Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.67 seconds.
Search: Posts Made By: blackhawk
Forum: Trailers 05-03-2015, 11:31 PM
Replies: 5
Views: 246
Posted By blackhawk
Would you be willing to part with the reservoir...

Would you be willing to part with the reservoir cap from the old Reliable unit? Mine is kind of chewed up on the hex and the diaphragm is caved in.
Forum: General Discussion 05-03-2015, 11:19 PM
Replies: 38
Views: 1,138
Posted By blackhawk
Disconnect your lanyard and just give the starter...

Disconnect your lanyard and just give the starter a very slight bump to turn the crank. Or you could turn the engine over by hand. I wouldn't think that it would get stuck on the crankshaft, but it...
Forum: General Discussion 05-03-2015, 11:14 PM
Replies: 13
Views: 666
Posted By blackhawk
After checking all the hoses for blockage, you...

After checking all the hoses for blockage, you could run it out of the water using the bucket method. That would make it easy to see if you are pulling water through the engine and out the exhaust.
Forum: Appearance 05-02-2015, 11:08 PM
Replies: 14
Views: 522
Posted By blackhawk
I agree with MikeG, that it is repairable. It...

I agree with MikeG, that it is repairable. It will definitely take some patience to get it right though.
Forum: Appearance 05-01-2015, 11:28 PM
Replies: 3
Views: 195
Posted By blackhawk
3M Finesse-it II

3M Finesse-it II
Forum: Wanted to Buy 04-29-2015, 11:47 PM
Replies: 2
Views: 112
Posted By blackhawk
Here is a link to Hammer's upholstery pics. Send...

Here is a link to Hammer's upholstery pics. Send him a PM about the shop that he used.

http://www.mastercraft.com/teamtalk/showthread.php?t=59338&highlight=compound&page=4
Forum: Wanted to Buy 04-29-2015, 11:44 PM
Replies: 2
Views: 112
Posted By blackhawk
Probably will have to get them custom made for a...

Probably will have to get them custom made for a 2006. Hammer had his X46 upholstery done by a shop in your area. From the pics that he posted, looked like a quality job.
Forum: Appearance 04-29-2015, 11:36 PM
Replies: 14
Views: 522
Posted By blackhawk
Is there a story behind this?

Is there a story behind this?
Forum: General Discussion 04-29-2015, 11:34 PM
Replies: 65
Views: 2,014
Posted By blackhawk
It is your boat, but my vote would be against a...

It is your boat, but my vote would be against a Harley theme.
Forum: General Discussion 04-28-2015, 10:18 PM
Replies: 6
Views: 344
Posted By blackhawk
The dealer did it correctly. That is how the...

The dealer did it correctly. That is how the Wakemaker's system is also. With bags piggybacked, you just have to be sure that when you empty them, that the bags don't collapse completely so that...
Forum: Ballast 04-27-2015, 11:46 PM
Replies: 3
Views: 140
Posted By blackhawk
Go to the pump and unplug its electrical...

Go to the pump and unplug its electrical connector. Turn on your pump switch and use a multimeter to check that you have 12-13 volts at the connector. If you have voltage there, your pump is...
Forum: Appearance 04-27-2015, 11:42 PM
Replies: 8
Views: 609
Posted By blackhawk
Shoot, I used 8" pads above my rub rail. You...

Shoot, I used 8" pads above my rub rail. You just have to be careful. You can't reach into corners, but there really aren't many corners.
Forum: General Discussion 04-27-2015, 11:35 PM
Replies: 20
Views: 699
Posted By blackhawk
Dark tan

Dark tan
Forum: Ballast 04-25-2015, 11:52 PM
Replies: 28
Views: 1,182
Posted By blackhawk
Unplug the quick disconnect at the motor. Turn...

Unplug the quick disconnect at the motor. Turn on the pump switch and check for 12 volts at the plug. If you have voltage there, your pump is dead, most likely the brushes.

If no voltage at the...
Forum: General Discussion 04-24-2015, 10:46 PM
Replies: 25
Views: 1,033
Posted By blackhawk
Very nice boat! My dog has ridden on the boat...

Very nice boat! My dog has ridden on the boat with us since he was a pup. He loves to ride on the back seat with the air in his face. Just keep his nails trim and you'll be just fine.
Forum: Off Topic Discussion 04-23-2015, 11:54 PM
Replies: 156
Views: 9,694
Posted By blackhawk
Good idea Kyle!

Good idea Kyle!
Forum: General / Other 04-23-2015, 11:42 PM
Replies: 12
Views: 552
Posted By blackhawk
inboardonline.com

inboardonline.com
Forum: General Discussion 04-23-2015, 11:38 PM
Replies: 18
Views: 1,018
Posted By blackhawk
bturner2 - How much brake fluid does it take to...

bturner2 - How much brake fluid does it take to flush the brake system?
Forum: General Discussion 04-21-2015, 10:08 PM
Replies: 18
Views: 1,018
Posted By blackhawk
How much fluid does it typically take to flush...

How much fluid does it typically take to flush out a tandem trailer? I have emptied a 12 oz bottle just on the first caliper and it still hasn't started to run clear.

My 2006 trailer is stamped...
Forum: Upholstery 04-19-2015, 09:47 PM
Replies: 4
Views: 282
Posted By blackhawk
You could try some 3M general purpose adhesive...

You could try some 3M general purpose adhesive remover. I would definitely try it on an inconspicuous spot first. You can get it from Amazon, but some Napa stores also have it. ...
Forum: Audio/Stereo 04-19-2015, 09:40 PM
Replies: 2
Views: 386
Posted By blackhawk
JL Audio sale at Crutchfield's

Just got an email from Crutchfield that all their JL Marine audio gear is on sale for 15% off.
Forum: Off Topic Discussion 04-14-2015, 09:37 PM
Replies: 2
Views: 226
Posted By blackhawk
Great! If you do make it there, just PM me and I...

Great! If you do make it there, just PM me and I will send you my email address.

Thanks
Forum: Appearance 04-14-2015, 09:31 PM
Replies: 126
Views: 8,980
Posted By blackhawk
You are probably going to need some fairing putty...

You are probably going to need some fairing putty in those gouges to get it back smooth before gelcoating. I see some wet sanding in your future.

Do you beach your boat?
Forum: General Discussion 04-14-2015, 09:28 PM
Replies: 13
Views: 493
Posted By blackhawk
1 corvette engine versus $25 of AF and 30 minutes...

1 corvette engine versus $25 of AF and 30 minutes time. No brainer in my book.
Forum: Off Topic Discussion 04-13-2015, 09:42 PM
Replies: 2
Views: 226
Posted By blackhawk
Silver Dollar City, Branson - anyone going there?

Here is a pic of a monument that was done at the entrance to Fireman's Landing in Silver Dollar City, (Branson, MO). I have a side business making signs and I made the large central sign and small...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 01:11 AM.