Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 69
Search took 0.01 seconds.
Search: Posts Made By: woodrowskis
Forum: Engine / Drive Train 05-15-2014, 06:10 PM
Replies: 74
Views: 3,523
Posted By woodrowskis
I read the entire deal but was interrupted a few...

I read the entire deal but was interrupted a few times so its difficult to remember it all.

(1) If you are getting voltage to the distributor but not to the plugs, I agree on the cap and rotor....
Forum: Appearance 05-15-2014, 12:28 PM
Replies: 24
Views: 1,817
Posted By woodrowskis
Older Decals: trying Cassandra at Universal Products

She answered but says I have to get the part numbers from Mastercraft and have permission from Mastercraft.

I am tying to email my dealer and I can't get email through to them to confirm part...
Forum: Engine / Drive Train 09-30-2013, 11:14 AM
Replies: 32
Views: 1,440
Posted By woodrowskis
I have that sound in my boat. I do have motor...

I have that sound in my boat. I do have motor oil instead of transmission fluid. I am not sure what I think is the problem. I am going to get the alignment checked this winter when I slow down...
Forum: Electrical 06-06-2013, 08:44 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
I looked at my picture on my old sending unit. It...

I looked at my picture on my old sending unit. It had screws and I did remember it saying empty and full. However, I pulled my panel to get access to the tank to adjust the new unit ( I was going to...
Forum: Electrical 06-05-2013, 09:42 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
I had no idea those were adjusting screws. Mine...

I had no idea those were adjusting screws. Mine has two hex head bolts which look structural. I'll give it a shot. thanks.
Forum: Electrical 06-05-2013, 09:33 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
Sounds reasonable but I live on a ski lake where...

Sounds reasonable but I live on a ski lake where we fill with 5 gallons cans. And I share the boat with a neighbor. So just filling is not a good option for me. Before I started sharing it wasn't a...
Forum: Electrical 06-05-2013, 09:24 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
I could not find after about 30 minutes so I went...

I could not find after about 30 minutes so I went to the dealer. About $110. yes, a little disappointing
Forum: Electrical 06-03-2013, 08:26 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
Testing the sending unit versus the gauge was...

Testing the sending unit versus the gauge was going to be a pain. I ordered a sending unit. It fixed the problem. I have not filled it or driven to empty to check accuracy. But looking at the amount...
Forum: Engine / Drive Train 05-31-2013, 05:58 PM
Replies: 58
Views: 8,679
Posted By woodrowskis
I never figured out my problem. My boat runs well...

I never figured out my problem. My boat runs well as far as skiing. I am on a slalom course and pulls great passes and times out correct consistently. But it still makes a nasty noise at times. It...
Forum: Upholstery 05-31-2013, 04:52 PM
Replies: 9
Views: 750
Posted By woodrowskis
If you do not get a wrench on the back of the...

If you do not get a wrench on the back of the upper screws you can tear the panel material behind them. You can see a few tech tips on how people have tried differrent ways to repair this. Definitely...
Forum: Electrical 05-29-2013, 09:39 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
it may not be perfect, that could cause the full...

it may not be perfect, that could cause the full too soon issue, but it always worked accurately from 3/4 down to empty before. thats all I really care about.
Forum: Electrical 05-29-2013, 02:24 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
I did find a test method but I do need the...

I did find a test method but I do need the correct electrical connector and apparently need some resistors to confirm the gauge . Anyone know if it is the same resistors for the 3 pin? I may can...
Forum: Electrical 05-29-2013, 01:52 AM
Replies: 17
Views: 2,220
Posted By woodrowskis
Fuel Gauge inacurrate

2002 Mastercraft 197:
I am about to search history again but did not find the advice I was looking for last time. Anyway fuel gauge reads wrong. It does read now. It used to say empty. Dealer...
Forum: Engine / Drive Train 09-15-2012, 10:48 PM
Replies: 2
Views: 915
Posted By woodrowskis
Ticking noise in exhaust 2010 X14v

Noise in exhaust. Can feel it in the left bank in the muffler and the flex hose. Did not hold the SS tubing to feel due to temperature. Has anyone had catalyst come loose or baffle loose in the...
Forum: Electrical 01-31-2012, 06:52 PM
Replies: 7
Views: 2,405
Posted By woodrowskis
should have asked 1st time, but how much do you...

should have asked 1st time, but how much do you want for it?
you said you had an extra.

Not trying to nickel and dime you.
Forum: Electrical 01-31-2012, 05:14 PM
Replies: 7
Views: 2,405
Posted By woodrowskis
sorry, what is MDC?

sorry, what is MDC?
Forum: Engine / Drive Train 01-13-2012, 01:17 PM
Replies: 4
Views: 551
Posted By woodrowskis
transmissions are rotation specific. especially...

transmissions are rotation specific. especially for driving the pump.
I have seen a thread in the past telling how to change the rotation on a transmission if you think you might be up to it. It...
Forum: Electrical 01-13-2012, 01:13 PM
Replies: 3
Views: 815
Posted By woodrowskis
2002 model 197. I have had low batteries that...

2002 model 197.
I have had low batteries that would not crank.
Alarm never went off then. Maybe it has to be high enough for alarm
Forum: Electrical 01-13-2012, 09:57 AM
Replies: 3
Views: 815
Posted By woodrowskis
warning alarm going off

It just started.

My alarm is buzzing even with engine off and with key in accessory postion (also goes off in the ignition power postion as well). I disconnected the perfect pass so it is the boat....
Forum: Upholstery 01-10-2012, 07:13 PM
Replies: 0
Views: 332
Posted By woodrowskis
throttle panel mounting holes tearing, 2002 197

2002 197
I know a few people who have had this problem. When trying to remove the panel at the throttle, you tear the material in the holes. I bought a new panel but want to try to do something to...
Forum: Electrical 01-10-2012, 07:04 PM
Replies: 7
Views: 2,405
Posted By woodrowskis
Dash gauges not working, 2002 197

Has there been any common problem causing gauge issues on boats in this age range?
Went about 1-1/2 years where a couple of the gauges did not work when powering up with the key. Often, I could turn...
Forum: General / Other 01-05-2012, 05:30 PM
Replies: 12
Views: 1,348
Posted By woodrowskis
I also have a 197 and need to change the cable. I...

I also have a 197 and need to change the cable. I have been told by my dealer I need to confirm which cable length since two different l.engths were used that year (2002).
I guess to me it seems...
Forum: General / Other 01-04-2012, 04:17 PM
Replies: 8
Views: 885
Posted By woodrowskis
hot water shower for closed cooling

did you figure anytrhing out?
I am currently contemplating two solutions. Neither as simple as I would like.

(1) an on demand water heater appx 1500 watt and a Dc to AC power inverter
(2) a...
Forum: General / Other 12-29-2011, 05:57 PM
Replies: 2
Views: 503
Posted By woodrowskis
When you say there is no constant hotwater, I am...

When you say there is no constant hotwater, I am not sure what you mean. Hot or at least warm water leaves the shell and tube. I think the exit is via a hose to the engine (possibly one to each side...
Forum: General / Other 12-22-2011, 12:06 AM
Replies: 2
Views: 503
Posted By woodrowskis
Hot water shower with closed cooling?

Has anyone installed hot water shower with closed cooling?
I have not had time to really look at the engine and think it through. But it seems hard to believe it can't be done. There are no kits...
Showing results 1 to 25 of 69

 

All times are GMT -4. The time now is 02:23 AM.