Go Back   TeamTalk > Search Forums

Showing results 1 to 22 of 22
Search took 0.00 seconds.
Search: Posts Made By: jj4smith
Forum: Wakesurfing 02-15-2015, 05:19 PM
Replies: 36
Views: 3,002
Posted By jj4smith
I tried posting this video before but don't think...

I tried posting this video before but don't think it worked....hopefully it does this time.

https://vimeo.com/119701270


Sent from my iPhone using Tapatalk
Forum: General Discussion 02-13-2015, 05:49 PM
Replies: 26
Views: 3,391
Posted By jj4smith
raise set option

I wonder if I could use something like this to raise my seat. Then it could swivel too! Or would this just look ghetto?
Forum: Wakesurfing 01-31-2015, 04:28 PM
Replies: 17
Views: 1,135
Posted By jj4smith
VRS dividers

Can you give some more detail about how you remade your dividers? Did you just move the original dividers? Or did you make brand new ones? I've been thinking about doing this myself. Thanks.
Forum: Engine / Drive Train 01-03-2015, 10:15 AM
Replies: 13
Views: 733
Posted By jj4smith
I've been thinking about going to a dripless...

I've been thinking about going to a dripless system for quite some time now. How exactly do those work? I see there is a nipple. I'm assuming a small tube carries the water away, but to where? A...
Forum: Engine / Drive Train 01-02-2015, 07:46 AM
Replies: 13
Views: 733
Posted By jj4smith
Thanks for all the input. I think I might have...

Thanks for all the input. I think I might have them replace the shaft packing and my rudder port at the same time. Hopefully this will reduce the amount of water in my bilge.


Sent from my iPhone...
Forum: Engine / Drive Train 01-01-2015, 10:11 AM
Replies: 13
Views: 733
Posted By jj4smith
V drive seal replacement

I have a seal that is apparently leaking on the v drive of my Maristar. It's the lower seal on the prop shaft output. My dealer says they have to pull the whole engine and vdrive unit in order to...
Forum: Wakesurfing 12-16-2014, 10:56 PM
Replies: 17
Views: 1,135
Posted By jj4smith
Get an ACME 1235 too. You will poop your pants...

Get an ACME 1235 too. You will poop your pants when you hit the throttle. Plus it's a lot easier on the engine holding the low speeds.


Sent from my iPhone using Tapatalk
Forum: Wakesurfing 12-16-2014, 10:36 PM
Replies: 17
Views: 1,135
Posted By jj4smith
Weighting a 1995 Maristar 200 VRS for surfing

I have a 95 Maristar 200 VRS. We have an older sumo 800 pound sac in each rear ski locker. I plumbed them in so they drain fill with the flick of a button on the dash. We also manually fill a 240...
Forum: Wakesurfing 09-20-2014, 11:24 PM
Replies: 36
Views: 3,002
Posted By jj4smith
Nice video VP46. Looks like you have a blast on...

Nice video VP46. Looks like you have a blast on the boat with your family.
Forum: Wakesurfing 09-20-2014, 11:18 PM
Replies: 36
Views: 3,002
Posted By jj4smith
Surfing behind Maristar 200VRS

https://drive.google.com/open?id=0B0tt22KqyqOAekpmd0I4SlhDMzA
Forum: Wakesurfing 03-13-2014, 09:54 AM
Replies: 65
Views: 5,305
Posted By jj4smith
Scott023, I'm thinking about ordering a Day1...

Scott023, I'm thinking about ordering a Day1 board. I'm not sure if I wanna go with a twin fin setup or a quad fin. Why did you pick the quad fin?


Sent from my iPhone using Tapatalk
Forum: Wakesurfing 03-09-2014, 06:30 PM
Replies: 618
Views: 109,983
Posted By jj4smith
Impressive! What kind of board you ride? I'll be...

Impressive! What kind of board you ride? I'll be looking for a new one this season.
Forum: Wakesurfing 03-09-2014, 01:46 PM
Replies: 618
Views: 109,983
Posted By jj4smith
800 in corner, 260 on seat in corner, 260 in...

800 in corner, 260 on seat in corner, 260 in walkway, 3 adults in boat.

You doing any 360's yet? We are just learning how, video attached.

I do like the Maristar for surfing just wish it had a...
Forum: Wakesurfing 03-08-2014, 07:51 PM
Replies: 618
Views: 109,983
Posted By jj4smith
95 Maristar surf wake

Nice wake Traxx822! We have that same exact boat, and I just post a pic of my wife surfing.
Forum: Wakesurfing 03-08-2014, 07:47 PM
Replies: 618
Views: 109,983
Posted By jj4smith
95 Maristar surf wake

Here's my wife behind our 95 Maristar 200 VRS.
Forum: Appearance 06-01-2013, 10:45 PM
Replies: 61
Views: 10,972
Posted By jj4smith
Anybody willing to cut me a set of plain white...

Anybody willing to cut me a set of plain white 50" mc decals?
Forum: Appearance 06-01-2013, 02:03 PM
Replies: 8
Views: 860
Posted By jj4smith
I have the same exact boat, and I'm looking for a...

I have the same exact boat, and I'm looking for a set of plain white MASTERCRAFT 50" decals. The existing decals are all scratched up. I think I just need to find somebody with a vinyl cutter. I...
Forum: Engine / Drive Train 09-24-2012, 01:27 PM
Replies: 8
Views: 1,525
Posted By jj4smith
ahhudgines: You use SAE30 in the v drive? What...

ahhudgines: You use SAE30 in the v drive? What about the tranny, 15W40 or Dextron III?

Thanks for your help.
Forum: Engine / Drive Train 09-20-2012, 08:29 PM
Replies: 8
Views: 1,525
Posted By jj4smith
my shaft is 1 1/8". that would make sense that...

my shaft is 1 1/8". that would make sense that the gear reduction would be in the v-drive. thanks for your help.
Forum: Engine / Drive Train 09-20-2012, 04:09 PM
Replies: 8
Views: 1,525
Posted By jj4smith
1995 maristar 200VRS transmission 1:1 or 1:1.5

I have a 95 maristar 200 VRS. I've been told by wakeprops that all mastercrafts with 1 1/8 shafts have the 1:1.5 powerslot transmission. However the sticker on my transmission clearly shows the Hurth...
Forum: Engine / Drive Train 05-16-2012, 08:22 AM
Replies: 2
Views: 615
Posted By jj4smith
Prop shaft bent or motor misaligned?

Took the following video of my propeller shaft. You can see the packing nut is moving back and fourth. Wondering if anybody knows if this is a bent shaft or if something is just out of alignment. I...
Forum: General / Other 04-19-2012, 01:34 PM
Replies: 1
Views: 1,193
Posted By jj4smith
depth finder/speedometer 1995 Maristar

I'm having problems with both my speedometer and teleflex through hull digital depth finder. The speedometer only seems to work at speeds above 20 mph, and the depth finder doesn't work at all. I...
Showing results 1 to 22 of 22

 

All times are GMT -4. The time now is 06:49 PM.