Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 369
Search took 0.04 seconds.
Search: Posts Made By: ProStar Slalom
Forum: Off Topic Discussion 07-02-2015, 03:14 PM
Replies: 17
Views: 445
Posted By ProStar Slalom
When I put ours in I ran a 4th wire in the...

When I put ours in I ran a 4th wire in the conduit from the house down to the panel at the shoreline. Don't need 220 now, but if we ever do (to pump lake water, etc.) it will be an easy upgrade.
Forum: Electrical 07-01-2015, 04:59 PM
Replies: 1
Views: 114
Posted By ProStar Slalom
I haven't seen it before. Great find; thanks for...

I haven't seen it before. Great find; thanks for posting!
Forum: Engine / Drive Train 06-26-2015, 04:51 PM
Replies: 13
Views: 324
Posted By ProStar Slalom
www.skidim.com. Not sure on part number, but...

www.skidim.com. Not sure on part number, but should be obvious which one is right for you.
Forum: MasterCraft In Your Area 06-08-2015, 01:25 PM
Replies: 6
Views: 256
Posted By ProStar Slalom
If you're planning to run all over the lake, just...

If you're planning to run all over the lake, just pay attention to the channel markers. There are some shallow spots here and there that are not obvious at first. If in doubt, do what most of the...
Forum: Engine / Drive Train 06-04-2015, 04:56 PM
Replies: 53
Views: 5,193
Posted By ProStar Slalom
I don't know anyone, but can't believe it would...

I don't know anyone, but can't believe it would be anything significantly different. The wiring colors will be the same, and you're essentially just removing the MDC from the equation. I followed...
Forum: General Discussion 05-17-2015, 04:18 PM
Replies: 6
Views: 304
Posted By ProStar Slalom
If you're talking about the switch on the...

If you're talking about the switch on the transmission, check with Ski DIM, skidim.com. If you're talking about the button near the throttle, not sure. I'd still recommend Ski DIM as a start point.
Forum: Electrical 05-14-2015, 06:28 AM
Replies: 3
Views: 234
Posted By ProStar Slalom
Is yours a 3-wire with a connecting plug, or each...

Is yours a 3-wire with a connecting plug, or each wire attached directly to the sender?

I've got a 3-wire with connecting plug; 10 inch I think, for 11" or 12" tank
Forum: For Sale: Parts & Accessories 05-13-2015, 06:23 AM
Replies: 26
Views: 1,710
Posted By ProStar Slalom
This one will work out fine! :)

This one will work out fine! :)
Forum: For Sale: Parts & Accessories 05-06-2015, 08:12 AM
Replies: 26
Views: 1,710
Posted By ProStar Slalom
I do. Do you need one? I'd like to help out...

I do. Do you need one? I'd like to help out someone in need versus someone collecting parts or working re-sale.
Forum: For Sale: Parts & Accessories 05-05-2015, 08:20 AM
Replies: 26
Views: 1,710
Posted By ProStar Slalom
I've got one for sale as well if anyone needs...

I've got one for sale as well if anyone needs one. Should be plenty of demand this time of year. Mine works fine and never had pitot tubing attached, so no chance for water intrusion.
Forum: Electrical 04-16-2015, 07:40 PM
Replies: 7
Views: 459
Posted By ProStar Slalom
I'd recommend that you first try to determine...

I'd recommend that you first try to determine whether the gauges are going bad, or the MDC. If it's just the MDC, then that's an easy swap and you're back in business. If the gauges are bad, they...
Forum: Electrical 04-15-2015, 08:17 PM
Replies: 7
Views: 459
Posted By ProStar Slalom
If you have Medallion gauges (can't remember when...

If you have Medallion gauges (can't remember when MasterCraft started using them), sure sounds like a bad MDC. Possibly damaged by freeze over winter. Do a search on here, plenty of information.
Forum: Underwater Running Gear 04-07-2015, 08:29 PM
Replies: 3
Views: 421
Posted By ProStar Slalom
Our '84 has a lot of play as well (over 1300...

Our '84 has a lot of play as well (over 1300 hrs). I took it apart and didn't see an easy fix...mostly wear on the actual rudder shaft if I remember right. I just keep it well greased. Doesn't...
Forum: Electrical 03-26-2015, 08:28 PM
Replies: 6
Views: 633
Posted By ProStar Slalom
I've got one. PM sent.

I've got one. PM sent.
Forum: General Discussion 02-25-2015, 07:46 PM
Replies: 32
Views: 2,282
Posted By ProStar Slalom
Bastogne!

Bastogne!
Forum: General / Other 02-15-2015, 06:18 PM
Replies: 12
Views: 974
Posted By ProStar Slalom
Here's a picture of a new cable. I guess it does...

Here's a picture of a new cable. I guess it does slide through the tube; I can't remember. What I do remember is that when I bought the boat from PO the steering was terrible. I put in a new cable...
Forum: Electrical 02-13-2015, 06:41 PM
Replies: 27
Views: 4,318
Posted By ProStar Slalom
Follow-up. I thought I was good to go with OE...

Follow-up. I thought I was good to go with OE 3-wire, but not so much. I was getting a signal to the gauge but only a small needle movement. Not sure why it wouldn't work since it's supposed to...
Forum: Engine / Drive Train 02-10-2015, 08:56 PM
Replies: 5
Views: 654
Posted By ProStar Slalom
I'm not the original owner, but I don't think it...

I'm not the original owner, but I don't think it was ever messed with. You have to remove the rear seat back to even get to it. Not sure why there's a second filter, but I don't think the original...
Forum: General / Other 02-08-2015, 07:36 AM
Replies: 12
Views: 974
Posted By ProStar Slalom
If I recall correctly, that "support tube" will...

If I recall correctly, that "support tube" will come with the new cable...it's all one piece. You'll be good to go with a new cable. Attach some rope or string to the old cable as you pull it up to...
Forum: Electrical 02-02-2015, 08:17 PM
Replies: 27
Views: 4,318
Posted By ProStar Slalom
I found an OE 3-wire on Ebay. Didn't want to...

I found an OE 3-wire on Ebay. Didn't want to mess with changing the wiring back there. Not many of these left; next one will be mechanical I'm sure.
Forum: Engine / Drive Train 02-01-2015, 09:34 PM
Replies: 5
Views: 654
Posted By ProStar Slalom
Thanks, Jim; I'll give that a try. Yes, far more...

Thanks, Jim; I'll give that a try. Yes, far more complicated than the one between the fuel pump and the throttle body.
Forum: Electrical 02-01-2015, 08:01 PM
Replies: 27
Views: 4,318
Posted By ProStar Slalom
Jeff, my sender was bad as well. I assume the...

Jeff, my sender was bad as well. I assume the bad sender made for a bad signal to the fuel gauge...and for whatever reason was causing the voltage gauge to read bad as well. You can see on the...
Forum: Engine / Drive Train 02-01-2015, 07:49 PM
Replies: 5
Views: 654
Posted By ProStar Slalom
Remove in-line filter near tank?

2001 19Skier with 310 Predator. Boat has two fuel filters...one near fuel pump and another just outside the fuel tank. Probably a dumb question, but how do I remove the filter in the pictures...
Forum: Electrical 02-01-2015, 07:38 PM
Replies: 27
Views: 4,318
Posted By ProStar Slalom
We bought our '01 in 2007. In 2008 I had to...

We bought our '01 in 2007. In 2008 I had to replace the MDC box because I didn't know anything about "winterizing" it, and it was damaged by water from the speedo tubes. A couple of years later I...
Forum: General / Other 02-01-2015, 06:43 AM
Replies: 11
Views: 954
Posted By ProStar Slalom
Not sure about the best place to buy, but there...

Not sure about the best place to buy, but there are plenty out there and plenty of threads on here about biminis. I would recommend mounting it so that it will lie flat at the front edge of the...
Showing results 1 to 25 of 369

 

All times are GMT -4. The time now is 09:05 PM.