TeamTalk > Search Forums Search Results

User Name Remember Me? Password

Page 1 of 5 1 2 3 > Last »

Showing results 1 to 25 of 113 Search took 0.11 seconds. Search: Posts Made By: MLA

Forum: Audio/Stereo 05-06-2013, 04:13 PM

Replies: 21 kicker tower speakers Views: 692 Posted By MLA Not a dumb question at all. All 4 components of... Not a dumb question at all. All 4 components of the KM6500.2 setup by themselves are 4 ohm nominal impedance. The traditional configuration is to pair a horn and mid together in parallel (+ to +/- to...

Forum: Audio/Stereo 05-04-2013, 08:26 PM

Replies: 6 Bazooka 8" Tower speakers Views: 247 Posted By MLA Bob, Yes, Bazooka did release a new pod and... Bob, Yes, Bazooka did release a new pod and clamp design this spring. I had the opportunity to see and handle them 1st hand at the CES show in Jan. The pods come as a single driver, and then can be...

Forum: Audio/Stereo 05-04-2013, 08:10 PM

Replies: 21 kicker tower speakers Views: 692 Posted By MLA Bsloop, I know who's desk that is, maybe i can... Bsloop, I know who's desk that is, maybe i can get him to chime in and answer your questions. If im not mistaken, that actual set in that pic ended up on a promo boat I did. I am well aware of the...

Forum: Audio/Stereo 05-01-2013, 03:18 PM

Replies: 6 Bazooka 8" Tower speakers Views: 247 Posted By MLA Ive never been a fan of wiring a small and large... Ive never been a fan of wiring a small and large or dissimilar speakers together on the same amp chnl. To get the most out of that setup, I would add a 2nd set of binding post and run them on a 4...

Forum: Audio/Stereo 05-01-2013, 03:08 PM

Replies: 21 kicker tower speakers Views: 692 Posted By MLA From Kicker's web site. From Kicker's web site.

Forum: Electrical 05-01-2013, 08:31 AM

Replies: 8 New battery cables: lugs or terminals at the battery? Views: 240 Posted By MLA Here I how i would approach it. What is the... Here I how i would approach it. What is the function of that solenoid and what is the potential current draw of that circuit. Using the chart posted by cantrepeat, you can determine the necessary...

Forum: Audio/Stereo 05-01-2013, 01:12 AM

Replies: 21 kicker tower speakers Views: 692 Posted By MLA Yes, but what are your goals? You get four 6.5"... Yes, but what are your goals? You get four 6.5" mid-bass drivers flanking 2 HLCD tweeters in two composit pods with universal aluminum clamps with sizing inserts.

Forum: Audio/Stereo 05-01-2013, 01:07 AM

Replies: 8 Tower speaker broken screws Views: 230 Posted By MLA If any of the threaded portion of the screw is... If any of the threaded portion of the screw is out past the pod, cut a slot in it and use a screw driver. You will probably want to soak the threads good ahead of time with some PB. The likely cause...

Forum: Engine / Drive Train 04-10-2013, 06:37 PM

Replies: 6 new crate motor tbi need help no fuel Views: 310 Posted By MLA Yes, that indicates secondary ignition. The lack... Yes, that indicates secondary ignition. The lack of pulse with the presence of B+ at the injector connector indicates that the ECM is not pulsing the injectors or theres an undone connector. Other...

Forum: Engine / Drive Train 04-10-2013, 07:51 AM

Replies: 6 new crate motor tbi need help no fuel Views: 310 Posted By MLA On those engines, the injectors are fed a... On those engines, the injectors are fed a switched B+ when keyed up. When the ECM senses ignition, as in the engine is spinning over and the ignition is pusling, the ecm with start to pulse the...

Forum: Electrical 04-04-2013, 09:10 PM

Replies: 3 Battery isolator help! Views: 431 Posted By MLA If the relay is a continuous-duty solenoid, then... If the relay is a continuous-duty solenoid, then yes, the contacts can burn/wear, resulting in a loss. I would take a volt meter to both sides and test the voltage and see. If the loss is through the...

Forum: Audio/Stereo 03-29-2013, 08:50 PM

Replies: 21 Amp Level Control Views: 427 Posted By MLA The Kicker ZXM-RLC is also a 9V line level. The... The Kicker ZXM-RLC is also a 9V line level. The ZXM will also work regardless of what amps are used as its controlling the source signal level. On some amps, the Bass level control is just that, bass...

Forum: Electrical 03-28-2013, 07:25 PM

Replies: 3 Dual Battery Wiring Views: 263 Posted By MLA It will only make a difference if you intend to... It will only make a difference if you intend to add an on-board charger. If the ACR is wired to the batteries or to the battery side of the switch, it will combine when the charger is in use. It...

Forum: Audio/Stereo 02-25-2013, 09:21 PM

Replies: 26 My new double sub box... Views: 1,366 Posted By MLA Zach, The amp only "sees" a load in the form of... Zach, The amp only "sees" a load in the form of impedance. This impedance can be changed by how we wire multiple subs or speaker, or how we wire DVC subs. In the case of the JL amp, its output is...

Forum: Audio/Stereo 02-22-2013, 08:21 PM

Replies: 5 2012+ X30 ZFT4 rack swivel Vs. Wetsounds Rev10s Views: 320 Posted By MLA last summer we did a pair of Rev-10's on a 2012... last summer we did a pair of Rev-10's on a 2012 X15 on the inside locations. The racks only interfered with the speakers if they where stored in the in position with boards in.

Forum: Audio/Stereo 02-18-2013, 07:11 PM

Replies: 13 Powering Rev10's? Views: 1,314 Posted By MLA Pap, The full-range Class-D Wet Sounds SD-2 will... Pap, The full-range Class-D Wet Sounds SD-2 will deliver 400W rms x 2 @ 4 ohm for a single pair of Rev-10 and 620W rms x 2 @ 2 ohm, so 310W net to each if you added a 2nd pair.

Forum: Audio/Stereo 02-17-2013, 10:08 AM

Replies: 20 MTX TM652WB-B tower speakers? Views: 947 Posted By MLA The cross-over on the horn can also be detached... The cross-over on the horn can also be detached and epoxied to the side, giving a little more clearance.

Forum: Audio/Stereo 02-17-2013, 03:44 AM

Replies: 20 MTX TM652WB-B tower speakers? Views: 947 Posted By MLA These are made just for them... These are made just for them http://kicker.com/KM_Empty_Enclosures The KMTE-D's (a pair of doubles) are the best value, but if your tower has a lot of arch to it, 2 pair the KMTE-S (a pair of...

Forum: Audio/Stereo 02-15-2013, 07:53 AM

Replies: 20 MTX TM652WB-B tower speakers? Views: 947 Posted By MLA Not much out there and that amp, but if I am... Not much out there and that amp, but if I am finding the right specs, then the 500a2 does 125W x 2 @ 4 and 250W x 2 @ 2. Power wise, this amp will be good, but can it be switched to Hi-Pass with...

Forum: Audio/Stereo 02-14-2013, 10:15 PM

Replies: 20 MTX TM652WB-B tower speakers? Views: 947 Posted By MLA Well, IMO, the Kicker KMT60 is a better choice,... Well, IMO, the Kicker KMT60 is a better choice, but is not ideal to be run bridged on an 4 chnl amp due to its below 4 ohm nominal impedance. Under load at higher volume levels, it can put a 4 chnl...

Forum: Electrical 02-13-2013, 01:58 PM

Replies: 7 92 prostar 205 Battery/Stereo Questions Views: 363 Posted By MLA 1) No, cable length doesnt matter, but their... 1) No, cable length doesnt matter, but their gauge will be determined by length and intended loads. 2) Yes it matters. ALL audio gear needs to share the same battery source. If you are going to just...

Forum: Audio/Stereo 02-13-2013, 07:50 AM

Replies: 12 Wetsounds Rev 10 mc adapters and swivel mounts Views: 818 Posted By MLA I ran into this on an 07 or 08 X80 when mounting... I ran into this on an 07 or 08 X80 when mounting to the outer spots. I had no trouble sourcing longer bolts at a local specialty fastener shop.

Forum: Audio/Stereo 02-08-2013, 07:16 PM

Replies: 12 Buzzing sound using aux Views: 331 Posted By MLA I would test the cable and Iphone on another unit... I would test the cable and Iphone on another unit to start. Then I would take a 3.5MM x RCA and go right to the back of the head-unit taking the remote AUX socket out of the loop. If still there,...

Forum: Audio/Stereo 02-02-2013, 10:11 AM

Replies: 3 Wetsounds REv 10 and Rev 8 on X2 Views: 290 Posted By MLA The X mount Rev-8 is roughly 9.5 and the Rev-10... The X mount Rev-8 is roughly 9.5 and the Rev-10 is roughly 11.5 and the MC adapters adds an additional 1".

Forum: Audio/Stereo 02-02-2013, 07:26 AM

Replies: 20 MTX TM652WB-B tower speakers? Views: 947 Posted By MLA It sounds like the tower is 1st phase you want to... It sounds like the tower is 1st phase you want to tackle and is your primary focus overall. What are you looking to achieve with the tower setup, reaching a wake-boarder in tow, surf/party cove sound...

Showing results 1 to 25 of 113

Page 1 of 5 1 2 3 > Last »