TeamTalk > Search Forums Search Results

User Name Remember Me? Password

Page 1 of 12 1 2 3 11 > Last »

Showing results 1 to 25 of 287 Search took 0.50 seconds. Search: Posts Made By: hkallestad

Forum: Engine / Drive Train 06-29-2012, 10:11 AM

Replies: 1 Velvet drive shaft OD Views: 180 Posted By hkallestad Engine and gear has 1800 hours, I fixed my... Engine and gear has 1800 hours, I fixed my crankshaft seal area(rear main) the same way, worked fine. Anybody?

Forum: Engine / Drive Train 06-28-2012, 05:08 PM

Replies: 1 Velvet drive shaft OD Views: 180 Posted By hkallestad Velvet drive shaft OD My velvet drive is leaking at the front pump seal, changing the seal didn't help. Does anybody know the exact OD of the seal area on the shaft? I'm thinking of installing a repair sleeve since the...

Forum: Engine / Drive Train 07-05-2011, 04:12 AM

Replies: 30 '87 PS190 Loss of RPM's after warm up Views: 2,200 Posted By hkallestad Changing the two fuel filters is routine... Changing the two fuel filters is routine maintenance;-)) I change them once a year. Hope you fix your problem.

Forum: Engine / Drive Train 06-04-2011, 07:37 PM

Replies: 6 87 prostar need help Views: 457 Posted By hkallestad I can't help you much, but change to electronic... I can't help you much, but change to electronic ignition, you will never look back.

Forum: Engine / Drive Train 06-02-2011, 07:00 AM

Replies: 1 Straighten strut, possible? Views: 302 Posted By hkallestad Straighten strut, possible? How hard is the strut metal, is it possible to bend it straight if it's slightly off, while on the boat?

Forum: Engine / Drive Train 05-31-2011, 03:06 PM

Replies: 5 Engine oil and trans fluid change Views: 503 Posted By hkallestad I dont know your exact tranny, but I'm pretty... I dont know your exact tranny, but I'm pretty sure it does not have a filter, old oil out, new oil in. The cooler is just a heat exchanger, it needs to be cleaned now and then, at least the one I...

Forum: Engine / Drive Train 05-30-2011, 05:03 PM

Replies: 5 Engine oil and trans fluid change Views: 503 Posted By hkallestad Get a manual vacum pump, fairly cheap and works... Get a manual vacum pump, fairly cheap and works like a charm. Your engine should have a hose connected to the oil pan, the suction hose on my pump fit perfectly inside that hose, easy money. On the...

Forum: Engine / Drive Train 05-29-2011, 12:16 PM

Replies: 15 Where to buy rebuilt Holley 4160 Carb Views: 1,411 Posted By hkallestad I bought one from national carb and it's working... I bought one from national carb and it's working fine, I guess you can be unlucky too tho. Next time I'll tear it apart myself just for the education;-)

Forum: Engine / Drive Train 05-25-2011, 02:36 PM

Replies: 7 1987 Mastercraft Prostar 190 Oil Change Views: 1,589 Posted By hkallestad I assume it has a 351 engine, if so you should... I assume it has a 351 engine, if so you should use oil with sufficient zink because of the flat tapped cams in this engines(your cam can wear out quickly if not), many modern oils don't have this...

Forum: Engine / Drive Train 05-20-2011, 12:02 PM

Replies: 10 Changing the oil in the Spring Views: 880 Posted By hkallestad Change it when winterizing only. Changing it... Change it when winterizing only. Changing it again when spring comes is overkill, waste of oil and money;-)

Forum: Engine / Drive Train 04-06-2011, 04:50 PM

Replies: 7 Hose Replacement Views: 943 Posted By hkallestad Coulored silicone hoses would be cool, thanks for... Coulored silicone hoses would be cool, thanks for the tip! I prefer a transparent/clear hose from raw water pump, then I see imideately if the pump is pumping water or not when I start the engine.

Forum: General Discussion 03-22-2011, 04:02 PM

Replies: 9 Parks new black x-star, pure porn! Views: 2,184 Posted By hkallestad Parks new black x-star, pure porn! http://www.youtube.com/watch?v=Yl1Wb_y48ms The black one is just pure porn!

Forum: Engine / Drive Train 03-22-2011, 03:46 PM

Replies: 6 Sacrificial Anode Views: 708 Posted By hkallestad Almost on top of my heat exchanger(freshwater... Almost on top of my heat exchanger(freshwater cooling system) there is 3/8" NPT plug looking thing, but inside the plug there's a anode. Like this one: ...

Forum: Engine / Drive Train 03-21-2011, 05:10 PM

Replies: 6 Sacrificial Anode Views: 708 Posted By hkallestad I would check it now and then, the heat exchanger... I would check it now and then, the heat exchanger is not cheap so protecting it is worthwile.

Forum: Engine / Drive Train 10-18-2010, 05:51 PM

Replies: 0 Lost shaft zink anode during season, prop is corroded like f.... Views: 244 Posted By hkallestad Lost shaft zink anode during season, prop is corroded like f.... I keep my prostar in the sea(salt water) all season. When I took it up for the winter now I noticed that the zink anode on the shaft was gone, and the propeller was corroded quite a bit. I havent...

Forum: Engine / Drive Train 09-22-2010, 04:02 PM

Replies: 5 Raw water pump bearings Views: 698 Posted By hkallestad For 9.99 you get good quality bearings, they are... For 9.99 you get good quality bearings, they are a common size bearing so if you pay more than that you probably get ripped off;-) I used SKF bearings in my pump.

Forum: Engine / Drive Train 09-08-2010, 04:46 PM

Replies: 16 Gas smell at idle Views: 1,912 Posted By hkallestad Would the engine run at all at 200 rpm's, and... Would the engine run at all at 200 rpm's, and wouldn't it die wen you put it in gear at such a low rpm? I would check the tach as well. Engine timing check would be a good idea while you're at it too.

Forum: Engine / Drive Train 09-06-2010, 06:46 PM

Replies: 1 88 prostar overheating when going fast?? Views: 292 Posted By hkallestad 170 is normal as far as I know, as long as you... 170 is normal as far as I know, as long as you don't too far above 180 you should be fine. My 89 often go up to 180 right after slowing down.

Forum: Engine / Drive Train 09-03-2010, 05:34 PM

Replies: 9 What kind of carb did PO put on Views: 609 Posted By hkallestad I had a similar automobile carb on mine, maybee... I had a similar automobile carb on mine, maybee the same. Changed to marine carb this season, cant feel any difference in performance really, BUT I'm running safer;-) No more rubber fuel line and all...

Forum: Engine / Drive Train 08-09-2010, 04:03 PM

Replies: 15 Tired 351 Indmar Getting New Life Views: 4,058 Posted By hkallestad Cool project, keep feeding us with loads of... Cool project, keep feeding us with loads of pictures! Did you not compression test the engine before the teardown?

Forum: Engine / Drive Train 08-07-2010, 04:19 AM

Replies: 7 What is this engine? How to find out? Views: 614 Posted By hkallestad Looks like a poweslot by the lenght of the tranny? Looks like a poweslot by the lenght of the tranny?

Forum: Engine / Drive Train 08-06-2010, 02:10 AM

Replies: 29 Time For A Carb Views: 2,557 Posted By hkallestad I bought one from national this winter, been... I bought one from national this winter, been running strong all summer, I haven't read anything negative about these guys.

Forum: General Discussion 08-04-2010, 04:23 PM

Replies: 2 Pole in 89 prostar 190 Views: 301 Posted By hkallestad Pole in 89 prostar 190 I have a 2-piece wakeboarding pole in my 89ps 190. On the lower part of the pole there's 2 holes for heigh adjustment. I'm wondering if it's safe to put a pin in the lower hole to extend the pole....

Forum: Appearance 08-04-2010, 04:12 PM

Replies: 68 87 Prostar 190 Total rebuild Views: 12,346 Posted By hkallestad More pictures!!! :-) More pictures!!! :-)

Forum: Engine / Drive Train 08-04-2010, 03:45 PM

Replies: 8 Prop loose Views: 622 Posted By hkallestad I believe I've read on the forum here that a... I believe I've read on the forum here that a cotter pin is not necessary with a new fresh nylock.

Showing results 1 to 25 of 287

Page 1 of 12 1 2 3 11 > Last »