Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: TRBenj
Forum: Engine / Drive Train 04-24-2015, 11:01 AM
Replies: 89
Views: 4,220
Posted By TRBenj
351W Rebuild

Wait, you had a 13x13 and now have a 14x18? Which trans do you have? There is no engine/trans capable of turning both props, they are different by a factor of 50%. If you have a 1:1 with a 14x18,...
Forum: Trailers 04-23-2015, 04:54 PM
Replies: 9
Views: 336
Posted By TRBenj
trailer bearing service help needed

The only times I've seen races fall right out and new ones slide right in by hand, the hub was cracked. They are not always easy to see, especially if theyre still dirty and full of grease. Even...
Forum: Engine / Drive Train 04-23-2015, 10:07 AM
Replies: 89
Views: 4,220
Posted By TRBenj
Misalignment will usually quell vibration due to...

Misalignment will usually quell vibration due to the side loading, not cause or exacerbate it. I'm betting bent shaft or prop.
Forum: Engine / Drive Train 04-21-2015, 04:23 PM
Replies: 15
Views: 736
Posted By TRBenj
You can buy replacement gears of all types for...

You can buy replacement gears of all types for both flat tappet and roller cams. The rollers are just more common since a gear swap is required with the conversion. It is not out of the question that...
Forum: Engine / Drive Train 04-21-2015, 04:21 PM
Replies: 89
Views: 4,220
Posted By TRBenj
351W Rebuild

A 13x13 is a way wrong prop for a powerslot (implied by the current 14x18).

Not sure if the video showcased what you were trying to describe but it is highly unlikely you are overpowering your prop...
Forum: Engine / Drive Train 03-28-2015, 07:32 AM
Replies: 15
Views: 736
Posted By TRBenj
302 is out of luck but the 351c/460 msd only...

302 is out of luck but the 351c/460 msd only requires a gear swap in order to be used on a 351w. My buddy runs one on his stroker 408w.
Forum: Engine / Drive Train 03-27-2015, 04:26 PM
Replies: 15
Views: 736
Posted By TRBenj
Anyone who thinks there is a world of difference...

Anyone who thinks there is a world of difference between points and EI in terms of starting ease or performance gains was comparing apples to oranges- surely the points set you switched from was in...
Forum: Engine / Drive Train 03-27-2015, 12:47 PM
Replies: 15
Views: 736
Posted By TRBenj
Voltage at the plug is a function of the coil not...

Voltage at the plug is a function of the coil not the trigger mechanism (points vs EI). The dwell of that trigger could arguably be a little better controlled on certain EI systems, but I call BS on...
Forum: General Discussion 03-25-2015, 02:57 PM
Replies: 72
Views: 3,403
Posted By TRBenj
Well this thread took a turn, ha. The Fish is a...

Well this thread took a turn, ha.

The Fish is a very cool boat but the wake is lousy by all accounts... Unless you're barefooting (and then the issue is top end speed). The wake is big but the lip...
Forum: General Discussion 03-09-2015, 03:03 PM
Replies: 27
Views: 1,002
Posted By TRBenj
Probably 800 or so for a Coversports (possibly...

Probably 800 or so for a Coversports (possibly more), assuming their pricing is in line with the now-defunct Rankin covers that pioneered that towable style of cover.

Skiboatcovers should be less-...
Forum: General Discussion 03-05-2015, 11:26 AM
Replies: 19
Views: 1,307
Posted By TRBenj
Why can't it be towed? Trailer not trustworthy?

Why can't it be towed? Trailer not trustworthy?
Forum: Engine / Drive Train 02-02-2015, 07:32 AM
Replies: 89
Views: 4,220
Posted By TRBenj
The cam lobe to lifter interface is the critical...

The cam lobe to lifter interface is the critical one, and the one addressed by CR's break in service. They do number and box up the lifters, obviously- otherwise this would be pointless.

I have...
Forum: Engine / Drive Train 02-02-2015, 07:26 AM
Replies: 9
Views: 604
Posted By TRBenj
A proper head service (including vj) will cost...

A proper head service (including vj) will cost 75-85% of a pair of rebuilt gt40p's, at least around here. I wouldn't put a dime into the stock heads, but that's just me.
Forum: Engine / Drive Train 01-22-2015, 01:39 PM
Replies: 6
Views: 527
Posted By TRBenj
You have it backwards. MC used standard rotation...

You have it backwards. MC used standard rotation engines most commonly, with LH props. LH props back to starboard.

Reverse rotation engines mated to 1:1 transmissions use RH props and back to...
Forum: Engine / Drive Train 01-14-2015, 09:25 AM
Replies: 16
Views: 938
Posted By TRBenj
Prussian blue will confirm if your fit on the...

Prussian blue will confirm if your fit on the taper is ok or not... Lapping compound would be needed to address a poor fit.

A 541 will really wake the boat up, the 13x15 is way wrong for a 1:1 small...
Forum: General Discussion 11-20-2014, 03:51 PM
Replies: 15
Views: 873
Posted By TRBenj
'07 v8 4runner with 185k here. I've replaced the...

'07 v8 4runner with 185k here. I've replaced the front calipers but that's about the only thing I've done to it other than routine maintenance. Did the timing belt and water pump at 110k.

I tow a...
Forum: Engine / Drive Train 10-28-2014, 10:29 AM
Replies: 5
Views: 494
Posted By TRBenj
This does not sound like a gasket failure. Did...

This does not sound like a gasket failure. Did you remember to re-torque the bolts after a few heat cycles following reinstallation? If not, there's a good chance they'll loosen up.

In case you...
Forum: General Discussion 10-21-2014, 10:29 AM
Replies: 20
Views: 1,241
Posted By TRBenj
I've seen hand tight strainers cause moderate...

I've seen hand tight strainers cause moderate overheats at idle... Air leaks! Not sure how water pressure would help seal a leak [lol]. I've found tightening them down more aggressively stops this....
Forum: Off Topic Discussion 10-17-2014, 04:34 PM
Replies: 13
Views: 930
Posted By TRBenj
A buddy of mine had a couple ts6m's before he...

A buddy of mine had a couple ts6m's before he bought his SN. I remember them being nice skiing and footing boats! In our ski group consisting mostly of early 90's nautiques and MC's, it did just...
Forum: General Discussion 10-13-2014, 09:39 AM
Replies: 56
Views: 3,702
Posted By TRBenj
In all seriousness, there is no "magic bullet"...

In all seriousness, there is no "magic bullet" when it comes to prop selection. There is no prop that would push a x-star to 80. You can't simply add pitch and make the boat faster, it just doesn't...
Forum: Engine / Drive Train 09-29-2014, 03:38 PM
Replies: 20
Views: 1,222
Posted By TRBenj
I believe PCM had you bypass the resistor for...

I believe PCM had you bypass the resistor for that ei kit.
Forum: Engine / Drive Train 09-28-2014, 09:53 PM
Replies: 20
Views: 1,222
Posted By TRBenj
Yes that is a Prestolite ei module. PCM sold it...

Yes that is a Prestolite ei module. PCM sold it under their name as well.
Forum: Off Topic Discussion 09-22-2014, 12:34 PM
Replies: 1
Views: 604
Posted By TRBenj
Having a hard time getting PM's to go through on...

Having a hard time getting PM's to go through on my phone... Those hub caps would be sweet if you still have them: trbenj@gmail.com
Forum: Engine / Drive Train 09-10-2014, 08:37 AM
Replies: 7
Views: 453
Posted By TRBenj
The cooling system isn't cooling if the engine...

The cooling system isn't cooling if the engine isn't running, as the RWP isn't forcing in cool lake water. The residual heat in the hotter parts of the engine (comb chambers, exhaust runners) will...
Forum: Engine / Drive Train 09-08-2014, 07:48 PM
Replies: 17
Views: 943
Posted By TRBenj
If original, the commander is most certainly a RH...

If original, the commander is most certainly a RH engine if it came out of a single engine correct craft. Trans can spin either way but you need to index the pump. There is value in the commander...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 10:08 PM.