Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: mgs96ps
Forum: For Sale: Watersports Equipment Yesterday, 10:25 AM
Replies: 1
Views: 132
Posted By mgs96ps
size of boots and length of ski?

size of boots and length of ski?
Forum: General / Other 05-19-2015, 10:27 AM
Replies: 5,681
Views: 546,526
Posted By mgs96ps
I believe that is a spacer to put cam shaft seal...

I believe that is a spacer to put cam shaft seal over spine gear directly behind main water pump. There is a double lipped seal on end of the cam shaft on an LT-1.

Just a...
Forum: Engine / Drive Train 05-19-2015, 10:21 AM
Replies: 7
Views: 232
Posted By mgs96ps
Weather it's torqued to spec, or...

Weather it's torqued to spec, or cross-threaded....tight is tight.
Forum: Engine / Drive Train 05-19-2015, 07:57 AM
Replies: 7
Views: 232
Posted By mgs96ps
Clever idea! I guess you just need to remember to...

Clever idea! I guess you just need to remember to keep plug short to leave enough clearance on top as bolt is threaded out.
Forum: Off Topic Discussion 05-18-2015, 09:26 PM
Replies: 6,103
Views: 884,880
Posted By mgs96ps
Hillsdale?

Hillsdale?
Forum: Off Topic Discussion 05-18-2015, 07:42 PM
Replies: 6,103
Views: 884,880
Posted By mgs96ps
I have. Must be the torque of the LT-1 spinning...

I have. Must be the torque of the LT-1 spinning it on.:D
Forum: Off Topic Discussion 05-15-2015, 05:32 PM
Replies: 6,103
Views: 884,880
Posted By mgs96ps
Planning on not suffering with another tight oil...

Planning on not suffering with another tight oil filter. I think that I am putting them on hand tight...but my boat seems to suck them on and will not let go. No more.
Forum: General / Other 05-11-2015, 02:33 PM
Replies: 5,681
Views: 546,526
Posted By mgs96ps
Thanks for compliment. I should have started a...

Thanks for compliment. I should have started a tread with the name "96 MasterCraft comes into the 21st Century". LOL
Forum: General / Other 05-11-2015, 09:58 AM
Replies: 5,681
Views: 546,526
Posted By mgs96ps
Installed an older DigitalPro Perfect Pass system...

Installed an older DigitalPro Perfect Pass system that I purchased from another member on TT. Did not install the paddle wheel as I plan on running in RPM mode only. Installed master module under...
Forum: Engine / Drive Train 05-05-2015, 11:43 PM
Replies: 8
Views: 247
Posted By mgs96ps
Circulating water pump would be my guess.

Circulating water pump would be my guess.
Forum: General Discussion 05-05-2015, 11:29 PM
Replies: 17
Views: 745
Posted By mgs96ps
What about maintenance and access? Is there added...

What about maintenance and access? Is there added level of difficulty over a traditional DD? Sorry for the thread jack....nice wheels!
Forum: General Discussion 05-05-2015, 11:07 PM
Replies: 17
Views: 745
Posted By mgs96ps
What do you think of that unique seating...

What do you think of that unique seating arrangement? I always thought that looked pretty cool and would function, but I have never ridden in one.
Forum: For Sale: Parts & Accessories 05-05-2015, 06:42 PM
Replies: 11
Views: 725
Posted By mgs96ps
http://www.ski-it-again.com/php/skiitagain.php?end...

http://www.ski-it-again.com/php/skiitagain.php?endless=summer&topic=Search&category=Speed_Ctrl&postid=32009

Found this on ski it again. Very similar to system I just bought here.
Forum: General Discussion 05-05-2015, 03:30 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
Touche'

Touche'
Forum: General Discussion 05-05-2015, 03:25 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
Another shot of tool.

Another shot of tool.
Forum: General Discussion 05-05-2015, 03:22 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
How about this type of tool slid into extractor...

How about this type of tool slid into extractor tube. Flare fingers in different areas or where you think you're stuck. Don't scratch your crank. Those fingers can be sharp.
Forum: General Discussion 05-05-2015, 02:40 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
Don't know if this is the best idea. Just a...

Don't know if this is the best idea. Just a thought. Could you pour a small amount something nasty down inter extractor tube to soften plastic and pull out once it dwells. Change oil after that. ...
Forum: Off Topic Discussion 05-05-2015, 02:29 PM
Replies: 36
Views: 2,020
Posted By mgs96ps
Good. After I wrote that I was thinking that you...

Good. After I wrote that I was thinking that you were going to say that you would just punch me instead....and that would have been a TKO by Sammy. Is was one of those replies I could not get back...
Forum: Off Topic Discussion 05-05-2015, 01:35 PM
Replies: 36
Views: 2,020
Posted By mgs96ps
what if it's a female...what then?

what if it's a female...what then?
Forum: For Sale: Parts & Accessories 05-05-2015, 10:22 AM
Replies: 6
Views: 295
Posted By mgs96ps
rpm cable 12v power cable servo motor on bracket...

rpm cable
12v power cable
servo motor on bracket with the right throttle cable (length) for your engine
power cable between servo and master module
and the paddle wheel...unless you are going to run...
Forum: General Discussion 05-03-2015, 03:08 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
so now team talk has a "broke my dipstick thread"...

so now team talk has a "broke my dipstick thread" and got "my extractor stuck thread".
Forum: General Discussion 05-03-2015, 03:06 PM
Replies: 85
Views: 3,257
Posted By mgs96ps
I would try a little compressed air as you pull

I would try a little compressed air as you pull
Forum: General Discussion 05-02-2015, 01:42 PM
Replies: 17
Views: 775
Posted By mgs96ps
Hey D. Can I come over to watch the fight?

Hey D. Can I come over to watch the fight?
Forum: For Sale: Parts & Accessories 05-01-2015, 12:36 AM
Replies: 11
Views: 725
Posted By mgs96ps
I was very lucky to pm skunny first on this very...

I was very lucky to pm skunny first on this very popular item. I have wanted PP for some time and would have been bummed to missed out on this. Anyways, for what it's worth...I hope more systems...
Forum: For Sale: Parts & Accessories 04-30-2015, 09:53 AM
Replies: 11
Views: 725
Posted By mgs96ps
interested....PM sent

interested....PM sent
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 09:13 AM.