Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Jorski
Forum: General Discussion 07-21-2015, 01:59 PM
Replies: 151
Views: 4,834
Posted By Jorski
I'll take one

I'll take one
Forum: Engine / Drive Train 07-19-2015, 09:50 AM
Replies: 19
Views: 522
Posted By Jorski
Could be clogged injectors from sitting so long

Could be clogged injectors from sitting so long
Forum: Engine / Drive Train 07-03-2015, 06:58 PM
Replies: 25
Views: 980
Posted By Jorski
Winner Wimmer chicken dinner! BRET nailed...

Winner Wimmer chicken dinner!

BRET nailed it.....there was water in the tranny fluid. Changed the fluid and all is well!
Forum: Engine / Drive Train 06-30-2015, 11:28 AM
Replies: 25
Views: 980
Posted By Jorski
I appreciate all of the replies!!!! I didn't get...

I appreciate all of the replies!!!! I didn't get to spend much time on the boat this past weekend....it was raining hard almost the entire time.

I will check the trans fluid...and try it a little...
Forum: Engine / Drive Train 06-29-2015, 12:13 PM
Replies: 25
Views: 980
Posted By Jorski
I have a hard time imagining why the transmission...

I have a hard time imagining why the transmission would.slip when turning in one direction and not the other.
Forum: Engine / Drive Train 06-29-2015, 09:09 AM
Replies: 25
Views: 980
Posted By Jorski
Okay....replaced battery cables. I'm getting much...

Okay....replaced battery cables. I'm getting much more juice through the system. You can tell when starting or running the blower etc.

Boat is still cutting out on hard right turns. I am convinced...
Forum: Restorations and Refurbishments 06-24-2015, 03:47 PM
Replies: 6
Views: 1,469
Posted By Jorski
If there is a shadow where the old ones were...

If there is a shadow where the old ones were installed, why don't you just measure it?
Forum: Engine / Drive Train 06-23-2015, 04:31 PM
Replies: 25
Views: 980
Posted By Jorski
Not a carb.....LT1 efi Fuel pump wouldn't care...

Not a carb.....LT1 efi

Fuel pump wouldn't care which way I turned...but the wiring harness leading to it might.

I do think that it is electrical
Forum: Engine / Drive Train 06-23-2015, 02:42 PM
Replies: 25
Views: 980
Posted By Jorski
it's like there was a toggle switch and someone...

it's like there was a toggle switch and someone turned the key off for a second then back on....I don't think it's anything to do with the bottom or the prop....

I think fuel or electrical....
Forum: Engine / Drive Train 06-23-2015, 12:54 PM
Replies: 25
Views: 980
Posted By Jorski
Thanks! think you hit on something....I have a...

Thanks!

think you hit on something....I have a battery cable that has given me some trouble...I'm going to replace that to start.

Anyone know how long the cables are?
Forum: Engine / Drive Train 06-23-2015, 11:02 AM
Replies: 25
Views: 980
Posted By Jorski
Engine cuts in and out when I turn left

Okay, so 1993 Prostar 190 with LT1....

My engine is running great.
I can turn to the left as hard as I dare.

When I turn hard to the right the engine cuts in and out...

Sounds like a loose...
Forum: Appearance 06-18-2015, 09:13 AM
Replies: 4
Views: 484
Posted By Jorski
Have you tried to refurb the existing flake? If...

Have you tried to refurb the existing flake? If you are going to paint or gel it anyhow....you could be pretty aggressive.....I would try a spot

wet sand with 400, then 600 then 800 then 1000 then...
Forum: General Discussion 06-18-2015, 09:04 AM
Replies: 13
Views: 562
Posted By Jorski
Also....check screen on the inlet side of the...

Also....check screen on the inlet side of the fuel pump...you have to remove the fittings to get at it....they just unscrew.
Forum: General Discussion 06-18-2015, 08:58 AM
Replies: 34
Views: 2,206
Posted By Jorski
Lots of good advice...... the key thing is to...

Lots of good advice......

the key thing is to become comfortable with what your boat will do when you put it into reverse.

If you anticipate how the prop will "paddle wheel" the back end of your...
Forum: Upholstery 06-13-2015, 03:41 PM
Replies: 6
Views: 684
Posted By Jorski
You can use degreaser..... warning....dilute to...

You can use degreaser.....

warning....dilute to 50%....only go stronger as required. DO NOT LET IT SIT.....

This will work amazingly well...but this stuff is very strong.

Test on an out of the way...
Forum: Off Topic Discussion 06-11-2015, 10:05 PM
Replies: 65
Views: 3,578
Posted By Jorski
from the way back machine....welcome back!

from the way back machine....welcome back!
Forum: General Discussion 06-11-2015, 09:56 PM
Replies: 18
Views: 1,275
Posted By Jorski
search boathouses MUSKOKA ....Lots of ideas...

search boathouses MUSKOKA ....Lots of ideas there....some of the best boathouse in the world...will give you some ideas
Forum: General Discussion 06-09-2015, 04:17 PM
Replies: 50
Views: 4,487
Posted By Jorski
Any updates Greg?

Any updates Greg?
Forum: Engine / Drive Train 05-23-2015, 08:49 AM
Replies: 36
Views: 1,590
Posted By Jorski
Watch this...good video on...

Watch this...good video on alignment

https://youtu.be/3_w0LvD6gEc
Forum: General Discussion 05-03-2015, 12:54 PM
Replies: 50
Views: 4,487
Posted By Jorski
Greg, that J is looking awesome!!!!! Can't wait...

Greg, that J is looking awesome!!!!! Can't wait to see it with the graphics applied!


Also..don't know if you have seen this site...they sell reproduction decals for outboard...
Forum: General Discussion 05-01-2015, 09:47 PM
Replies: 17
Views: 948
Posted By Jorski
No Knockout it goes 12 rounds Mayweather...not a...

No Knockout
it goes 12 rounds
Mayweather...not a close decision either

It will be boring....Paquiao won't touch him.

@501s...they are not splitting 200 million....that's Mayweather's take on a...
Forum: Appearance 04-30-2015, 08:51 AM
Replies: 18
Views: 1,488
Posted By Jorski
throw in an extra gauge?

throw in an extra gauge?
Forum: General Discussion 04-28-2015, 09:19 PM
Replies: 50
Views: 4,487
Posted By Jorski
There was a thread all about J Crafts and their...

There was a thread all about J Crafts and their history on Scream and Fly a few years ago...in fact as recently as a couple of years a guy named John Spaeth had the molds and was building a dozen per...
Forum: General Discussion 04-28-2015, 01:37 PM
Replies: 12
Views: 751
Posted By Jorski
That boat in great shape is worth...

That boat in great shape is worth $10,000-$11,000...depending upon hours.

So....given the high maintenance storage and the quality of the "cover" I would count on:
Boat:
1) a new interior...vinyl...
Forum: General Discussion 04-28-2015, 01:17 PM
Replies: 50
Views: 4,487
Posted By Jorski
I think that you will prefer the 21" Laser...with...

I think that you will prefer the 21" Laser...with JCrafts there is a fair amount of wetted surface, so it won't be much faster with the 24" Trophy, but the Laser will for sure have a better holeshot.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 01:07 PM.