Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 9.33 seconds.
Search: Posts Made By: MattsCraft
Forum: General Discussion 10-17-2018, 03:24 PM
Replies: 4
Views: 371
Posted By MattsCraft
Yes - Filter off, cap open - That would be a cool...

Yes - Filter off, cap open - That would be a cool trick to get 5 Qts out of a 4.5 Qt system:rolleyes:
Forum: General Discussion 10-14-2018, 12:31 PM
Replies: 4
Views: 371
Posted By MattsCraft
Another Oil Change Thread

As the title states - Prob discussed 1000 times...


Specifically a 2013 Ilmor 6.2 liter V-drive


Less than 300 hours over 7 oil changes in her life - 1st, 2nd & 4th completed by the dealer.


On...
Forum: Ballast 10-13-2018, 07:57 AM
Replies: 8
Views: 165
Posted By MattsCraft
I do my KGB this way - I use a clear piece of...

I do my KGB this way - I use a clear piece of hose & funnel, it will want to burp, so go slow.


I always forget which is the ballast & which is the bilge, just run your bilge & listen with your ear...
Forum: Tow Vehicles 10-12-2018, 04:19 PM
Replies: 79
Views: 13,772
Posted By MattsCraft
Thanks a ton!

Thanks a ton!
Forum: Tow Vehicles 10-11-2018, 03:31 PM
Replies: 79
Views: 13,772
Posted By MattsCraft
Do tell of this tuning you speak of... I have...

Do tell of this tuning you speak of... I have mine scheduled to get the de-tune, for the cash, then I would like to have it tuned correctly!
Forum: General Discussion 09-17-2018, 09:38 AM
Replies: 150
Views: 7,174
Posted By MattsCraft
Yo Ho Ho, avast, me bilge is the place for them...

Yo Ho Ho, avast, me bilge is the place for them swashbucklin landlubers!
Forum: Electrical 09-16-2018, 07:53 AM
Replies: 1
Views: 112
Posted By MattsCraft
From your description, sounds like the GPS puck...

From your description, sounds like the GPS puck is bad. It is the black puck just outside the windshield on the drivers side - You can follow the wire from here under your dash & see where it plugs...
Forum: General Discussion 09-15-2018, 11:10 AM
Replies: 8
Views: 361
Posted By MattsCraft
I don't have it on my X25 - I actually prefer non...

I don't have it on my X25 - I actually prefer non power steering vs Power - Mine is super easy to turn & holds in place while under way no problems.
Forum: General Discussion 09-15-2018, 11:07 AM
Replies: 150
Views: 7,174
Posted By MattsCraft
Awesome DD - Happy for you, can't wait to see it...

Awesome DD - Happy for you, can't wait to see it in person!:D:D:D


Hmmm 400HP, might have a drag race contender for my X25;):D
Forum: Off Topic Discussion 09-09-2018, 09:17 AM
Replies: 93
Views: 9,093
Posted By MattsCraft
With all this rain in Cincy this weekend, you...

With all this rain in Cincy this weekend, you might get to test that floodplain requirement8p
The river at Cincy is at 38' forecast to 49.9' by Thursday. Crazy, this is spring levels!:(
Forum: For Sale: Boats 09-04-2018, 07:48 PM
Replies: 39
Views: 3,296
Posted By MattsCraft
Exactly...

Exactly...
Forum: General / Other 08-27-2018, 09:19 AM
Replies: 7,292
Views: 1,361,943
Posted By MattsCraft
Dome Numbers hooked me up with some awesome...

Dome Numbers hooked me up with some awesome decals :cool:
Forum: For Sale: Boats 08-27-2018, 07:50 AM
Replies: 39
Views: 3,296
Posted By MattsCraft
GLWS DD - Sweet boat for sure - Pretty sure I...

GLWS DD - Sweet boat for sure - Pretty sure I know whats next :cool:
Forum: General Discussion 08-20-2018, 01:23 PM
Replies: 3
Views: 227
Posted By MattsCraft
PTM Edge

I have to give a HUGE SHOUT OUT to the folks at PTM Edge & Jason!!!



Customer Service is over the top - I mean seriously over the top!


Long story short, I lost a bolt to the windshield mounting...
Forum: General Discussion 08-20-2018, 11:41 AM
Replies: 24
Views: 1,261
Posted By MattsCraft
Yeah - It goes into what they call a block, for...

Yeah - It goes into what they call a block, for the pitch/angle etc. & balanced, as others said it does not take much to cause some wicked vibration.


I carry a spare, for this reason, I've been...
Forum: General Discussion 08-20-2018, 11:10 AM
Replies: 24
Views: 1,261
Posted By MattsCraft
Your shaft could be out of alignment, however I...

Your shaft could be out of alignment, however I would start with repairing your prop or replacing. I have had a prop with no visual damage to me, however My prop guy looked at it & could tell...
Forum: Towers 08-16-2018, 09:33 AM
Replies: 30
Views: 1,210
Posted By MattsCraft
Here is a permanent fix to the issue!

Here is a permanent fix to the issue!
Forum: MasterCraft In Your Area 08-16-2018, 07:30 AM
Replies: 182
Views: 8,100
Posted By MattsCraft
Always open my man & since I skied behind your...

Always open my man & since I skied behind your boat this year, means you have to surf behind my boat next year!8p Again, thanks for the pull!:D
Forum: Towers 08-16-2018, 07:20 AM
Replies: 30
Views: 1,210
Posted By MattsCraft
I used to have this problem on my 4 point tower -...

I used to have this problem on my 4 point tower - The double nut trick works.


I used red thread locker on the knob part which seemed to work, not sure how long as I sold the boat.


If I would have...
Forum: General Discussion 08-16-2018, 07:16 AM
Replies: 121
Views: 17,194
Posted By MattsCraft
Man o man, all these issues with the Gen II...

Man o man, all these issues with the Gen II software:confused:


I have a '13 X25 with added Gen II tabs, I have not updated the software, but having zero problems - Knock On Wood ;) I have no plan...
Forum: MasterCraft In Your Area 08-15-2018, 10:36 AM
Replies: 182
Views: 8,100
Posted By MattsCraft
This pic upload limit is killing me:D

This pic upload limit is killing me:D
Forum: MasterCraft In Your Area 08-15-2018, 10:30 AM
Replies: 182
Views: 8,100
Posted By MattsCraft
More...

More...
Forum: MasterCraft In Your Area 08-15-2018, 10:22 AM
Replies: 182
Views: 8,100
Posted By MattsCraft
OK - Here is a small sampling of pics - 182...

OK - Here is a small sampling of pics - 182 uploaded to DD, which I am sure he will post on the FB page. If anyone see's a pic from there they want, PM me with an email & I can send the high res...
Forum: MasterCraft In Your Area 08-14-2018, 05:41 PM
Replies: 31
Views: 1,262
Posted By MattsCraft
Unfortunately we are out this year [emoji31] My...

Unfortunately we are out this year [emoji31] My son is getting hitched on 9/1! Always a great highlight weekend for the end of the year, we will miss you guys!


Sent from my iPhone using Tapatalk
Forum: MasterCraft In Your Area 08-13-2018, 08:16 PM
Replies: 182
Views: 8,100
Posted By MattsCraft
Sunday Funday @ Bash 9 - A little drag race...

Sunday Funday @ Bash 9 - A little drag race challenge between the 214 Direct Drive vs X25 V Drive. - No Replacement for...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 03:39 AM.


2018