Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 151
Search took 0.04 seconds.
Search: Posts Made By: AR Footer
Forum: Off Topic Discussion 11-15-2012, 02:19 PM
Replies: 13,933
Views: 3,710,494
Posted By AR Footer
Been too long. Good to see you back and a great...

Been too long. Good to see you back and a great shot of the Mrs.
Forum: Appearance 06-03-2011, 06:02 AM
Replies: 43
Views: 7,028
Posted By AR Footer
I wipe down the entire boat every time I take it...

I wipe down the entire boat every time I take it out of the water. Every other time, I also apply a coat of wax. Takes a little extra time but certainly worth it in the long run.
Forum: General Discussion 09-26-2010, 09:30 AM
Replies: 1
Views: 354
Posted By AR Footer
Not sure about the chrome caps. If the bearings...

Not sure about the chrome caps. If the bearings and the seals are the same as mine, they will be:

Seal SKF17146
Inner bearing L68149
Inner race ...
Forum: Off Topic Discussion 09-08-2010, 10:01 PM
Replies: 13,933
Views: 3,710,494
Posted By AR Footer
WOW!!!!!! Need I say more???????

WOW!!!!!! Need I say more???????
Forum: Trailers 09-07-2010, 08:15 PM
Replies: 4
Views: 472
Posted By AR Footer
Good idea. I have checked everything else so I...

Good idea. I have checked everything else so I feel pretty confident that it is the spindle but a second look will not hurt.
Forum: Trailers 09-07-2010, 08:13 PM
Replies: 4
Views: 472
Posted By AR Footer
I have considered that but was wanting to keep my...

I have considered that but was wanting to keep my trailer original if I could but it is looking like that may be impossible.
Forum: Trailers 09-07-2010, 07:10 AM
Replies: 4
Views: 472
Posted By AR Footer
Trailer Axle issue on 85

I cannot seem to get a wheel seal not to leak on one side of my trailer axle. I have replaced it numerous times. When I purchased it, the previous owner said that he had suffered a bearing failure on...
Forum: General Discussion 09-05-2010, 11:10 PM
Replies: 1,081
Views: 129,830
Posted By AR Footer
License plate frame update

Any update on the license plate frames?
Forum: General Discussion 10-31-2009, 07:10 AM
Replies: 5
Views: 894
Posted By AR Footer
I would still contact skiddim just to make sure...

I would still contact skiddim just to make sure that the same kit is used but here are the part numbers of everything that I used:

UFLROTECHKIT14 Rotary System Item #2414
6301335 ...
Forum: General Discussion 10-30-2009, 11:53 PM
Replies: 5
Views: 894
Posted By AR Footer
I had the same problem with my 85 this past...

I had the same problem with my 85 this past summer. Ordered a new steering cable and related parts from Discount Inboard Marine (www.skidim.com) and it works as good as new. Really smooth and easy....
Forum: General Discussion 07-29-2009, 10:41 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I haven't and I don't know why. I will try that...

I haven't and I don't know why. I will try that the next time I have time to work on it.
Forum: General Discussion 07-29-2009, 10:39 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I did not disconnect the boat battery at first...

I did not disconnect the boat battery at first and that is when I could get it to turn over. When I took the battery cables off the boat battery and connected them to my jumper cables it would not...
Forum: General Discussion 07-29-2009, 06:05 PM
Replies: 40
Views: 2,522
Posted By AR Footer
Jumper cable on battery positive of my truck and...

Jumper cable on battery positive of my truck and other end of cable was on positive on relay. The other jumper cable was on negative of truck battery on one end and the motor mount on the other end....
Forum: General Discussion 07-28-2009, 11:23 PM
Replies: 40
Views: 2,522
Posted By AR Footer
Engine is free. I actually got it to turn over...

Engine is free. I actually got it to turn over tonight but not through normal means. I describe the means in my post in reply to JimN.

I appreciate the help.
Forum: General Discussion 07-28-2009, 11:22 PM
Replies: 40
Views: 2,522
Posted By AR Footer
New development!!! I took my jumper cables and...

New development!!! I took my jumper cables and connected the positive to the positive post on the relay and then the negative to the motor mount. Bumped switch and engine turned over. Took battery...
Forum: General Discussion 07-28-2009, 09:40 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I have and still nothing.

I have and still nothing.
Forum: General Discussion 07-28-2009, 09:33 PM
Replies: 40
Views: 2,522
Posted By AR Footer
No disconnect switch for battery.

No disconnect switch for battery.
Forum: General Discussion 07-28-2009, 09:32 PM
Replies: 40
Views: 2,522
Posted By AR Footer
It will not even crank. I replaced the solenoid...

It will not even crank. I replaced the solenoid and the starter but still no cranking. Just the clicking from the solenoid. I took the wire off of the starter just to see if I could get power and I...
Forum: General Discussion 07-28-2009, 09:22 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I don't have access to a volt meter.

I don't have access to a volt meter.
Forum: General Discussion 07-28-2009, 08:49 PM
Replies: 40
Views: 2,522
Posted By AR Footer
Well I'm into my fourth day and $100 (new starter...

Well I'm into my fourth day and $100 (new starter and relay) working on this problem and I am no closer to having it fixed than before. I have cleaned all my connections. Ran another ground wire....
Forum: General Discussion 07-26-2009, 11:17 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I hadn't thought about the metal tabs. I will...

I hadn't thought about the metal tabs. I will also sand the plate to which the relay connects when I sand the starter face and the block. I will try that first and then the wire to the relay's metal...
Forum: General Discussion 07-26-2009, 11:13 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I plan to try that tomorow night. Thanks for the...

I plan to try that tomorow night. Thanks for the reply.
Forum: General Discussion 07-26-2009, 07:23 PM
Replies: 40
Views: 2,522
Posted By AR Footer
I did clean and tighten the battery cables and...

I did clean and tighten the battery cables and clamps. Not sure on the lubrication of the starter. I took it off a gain and took it to the auto parts store. They checked it all out and they seem to...
Forum: General Discussion 07-26-2009, 09:07 AM
Replies: 40
Views: 2,522
Posted By AR Footer
Well, I got a surprise yesterday. I was going to...

Well, I got a surprise yesterday. I was going to work on the hard starting issue when warm and when I tried to crank the motor, it would not crank. I had a clicking sound back toward the back of the...
Forum: General Discussion 07-20-2009, 07:07 AM
Replies: 5
Views: 959
Posted By AR Footer
I had a very similar problem with my 85. I...

I had a very similar problem with my 85. I rebuilt the carb and that fixed the problem.
Showing results 1 to 25 of 151

 

All times are GMT -4. The time now is 02:58 AM.