Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: onewheat
Forum: General Discussion 10-21-2014, 01:21 AM
Replies: 49
Views: 1,860
Posted By onewheat
Use a 2' length of 4" x 4" - it is a cheap and...

Use a 2' length of 4" x 4" - it is a cheap and very reliable jack for a tandem axle trailer. I always have one in the bed of my truck. Has worked like a charm on numerous occasions.
Forum: General Discussion 10-19-2014, 11:15 PM
Replies: 3
Views: 310
Posted By onewheat
That's why i only used half - tower goes down and...

That's why i only used half - tower goes down and cover goes on - up or down - piece of cake!
Forum: General Discussion 10-18-2014, 08:59 PM
Replies: 3
Views: 310
Posted By onewheat
I added them on the rear only of our '13 with the...

I added them on the rear only of our '13 with the ZFT-4. That adds half the length to it and the tower still folds when the racks are in. When the racks are out, I have no issues with the shock...
Forum: General Discussion 08-22-2014, 10:15 AM
Replies: 6
Views: 461
Posted By onewheat
What he said too - center tab I do adjust a bit...

What he said too - center tab I do adjust a bit depending on number of peeps and where they're sitting, fuel load, etc - also, I might bump speed up or down a couple of 0.1s depending on the day and...
Forum: Off Topic Discussion 08-19-2014, 11:59 PM
Replies: 12
Views: 978
Posted By onewheat
WBC Wipeout Video...

WBC Wipeout Video (https://www.youtube.com/watch?v=iCIO6Fe2rRE) This is one of the best videos I have watched in a long time. Entertaining for me - but I cringe for the people in it.
Forum: General Discussion 08-19-2014, 11:53 PM
Replies: 15
Views: 870
Posted By onewheat
One where you would find a typical GM engine...

One where you would find a typical GM engine thermostat - under the intake manifold in the front of the engine (rear of the boat for a V-drive) and the second in a housing before the circulation pump...
Forum: General Discussion 08-18-2014, 03:21 PM
Replies: 15
Views: 870
Posted By onewheat
Running hot again this past Saturday morning -...

Running hot again this past Saturday morning - found out there is a second thermostat in this engine. Took that housing off the block and found two more pieces of impeller stuck in that thermostat -...
Forum: General Discussion 08-11-2014, 11:29 AM
Replies: 15
Views: 870
Posted By onewheat
Is that what caused the exhaust to self-destruct?

Is that what caused the exhaust to self-destruct?
Forum: General Discussion 08-11-2014, 12:57 AM
Replies: 15
Views: 870
Posted By onewheat
There is a check valve on the small line that...

There is a check valve on the small line that comes out of the impeller housing - I found 3 chunks of impeller in that check valve today. I didn't get a chance to run it afterwards because it was...
Forum: General Discussion 08-07-2014, 03:18 PM
Replies: 15
Views: 870
Posted By onewheat
Too busy with other things - buying a house,...

Too busy with other things - buying a house, selling a house, building a house and trying to maintain a house (and a boat). Houses are all 2 - 3.5 hours apart from each other - 10,000 miles on my 3...
Forum: General Discussion 08-07-2014, 02:55 PM
Replies: 15
Views: 870
Posted By onewheat
I changed the impeller right after getting back...

I changed the impeller right after getting back with the cracked lid - actually bypassed the strainer in the middle of the lake to get water moving and got back to the dock and changed the impeller -...
Forum: General Discussion 08-07-2014, 01:23 AM
Replies: 15
Views: 870
Posted By onewheat
Question Impeller vane stuck

I lost an impeller vane on my 6.2 after a cracked strainer lid caused an ail leak and lack of suction. I am running a touch hot above wakeboard speeds and if running 4000 rpm's will top 200 degrees,...
Forum: General Discussion 07-23-2014, 10:15 PM
Replies: 13
Views: 723
Posted By onewheat
I believe the tower is clear anodized - it won't...

I believe the tower is clear anodized - it won't polish like bare aluminum will (if that is the case). If it is anodized and a portion of the coating is worn off - then Mother's will wprk well on...
Forum: General Discussion 07-21-2014, 01:51 AM
Replies: 109
Views: 4,211
Posted By onewheat
There is such a big difference between a HOA that...

There is such a big difference between a HOA that gives you square footage requirements and some guidelines vs the ones that tell you what color flowers you can have and where you are allowed to put...
Forum: General / Other 07-15-2014, 12:15 AM
Replies: 26
Views: 1,225
Posted By onewheat
I'm pretty active on several forums - depending...

I'm pretty active on several forums - depending on the time of year - but I must say, this is BY FAR the best forum that I am a member of. Most of them seem to be populated by 17 - 21 year old males...
Forum: General Discussion 07-14-2014, 02:17 PM
Replies: 14
Views: 1,386
Posted By onewheat
It's still open for business - hurry back. You...

It's still open for business - hurry back. You know the water over there in the UK is barely above freezing at best and they measure it in C, so it even sounds colder than it already is.
Forum: General Discussion 07-14-2014, 12:07 PM
Replies: 14
Views: 1,386
Posted By onewheat
Yes - there are a lot of MC's in our cove - our...

Yes - there are a lot of MC's in our cove - our Fire on the Water group.
.
.
Forum: General Discussion 07-14-2014, 12:03 PM
Replies: 31
Views: 1,432
Posted By onewheat
Someone gave us a 3-person SeaDoo tube as a Lake...

Someone gave us a 3-person SeaDoo tube as a Lake House warming present - we used the hell out of it the last two years pulling around 3 guys from my son's frat house - easily 500+ pounds on it - I...
Forum: Off Topic Discussion 07-14-2014, 01:55 AM
Replies: 47
Views: 2,724
Posted By onewheat
We just did our basement - 10' poured walls...

We just did our basement - 10' poured walls except one end which is about 4' - 2950 sq ft - $47,000 for the basement - unfinished price, of course. The cost of the same footprint crawlspace was...
Forum: General Discussion 06-30-2014, 01:27 PM
Replies: 19
Views: 895
Posted By onewheat
I ALWAYS look over the windshield - I could paint...

I ALWAYS look over the windshield - I could paint my windows and it would never affect me. If you are going to tint - 20% or don't bother.
Forum: MasterCraft In Your Area 06-23-2014, 01:15 AM
Replies: 3
Views: 469
Posted By onewheat
I think that is up at the East end of the lake. ...

I think that is up at the East end of the lake. The water is about 8' or so low - it would totally depend on your particular cove and how shallow it normally is. We have a cove near us that is...
Forum: General Discussion 06-23-2014, 01:03 AM
Replies: 15
Views: 633
Posted By onewheat
Norris has skunky water and is full of snakes and...

Norris has skunky water and is full of snakes and stumps - the water is always choppy too. I'm just sayin'...
Forum: General Discussion 06-19-2014, 01:21 AM
Replies: 6
Views: 702
Posted By onewheat
Exactly!

Exactly!
Forum: For Sale: Watersports Equipment 06-16-2014, 04:48 PM
Replies: 11
Views: 1,105
Posted By onewheat
Boot size is on the outside of the boot cushion...

Boot size is on the outside of the boot cushion under the hard part of the boot near the top.
Forum: General Discussion 06-16-2014, 12:04 AM
Replies: 10
Views: 754
Posted By onewheat
I used 404 waterproofing on ours - it works very...

I used 404 waterproofing on ours - it works very well too. Used it every year as well.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 10:01 AM.