Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 71
Search took 0.05 seconds.
Search: Posts Made By: x10vancouver2003
Forum: General Discussion 08-07-2011, 03:48 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
Bump, RE: the boat stereo issue?

Bump, RE: the boat stereo issue?
Forum: General Discussion 08-05-2011, 08:15 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
Thanks again for all the replies everyone. So I...

Thanks again for all the replies everyone.

So I replaced the impeller in the engine, got the boat on level ground (our driveway is quite the slope)...and ran the hose into the engine with the boat...
Forum: General Discussion 08-05-2011, 02:48 PM
Replies: 24
Views: 3,084
Posted By x10vancouver2003
I also have an '03 X10...and agree with most that...

I also have an '03 X10...and agree with most that have replied to your thread. Definitely get rid of the OEM finger racks, and replace them with something that will last a long time to come.

I had...
Forum: General Discussion 08-05-2011, 12:16 AM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
There is no water coming out of the 2 exhaust...

There is no water coming out of the 2 exhaust holes in the stern under the swim grid...only out of the top of the shaft.

I have never seen water come out at the top end of the shaft before. Not sure...
Forum: General Discussion 08-04-2011, 10:26 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
OK so here is where we are at now: - I pulled...

OK so here is where we are at now:

- I pulled the boat out of the auto mechanic today. The trailer light issue is fixed...so those will run at night now. (there was a blown fuse in the engine...
Forum: General Discussion 08-04-2011, 03:58 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
AUTO mechanic. He called me within 30 minutes,...

AUTO mechanic. He called me within 30 minutes, and the boat was fixed. He had to replace an "ignition coil" in the engine, and the boat fired up right away. A $200 total fix, that was eventually...
Forum: General Discussion 08-04-2011, 03:54 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
Thanks everyone for the responses up to this...

Thanks everyone for the responses up to this point.

So I dragged the boat out of the MasterCraft dealership (after sitting there for 3 weeks), and took it to our family
Forum: General Discussion 07-25-2011, 08:33 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
***Haven't

***Haven't
Forum: General Discussion 07-25-2011, 08:32 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
Hey everyone...I've got to get this thread going...

Hey everyone...I've got to get this thread going again. Since I first started this thread, our '03 X10 has been with our personal boat mechanic for two weeks, and has been at the MasterCraft...
Forum: General Discussion 06-28-2011, 09:24 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
Thanks for all the replies so far...

Thanks for all the replies so far everyone...appreciate it. Since I'm being passed on this info from my Dad (who's talking to our mechanic), I may not have all the answers as or now. But here is an...
Forum: General Discussion 06-23-2011, 04:32 PM
Replies: 29
Views: 2,828
Posted By x10vancouver2003
'03 X10 issue (please help!!!)

Hello all,

My Dad was out in our 2003 X10 about a week ago, and the boat stopped working. It had to be towed into the dock, and has been at our mechanics place since then. Our mechanic has been...
Forum: General Discussion 10-19-2010, 11:34 PM
Replies: 21
Views: 2,437
Posted By x10vancouver2003
Thanks for the replies everyone!!! With the...

Thanks for the replies everyone!!!

With the installation of an IBS, how do you plumb it off the center ski locker sac? I have never dealt with a ballast install before...but it should definitely...
Forum: General Discussion 10-19-2010, 11:23 PM
Replies: 12
Views: 2,971
Posted By x10vancouver2003
Any idea where abouts in Surrey, BC? I live in...

Any idea where abouts in Surrey, BC?

I live in Surrey as well...we had a break in late last week in one of our cars in the driveway (boat is right beside the car), so there seems to be some problems...
Forum: General Discussion 10-17-2010, 08:55 PM
Replies: 21
Views: 2,437
Posted By x10vancouver2003
Adding FlyHigh sacks to stock ballast system...(winter project)

Hey all,

I am looking into adding some bigger sacs for my 2003 X10, and was looking for a bit of information and advice. The whole system is still stock, so the 2 hard tanks in the back compartments...
Forum: General Discussion 09-27-2010, 02:22 AM
Replies: 20
Views: 2,306
Posted By x10vancouver2003
I just picked up a O'Neill Boost from...

I just picked up a O'Neill Boost from activewake.com (very good price)...took a couple sets yesterday in it.

Very impressed with it so far. A little water got it around my neck after a couple very...
Forum: General Discussion 09-18-2010, 11:03 PM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
Bump???? :-)

Bump???? :-)
Forum: General Discussion 09-10-2010, 03:31 AM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
I believe it is a 2 vent, yes. As far as the...

I believe it is a 2 vent, yes. As far as the speed, I am not sure. Buying the boat used, we are just trying to work out the kinks and personalize the boat as much as we can.

I can't seem to get...
Forum: General Discussion 09-03-2010, 02:04 PM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
Thx for the reply, I'll give that a shot sometime...

Thx for the reply, I'll give that a shot sometime this weekend. How do you determine if the heater core has/had a leak in it? Which item# am I looking for on the 'skidim' site?...
Forum: General Discussion 09-02-2010, 08:23 PM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
Thx for the replies so far... But how do you get...

Thx for the replies so far...

But how do you get physical access to the circulating pump behind the kick panel?

Without getting it out, its probably impossible to determine what is exactly wrong...
Forum: General Discussion 09-02-2010, 03:17 AM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
How do you get access to the "blower fan...

How do you get access to the "blower fan box"/fan/circulating pump?

Does the kick panel come off? There are screws around the border...but it looks quite messy to deal with.

How would a water leak...
Forum: General Discussion 09-01-2010, 11:27 PM
Replies: 14
Views: 1,703
Posted By x10vancouver2003
Kind of reviving this thread a little late with...

Kind of reviving this thread a little late with the focus the last while on the audio system in the boat...but as the evenings get colder up here in Vancouver, BC...its time to get to the bottom of...
Forum: General Discussion 08-16-2010, 09:10 PM
Replies: 5
Views: 472
Posted By x10vancouver2003
Could that be the cause of both of the issues?...

Could that be the cause of both of the issues?

I am far from an audio junkie...but what is the reason why only some of the gauges are working, and why the deck will allow a certain volume, and then...
Forum: General Discussion 08-16-2010, 06:40 PM
Replies: 5
Views: 472
Posted By x10vancouver2003
Aftermarket audio question...

Hey all,

Through a local marine audio shop, we installed 2 Wetsounds SST-65 tower speakers, a 10" Hertz sub and box, and an Exile 5 channel amplifier.

We had an existing Kenwood deck in the boat,...
Forum: General Discussion 08-02-2010, 04:33 PM
Replies: 23
Views: 1,713
Posted By x10vancouver2003
The response I got from MC by Design basically...

The response I got from MC by Design basically said that they have run into this problem before, and they can rebuilt the current racks. They require the rack to be sent to them...they will take a...
Forum: General Discussion 07-30-2010, 08:58 PM
Replies: 23
Views: 1,713
Posted By x10vancouver2003
I sent an email to MC by Design regarding the '03...

I sent an email to MC by Design regarding the '03 racks...will let you all know what they suggest and if there are any options.

With the amount of demand out there, some kind of solution should be...
Showing results 1 to 25 of 71

 

All times are GMT -4. The time now is 05:07 AM.