Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 171
Search took 0.01 seconds.
Search: Posts Made By: BallBushing
Forum: General / Other 09-03-2014, 03:19 PM
Replies: 10
Views: 567
Posted By BallBushing
Need to start with opposite holes, and follow...

Need to start with opposite holes, and follow kind of like a star pattern. Should not end up with three empty holes opposite three filled holes. Don't tighten all the way until they are all in,...
Forum: General Discussion 08-18-2014, 01:58 PM
Replies: 30
Views: 1,766
Posted By BallBushing
Went with the Epic long, had good reviews on...

Went with the Epic long, had good reviews on Amazon. Now I'll have another piece of gear to store during the winter
Forum: Engine / Drive Train 08-15-2014, 03:57 PM
Replies: 507
Important: Fuel Pump 101
Views: 90,964
Posted By BallBushing
Glad you found the part, now clean the top of...

Glad you found the part, now clean the top of your fuel pump assembly.
Forum: General Discussion 08-15-2014, 03:46 PM
Replies: 19
Views: 893
Posted By BallBushing
Check the yellow electrical connection on top of...

Check the yellow electrical connection on top of the fuel pump assembly. Pull apart, clean & put together. Try jiggling if the engine dies. Also check the two crank position sensors (under the...
Forum: General Discussion 08-13-2014, 08:55 AM
Replies: 18
Views: 985
Posted By BallBushing
He turned LEFT to pick up the skier, assuming...

He turned LEFT to pick up the skier, assuming he'll pick him up on the drivers side a figure 8 is required. First he loses sight of the skier and has a chance he'll run over the rope. I always turn...
Forum: Off Topic Discussion 08-13-2014, 08:36 AM
Replies: 9
Views: 1,209
Posted By BallBushing
Been using the shaker for two years now. Works...

Been using the shaker for two years now. Works great, may need to replace the hose (getting stiff) but a quick trip to Ace Hardware for new hose and I'll be good to go.
Forum: Engine / Drive Train 08-06-2014, 09:07 PM
Replies: 12
Views: 565
Posted By BallBushing
Curver, How did you adjust the inside holding...

Curver, How did you adjust the inside holding plastic? Just put new screw holes (lower) in the canister?
Forum: Engine / Drive Train 08-06-2014, 08:49 AM
Replies: 12
Views: 565
Posted By BallBushing
Here's the best source I found for a replacement...

Here's the best source I found for a replacement Carter 52018056. IF... you live in Poland ...
Forum: Engine / Drive Train 08-06-2014, 08:12 AM
Replies: 12
Views: 565
Posted By BallBushing
1999 Maristar 210 VRS with the 330 LTR here. ...

1999 Maristar 210 VRS with the 330 LTR here. Went through this exercise 2 years ago. Bought the the Airtex E2044 everyone uses and as you discovered it was much smaller than the original Carter...
Forum: Towers 07-15-2014, 01:24 PM
Replies: 8
Views: 483
Posted By BallBushing
To be more exact: Diameter =...

To be more exact: Diameter = Circumference/3.14159265358979323846264338327950288419716939937510
58209749445923078164062862089986280348253421170679
...
Forum: General Discussion 07-14-2014, 07:51 PM
Replies: 15
Views: 538
Posted By BallBushing
Ditto on the crank shaft sensors like BCD wrote. ...

Ditto on the crank shaft sensors like BCD wrote. Was the cause of my no start after working great all day. Pull, clean and put back. So far, so good.
Forum: Electrical 07-10-2014, 03:26 PM
Replies: 7
Views: 407
Posted By BallBushing
Same problem here '99 210 VRS. Used my daughters...

Same problem here '99 210 VRS. Used my daughters hair tie for a year to keep the connection together. Finally bought the harness from Rambo Marine p/n 508436. $31.30 + $13.95 shipping in July 2012. ...
Forum: Engine / Drive Train 07-08-2014, 08:45 AM
Replies: 29
Views: 924
Posted By BallBushing
6203 2RS, has seals on both sides. The most...

6203 2RS, has seals on both sides. The most common size produced in the world

Any bearing distributor has them. Motion Industries, Applied Industrial Technologies, Kaman Corporation. They are all...
Forum: Engine / Drive Train 07-08-2014, 08:37 AM
Replies: 8
Views: 403
Posted By BallBushing
Same boat here, but LTR Check the yellow...

Same boat here, but LTR

Check the yellow electrical connection on top of the fuel pump, mine caused the same intermittent problem. Replaced the harness and solved the problem.

Also, ditto on...
Forum: General Discussion 06-11-2014, 10:50 AM
Replies: 52
Views: 2,987
Posted By BallBushing
Thanks for the discount code. Ordered a 32 oz....

Thanks for the discount code. Ordered a 32 oz. bottle.
Forum: Off Topic Discussion 06-05-2014, 04:56 PM
Replies: 11
Views: 849
Posted By BallBushing
How do you move an 80' yacht from KY to IL? Is...

How do you move an 80' yacht from KY to IL? Is there a waterway?
Forum: Off Topic Discussion 05-24-2014, 10:55 AM
Replies: 42
Views: 2,770
Posted By BallBushing
It's very simple Q in > Q out = weight gain Q...

It's very simple
Q in > Q out = weight gain
Q in < Q out = weight loss
Q in = Q out = no change
Forum: General / Other 04-21-2014, 08:50 PM
Replies: 8
Views: 588
Posted By BallBushing
https://www.superbrightleds.com/cat/festoon/ Fest...

https://www.superbrightleds.com/cat/festoon/

Festoon bulbs, think mine were 6 or 8 LEDs/bulb, Buy the bulb holders, solder on some leads attach to boat and splice the pos & neg terminals. You can...
Forum: General / Other 04-17-2014, 09:59 AM
Replies: 8
Views: 588
Posted By BallBushing
White lights, most likely burnt out so you didn't...

White lights, most likely burnt out so you didn't notice them. Two on both port & starboard sides. Replaced mine with LED's of the same size. Easy job
Forum: General Discussion 03-11-2014, 07:56 PM
Replies: 38
Views: 1,795
Posted By BallBushing
4 page thread now, do I hear 5

4 page thread now, do I hear 5
Forum: General Discussion 02-18-2014, 11:25 AM
Replies: 169
Views: 24,721
Posted By BallBushing
I have that siphon, works great, recommend it

I have that siphon, works great, recommend it
Forum: Off Topic Discussion 10-14-2013, 10:08 PM
Replies: 5,315
Views: 725,282
Posted By BallBushing
BSME here, was a good choice. All the best for...

BSME here, was a good choice. All the best for your son
Forum: Tow Vehicles 10-14-2013, 10:00 PM
Replies: 16
Views: 1,922
Posted By BallBushing
Don't do anything for 6 months. Live with it for...

Don't do anything for 6 months. Live with it for a while. From experience, having my son drop a baseball bat on the front fender of my 528i, I got over it and used the dent as a learning experience...
Forum: General Discussion 10-11-2013, 08:19 AM
Replies: 26
Views: 2,424
Posted By BallBushing
All the complaints and come election time the...

All the complaints and come election time the incumbents will get re elected.
Forum: General Discussion 09-25-2013, 02:43 PM
Replies: 7
Views: 1,143
Posted By BallBushing
Put the battery in today. Fired up & voltmeter...

Put the battery in today. Fired up & voltmeter works. However looks like I cooked a cell in the battery, only putting out 10 volts. Current is good, 950 amp on a battery rated at 850. New battery...
Showing results 1 to 25 of 171

 

All times are GMT -4. The time now is 10:26 PM.