasons now and it has been / run great. Just want to get an idea of the actual hours on it.

Not selling it...too much fun!!
Forum: General Discussion 10-31-2007, 09:10 PM
Replies: 24
Views: 1,584
Posted By brettpro
JimN, I have a 98 LT-1 as well - where is the ECM...

JimN,
I have a 98 LT-1 as well - where is the ECM located on the motor so I can have someone with a diagnostic computer with a Marine card plug in to give me some clue on the true hours. Any gotchas...
Forum: General Discussion 09-18-2007, 09:20 PM
Replies: 4
Views: 1,161
Posted By brettpro
MSanantonio, Bought some of that non-stick tape...

MSanantonio,
Bought some of that non-stick tape off of ebay - cost 30 bucks for two rolls of it. Then used the the old MC cut-out from the fender and a razor blade to trace it on the new non-stick...
Forum: General Discussion 08-17-2007, 10:08 PM
Replies: 4
Views: 642
Posted By brettpro
Look underneath the tongue of the trailer. I...

Look underneath the tongue of the trailer. I have a 98 200 VRS and that is where I found mine. I´ve also heard that they are sometimes stamped on the bottom of the axle.
Brett
Forum: General / Other 07-10-2007, 05:34 PM
Replies: 0
Views: 262
Posted By brettpro
Can't get Water Pump off!! Secret to loosen it??

Raw Water Pump is leaking and I'm going to replace it even though it may just be the seal....just can't seem to get any of the three screws that hold it on the motor to budge. When I do put some...
Forum: General Discussion 06-25-2007, 09:45 AM
Replies: 13
Views: 1,451
Posted By brettpro
Zen, Just had a NDT put on my Maristar about 2...

Zen,
Just had a NDT put on my Maristar about 2 weeks ago - it looks GREAT and so far I'm very happy with it. As for the cover, I still use my old cover for the boat and it slides down between the...
Forum: Appearance 05-14-2007, 06:04 PM
Replies: 12
Views: 1,340
Posted By brettpro
Here are a few more pics of other scratches on...

Here are a few more pics of other scratches on the hull - they are very light and did not break through the gelcoat however the whiteness of them obviously shows some damage. Are you guys saying...
Forum: Appearance 05-13-2007, 09:41 PM
Replies: 12
Views: 1,340
Posted By brettpro
just ordered a patch kit from Spectrum - IŽll try...

just ordered a patch kit from Spectrum - IŽll try to take some pics of the process later in the week and my fingers are crossed about the color match. We'll see how it goes b/c there are a lot of...
Forum: Appearance 05-09-2007, 06:27 PM
Replies: 12
Views: 1,340
Posted By brettpro
Gelcoat Ding..What to do?

Had the boat out the other day and my buddy dinged the gelcoat with a ski just below the rubrail. The pictures didn't come out too well but it is about 1 inch long and about 1/2 inch high - It...
Forum: General Discussion 05-04-2007, 11:15 AM
Replies: 8
Views: 844
Posted By brettpro
Got it - THANKS - tried to PM you but apparently...

Got it - THANKS - tried to PM you but apparently your inbox is full.
Forum: General Discussion 05-04-2007, 10:58 AM
Replies: 8
Views: 844
Posted By brettpro
Diesel, Re: Just pull out the heater core and...

Diesel,

Re: Just pull out the heater core and put a splice between the hoses until you can get another core. Or just undo both hoses on the engine and take a 1' piece of heater hose an connect the...
Forum: General Discussion 05-03-2007, 09:08 PM
Replies: 8
Views: 844
Posted By brettpro
VTbuehler, The hot water (red faucet) is turned...

VTbuehler,
The hot water (red faucet) is turned off / closed completely - if the water is still water getting through that valve, is there another way to completely block off the feed hose?
Forum: General Discussion 05-03-2007, 08:25 PM
Replies: 8
Views: 844
Posted By brettpro
Heater hose leaking??

Ok, still working this leak (see pic) that develops under the steering wheel - attached additional pic that shows red faucet that has been twisted closed. My heater has two hoses that lead into it. ...
Forum: General Discussion 05-01-2007, 10:20 PM
Replies: 21
Views: 1,392
Posted By brettpro
Yep...got it as well...who the!!!

Yep...got it as well...who the!!!
Forum: General Discussion 05-01-2007, 10:12 PM
Replies: 6
Views: 791
Posted By brettpro
Todd - do you have a pic that you can post so I...

Todd - do you have a pic that you can post so I can see how / where you installed the in-line valve? I'll remove the panel tomorrow and see what it looks like under there...we'll see how it...
Forum: General Discussion 05-01-2007, 09:50 PM
Replies: 6
Views: 791
Posted By brettpro
Leak under steering wheel

First time posting although I've been reading up for almost a year now and trying to learn - Hopefully the pics will show up.

98 Maristar 200 VRS, LT-1 motor

Since I bought the boat, every time I...
Showing results 1 to 21 of 21

 

All times are GMT -4. The time now is 10:33 AM.