Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.28 seconds.
Search: Posts Made By: mtajpa
Forum: Electrical 07-21-2016, 02:33 AM
Replies: 9
Views: 377
Posted By mtajpa
Look on page 3 of 18 of the attached. It should...

Look on page 3 of 18 of the attached. It should help.
Forum: General Discussion 07-15-2016, 10:05 PM
Replies: 4,184
Views: 571,476
Posted By mtajpa
Please somebody wake up. Vacations on LOTO are...

Please somebody wake up. Vacations on LOTO are not for sleeping in.
Forum: Trailers 07-15-2016, 10:00 PM
Replies: 14
Views: 773
Posted By mtajpa
Be sure to use stainless steel staples.

Be sure to use stainless steel staples.
Forum: Upholstery 07-15-2016, 09:54 PM
Replies: 10
Views: 718
Posted By mtajpa
Corinthians Marine carpet has Carpet Specials all...

Corinthians Marine carpet has Carpet Specials all the time. I found a 34 x 8.5 for 250 and got free shipping some how. Had it shipped to a local dealer. The second order 8.5 x 11 I found a special...
Forum: Upholstery 07-14-2016, 08:15 PM
Replies: 10
Views: 718
Posted By mtajpa
Well it took a little longer than 10 days in fact...

Well it took a little longer than 10 days in fact I had to cut short my LOTO trip by a couple of days only got to spend 2 1/2 weeks instead of 3. I think it came out pretty nice. Thanks to my wife...
Forum: General / Other 06-23-2016, 10:26 PM
Replies: 2
Views: 232
Posted By mtajpa
Mine is a 230 Maristar and I had to remove the...

Mine is a 230 Maristar and I had to remove the center seat section as the floor is underneath that section. Then lift up on the outer sections a bit. The it will slid out. It was not easy to come...
Forum: Electrical 06-21-2016, 12:43 AM
Replies: 8
Views: 233
Posted By mtajpa
Here is a schematic of the ignition system. All...

Here is a schematic of the ignition system. All it says is 121 WHT from pin B on the ignition control module.
Forum: Engine / Drive Train 06-08-2016, 09:21 PM
Replies: 42
Views: 1,403
Posted By mtajpa
Get a fuel pressure gauge and then you will be...

Get a fuel pressure gauge and then you will be able to test fuel pressure at key on, idle, and Wot. Mine is about 60psi. You could also check the connector at the pump and feel if it getting hot....
Forum: Upholstery 06-08-2016, 09:06 PM
Replies: 10
Views: 718
Posted By mtajpa
With temp's in the 100's and no wind. Me and my...

With temp's in the 100's and no wind. Me and my crew will have to spend our days like this. Hope the process goes smoothly with good results.
Forum: Wakesurfing 06-08-2016, 08:50 PM
Replies: 1,373
Views: 249,153
Posted By mtajpa
Beer shelf?

Beer shelf?
Forum: Upholstery 06-08-2016, 08:48 PM
Replies: 10
Views: 718
Posted By mtajpa
Here is a test run on the embroidery for the...

Here is a test run on the embroidery for the seats. Will have the MasterCraft on the drivers and passengers seat along with the rear bench. Sticking with same colors. EMB. is not going to be teal, it...
Forum: Upholstery 06-08-2016, 08:41 PM
Replies: 10
Views: 718
Posted By mtajpa
Maristar Interior makeover

:popcorn: Upholstery and carpet have finally got to go. Have a guy that did a friends boat and came out great. Dropped boat off on Sat. He said 10 days. Hope he's right as I leave with it for LOTO...
Forum: Engine / Drive Train 06-04-2016, 12:09 AM
Replies: 6
Views: 308
Posted By mtajpa
Possibly clean your injectors. I did this by...

Possibly clean your injectors. I did this by removing the injectors and using carb cleaner to fill the injector let it soak, pressurize with 125psi from compressor then connect 12 volts to injector...
Forum: Electrical 06-04-2016, 12:03 AM
Replies: 3
Views: 272
Posted By mtajpa
Did you try pressing the RED breaker reset in the...

Did you try pressing the RED breaker reset in the engine compartment?
Forum: Engine / Drive Train 05-26-2016, 07:04 PM
Replies: 47
Views: 1,353
Posted By mtajpa
You can remove the center floor section. The rear...

You can remove the center floor section. The rear of the center section sits under the rear seat base so you will have to lift the front of the floor section and slide it forward.

Remove the screws...
Forum: Electrical 05-19-2016, 08:11 PM
Replies: 12
Views: 426
Posted By mtajpa
I put a clamp around mine, Never had an issue....

I put a clamp around mine, Never had an issue. There is also a flat connector towards the front on that same loom of wire. See picture of trans the connector is in the upper left corner. This...
Forum: General Discussion 05-15-2016, 07:19 PM
Replies: 120
Views: 7,133
Posted By mtajpa
Very Nice. Dumont Dunes in the background? Were...

Very Nice. Dumont Dunes in the background? Were did you pick it up?
Forum: Towers 04-30-2016, 10:08 AM
Replies: 1,170
Views: 181,112
Posted By mtajpa
Another Prostar violated.:( For sale on...

Another Prostar violated.:( For sale on craigslist in Vegas.

Sorry I posted this in the second thread. Still on Craigslist but has a fresh coat of black paint on this lovely tower.
Forum: Engine / Drive Train 04-18-2016, 08:03 PM
Replies: 23
Views: 807
Posted By mtajpa
With all the discussion I think I'll go with...

With all the discussion I think I'll go with regular hardware with anti-sieze instead. Still waiting on the gaskets from SKIDIM.

Anyone use any sealant with the gaskets?
Forum: Engine / Drive Train 04-17-2016, 06:37 PM
Replies: 4
Views: 278
Posted By mtajpa
I think tightening it actually opens it to drain....

I think tightening it actually opens it to drain. Loosening closes the drain. Should have them on both side I believe. Typically they would be left open during the winter unless it was filled with...
Forum: General / Other 04-17-2016, 06:31 PM
Replies: 6,614
Views: 831,530
Posted By mtajpa
Riser Cleaning with evaporust. Thanks Mike

Riser Cleaning with evaporust. Thanks Mike
Forum: Engine / Drive Train 04-17-2016, 06:27 PM
Replies: 23
Views: 807
Posted By mtajpa
I went with stainless and lock washers

I went with stainless and lock washers
Forum: Electrical 04-17-2016, 06:26 PM
Replies: 32
Views: 2,263
Posted By mtajpa
Like Frank said it is a 6 pole switch. Pictures...

Like Frank said it is a 6 pole switch. Pictures are from my 1999 230 Sport Model. The wiring diagram should answer your questions.

The first diagram or top is with the switch in the raise position...
Forum: What is this boat worth? 04-13-2016, 11:54 PM
Replies: 12
Views: 1,325
Posted By mtajpa
Boulder Boats in Nevada has the same boat however...

Boulder Boats in Nevada has the same boat however it has built in ballast, heater,PPass, FA Exhaust, oversized bimini. They are asking 27k. Seems high but they are a boat dealer. Good to compare the...
Forum: Engine / Drive Train 04-10-2016, 10:09 AM
Replies: 21
Views: 1,463
Posted By mtajpa
How did the old circ. pump look? Pics? Was the...

How did the old circ. pump look? Pics? Was the circ. pump impeller stainless or just rusted steel? Maybe previous owner put in an automotive brand. Mine is still original pump and I have noticed...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 10:10 AM.