Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.14 seconds.
Search: Posts Made By: bturner2
Forum: General Discussion Today, 10:47 AM
Replies: 36
Views: 2,149
Posted By bturner2
I am speechless with your choice but as others...

I am speechless with your choice but as others have stated it's yours to do with as you will. I wouldn't be expecting any added value when you go to sell and it may actually take away from any...
Forum: General Discussion Today, 09:02 AM
Replies: 9
Views: 177
Posted By bturner2
We used a stationary spade connector (male to...

We used a stationary spade connector (male to male) to connect the wires together. The look something like this one....

http://www.eagleday.com/stblco.html

Used this so we could convert back later...
Forum: Electrical Yesterday, 08:25 AM
Replies: 7
Views: 173
Posted By bturner2
Check to see if you have pitot tubes for the...

Check to see if you have pitot tubes for the speedos or paddlewheel sensor. If you have the tubes they run to the MDC and are know to go bad and inject water in the MDC which fries the MDC or if...
Forum: Underwater Running Gear Yesterday, 08:13 AM
Replies: 4
Views: 228
Posted By bturner2
If you didn't change anything else that boat...

If you didn't change anything else that boat needs to go back to the place that did the alignment. I haven't heard of that issue with any X10s. A few people talked about the older MariStar 200s...
Forum: General Discussion 07-26-2014, 09:00 AM
Replies: 5
Views: 299
Posted By bturner2
I would think adding ballast to the center or a...

I would think adding ballast to the center or a bow tank would have a similar effect to adding a center trim tab. The bow would go down lifting the stern and hopefully decreasing the terrible slalom...
Forum: MasterCraft In Your Area 07-26-2014, 08:49 AM
Replies: 9
Views: 420
Posted By bturner2
Well I've been out here since Thursday now and...

Well I've been out here since Thursday now and while Thursday was less than a foot wave yesterday and today have averaged about 2 - 3 footers coming in from the south east. That means it should be...
Forum: Trailers 07-26-2014, 08:40 AM
Replies: 10
Views: 373
Posted By bturner2
You're lucky on that one as the lock pin just...

You're lucky on that one as the lock pin just keeps the silver tongue from popping out of position (if I understand the part that is broken correctly). Either way if all you were doing was moving the...
Forum: Engine / Drive Train 07-26-2014, 08:34 AM
Replies: 8
Views: 269
Posted By bturner2
My 2003 X2 had the dripless shaft seal from the...

My 2003 X2 had the dripless shaft seal from the factory.
Forum: For Sale: Watersports Equipment 07-25-2014, 10:08 AM
Replies: 4
Views: 191
Posted By bturner2
I've sold and bought off ski-it-again. Best...

I've sold and bought off ski-it-again. Best prices on close outs I've found. AWS isn't too shabby either. I missed their end of season sale last year by a week or would have bought from them if for...
Forum: MasterCraft In Your Area 07-24-2014, 10:31 AM
Replies: 9
Views: 420
Posted By bturner2
Talking My in-laws have a place just south of Colchester...

My in-laws have a place just south of Colchester which is across from Put In Bay by about 23 miles on the Canadian side. I typically take my boat to Lake Erie once or twice a year and it's dicey as...
Forum: General Discussion 07-24-2014, 09:57 AM
Replies: 105
Views: 4,842
Posted By bturner2
They were the big thing back in the day when I...

They were the big thing back in the day when I was a kid. They rated right up there with MC and CC. Wonder why they fell out of popularity.

I think someone tried to make a comeback with them back in...
Forum: General Discussion 07-24-2014, 09:54 AM
Replies: 3
Views: 376
Posted By bturner2
Very good point on the ski racks. It was a good...

Very good point on the ski racks. It was a good idea ahead of its time. Too bad the build quality of the boat was so bad.
Forum: General Discussion 07-24-2014, 09:52 AM
Replies: 14
Views: 1,020
Posted By bturner2
I got a Masterline for Christmas this year with a...

I got a Masterline for Christmas this year with a custom handle and love it. Slalom lines have stretch built into them based on the material they're made from. Tournament ropes are typically thicker...
Forum: Underwater Running Gear 07-23-2014, 07:28 AM
Replies: 8
Views: 622
Posted By bturner2
How hard was it getting the old one out and how...

How hard was it getting the old one out and how did you do it? I heard it's pretty bad.

Pictures on the second procedure please!
Forum: Electrical 07-23-2014, 07:20 AM
Replies: 6
Views: 175
Posted By bturner2
There was a run of bad displays that would get...

There was a run of bad displays that would get moisture in them and blank out. Most of the time when they were left in the sun for a while they would dry out then come back on, sometimes not. Yours...
Forum: Off Topic Discussion 07-17-2014, 07:00 AM
Replies: 18
Views: 641
Posted By bturner2
What is it with contractors in Canada? My mother...

What is it with contractors in Canada? My mother in law has a place outside Windsor on Lake Erie and its almost impossible to get anyone out to do any kind of contracting work. Most won't even return...
Forum: Electrical 07-16-2014, 05:29 PM
Replies: 6
Views: 271
Posted By bturner2
It's in the base settings section of the owners...

It's in the base settings section of the owners manual.
Forum: General Discussion 07-16-2014, 05:28 PM
Replies: 16
Views: 901
Posted By bturner2
I started carrying a spare fuel pump for these...

I started carrying a spare fuel pump for these very reasons. Boats seem to like to break just before a trip. Glad to see you made it back in one piece.
Forum: General Discussion 07-16-2014, 05:20 PM
Replies: 16
Views: 1,362
Posted By bturner2
Due to the locations and colors I was thinking...

Due to the locations and colors I was thinking 1000 - 1200. I'm sue the metal flake isn't doing you any favors. Pretty much three separate repairs and color matching.
Forum: General / Other 07-14-2014, 04:01 PM
Replies: 2
Views: 177
Posted By bturner2
Unless you have StarGazer, PP speed comes from...

Unless you have StarGazer, PP speed comes from the paddlewheel sensor located in the hull of the boat. Typically your speedo is getting it's signal from this same sensor. If so the two should not be...
Forum: Off Topic Discussion 07-14-2014, 10:56 AM
Replies: 10
Views: 405
Posted By bturner2
I've found that for newer riders bigger is better...

I've found that for newer riders bigger is better and if your ever on the edge go bigger. Typically bigger is more forgiving.
Forum: Ballast 07-14-2014, 07:38 AM
Replies: 23
Views: 568
Posted By bturner2
Both of my rear pumps were mounted upside down...

Both of my rear pumps were mounted upside down and both failed. Flipped them over about 3 years ago and they've been trouble free since.
Forum: Engine / Drive Train 07-14-2014, 07:33 AM
Replies: 1
Views: 191
Posted By bturner2
It's typically best to replace with what you...

It's typically best to replace with what you currently have. You may want to look at a place like Michigan Motorz and get something that was designed for marine use. Unless of course the engine you...
Forum: Trailers 07-10-2014, 03:41 PM
Replies: 8
Views: 303
Posted By bturner2
Dang Jeff I feel bad about my response after...

Dang Jeff I feel bad about my response after seeing that picture in yours. Very nice explanation and graphic on the connector!
Forum: General Discussion 07-10-2014, 03:32 PM
Replies: 49
Views: 2,703
Posted By bturner2
The quality of the ramp helps a lot and as most...

The quality of the ramp helps a lot and as most suggest a slow approach is the best. I put the trailer in with the fenders just below the water. On my boat this gets the bunks completely wet and will...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 08:37 PM.