Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 53
Search took 0.02 seconds.
Search: Posts Made By: jchance
Forum: Towers 09-21-2016, 08:57 AM
Replies: 4
Views: 397
Posted By jchance
Original Zeroflex tower

Mine is the original on a 2001 Maristar. The pads under the tower legs are worn out. What is best or where can I find something thick enough and heavy duty enough to use in their place? Thanks!
Forum: Electrical 09-19-2016, 03:17 PM
Replies: 2
Views: 173
Posted By jchance
Digital to Analog swap or other Dashboard work......

To all those who have had to work inside their dashboards, I have a question. I am swapping over to analog gauges since my 15 year old ones are beginning to flake out. It is a 2001 Maristar 210VRS....
Forum: Electrical 07-28-2016, 09:34 PM
Replies: 42
Views: 2,511
Posted By jchance
lakedawg--Did you ever figure out the fuel sender...

lakedawg--Did you ever figure out the fuel sender issue? I have a 2001 Maristar 210 VRS and am thinking about moving to analog.
Forum: Engine / Drive Train 06-23-2016, 11:50 PM
Replies: 2
Views: 206
Posted By jchance
LT-1 versus LT-R

Can anyone really answer this question in detail?? I have a 2001 210 with a LT-R 330 hp Indmar engine. When I check the Internet, almost all postings are for the LT-1 engine. What are the...
Forum: Electrical 06-23-2016, 11:44 PM
Replies: 8
Views: 323
Posted By jchance
PerfectPass speedo reading is from the paddle...

PerfectPass speedo reading is from the paddle wheel sensor while gauge is speedo water pick-up, if you use one. I agree that the schematic is for analog gauges. Mine is one of the early generation...
Forum: Electrical 06-21-2016, 12:06 AM
Replies: 8
Views: 323
Posted By jchance
2001 Maristar V210 w/330hp--no tach

I have a 2001 V210 Maristar with an Indmar 330hp engine. It runs great without any issues. All of the gauges boot up and run through the start-up routine. My problem is one with the tach. As I run...
Forum: General Discussion 10-30-2015, 11:19 AM
Replies: 22
Views: 1,451
Posted By jchance
Use one on a trolley system. Works great!

Use one on a trolley system. Works great!
Forum: Engine / Drive Train 05-16-2015, 11:25 PM
Replies: 1
Views: 332
Posted By jchance
Anyone help with O-ring size for rudder?

Anyone know what size O-rings go on the rudder of a 2001 Maristar 210VRS? Mine leaks a slow stream. I'd like to have new O-rings in hand to swap out and see if that solves my leak. Anyone know what...
Forum: General / Other 04-24-2015, 11:43 AM
Replies: 12
Views: 1,246
Posted By jchance
Most NON-Electrical engine parts are standard...

Most NON-Electrical engine parts are standard engine. Water pump is partially stainless and electrical parts have to be Coast Guard spec for sparks.
Forum: Engine / Drive Train 02-04-2015, 04:36 PM
Replies: 4
Views: 848
Posted By jchance
Swap the cable and don't look back. Not a hard...

Swap the cable and don't look back. Not a hard job but do it with an empty gas tank. SkiDim has the part.
Forum: Engine / Drive Train 02-04-2015, 09:07 AM
Replies: 5
Views: 804
Posted By jchance
Ordinarily I would agree with you but the fact...

Ordinarily I would agree with you but the fact that it is on the high side of the water pump and that makes it look like it is reverse flow. Also, the reason I'm doing this is not to just winterized...
Forum: Storage / Winterization 02-03-2015, 05:45 PM
Replies: 0
Views: 510
Posted By jchance
Which way does the water flow?

I am retrofitting my LTR to make it easier to winterize. It also has a ballast and heat system. I want to flush the heater with antifreeze via the shower pump. My question is which way does the...
Forum: Engine / Drive Train 02-03-2015, 05:44 PM
Replies: 5
Views: 804
Posted By jchance
Question about coolant flow

I am retrofitting my LTR to make it easier to winterize. It also has a ballast and heat system. I want to flush the heater with antifreeze via the shower pump. My question is which way does the...
Forum: Audio/Stereo 01-26-2015, 11:55 AM
Replies: 1
Views: 891
Posted By jchance
Skylon Defcon 3 tower speakers to new amplifiers

I am getting rid of the Clarion amps that I was using for my boat and going with newer Class D amps from JL Audio. I have a pair of Defcon 3's with 2 pairs of Kicker 6.2's on each can. They are...
Forum: Engine / Drive Train 01-02-2015, 10:19 AM
Replies: 13
Views: 2,342
Posted By jchance
SkiDim is a good source for info on both of these...

SkiDim is a good source for info on both of these jobs. Both can be done yourself or relatively easy by the dealer. Pulling the engine is NOT necessary for either, but 2 people are required for both....
Forum: Engine / Drive Train 01-02-2015, 02:25 AM
Replies: 13
Views: 2,342
Posted By jchance
Is it the seal on the shaft that goes through the...

Is it the seal on the shaft that goes through the hull to the prop? You do not have to pull the engine but certainly need 2 people and the special short wrenches from SkiDim. It is a real PITA...
Forum: Storage / Winterization 10-08-2014, 05:23 PM
Replies: 8
Views: 1,703
Posted By jchance
Where did you find the rest of the instructions?

Where did you find the rest of the instructions?
Forum: Engine / Drive Train 09-10-2014, 11:27 AM
Replies: 5
Views: 537
Posted By jchance
Manual states do not screw in.

Manual states do not screw in.
Forum: Ballast 07-03-2014, 02:14 PM
Replies: 1
Views: 740
Posted By jchance
Length of 1/2" PVC pipe to hold it open...

Length of 1/2" PVC pipe to hold it open longwise
Forum: Audio/Stereo 06-11-2014, 09:42 AM
Replies: 1
Views: 424
Posted By jchance
Need cooler running amp suggestions

2001 Maristar with 4 JL speakers and sub in the boat and 4 Kicker cans on the tower. They are currently powered by 2 of the original Clarion amps. Sounds good but 1 amp clips frequently; not to...
Forum: General Discussion 06-10-2014, 10:45 AM
Replies: 2
Views: 392
Posted By jchance
Help with getting floor up to remove gas tank to replace steering cable

I need to replace my cable in my 2001 Maristar v210. It is a V-drive. We can get the cable loose at both ends but it appears to be stuck under the gas tank. We can get all of the floor access panels...
Forum: General / Other 06-10-2014, 10:43 AM
Replies: 0
Views: 255
Posted By jchance
Help with steering cable/floor removal issue

I need to replace my cable in my 2001 Maristar v210. It is a V-drive. We can get the cable loose at both ends but it appears to be stuck under the gas tank. We can get all of the floor access...
Forum: Upholstery 12-02-2013, 11:01 AM
Replies: 7
Views: 2,051
Posted By jchance
Just for those who still are having the problem,...

Just for those who still are having the problem, stainless steel through bolting works better than trying to replace the inserts.
Forum: Trailers 05-02-2013, 10:35 AM
Replies: 47
Views: 5,306
Posted By jchance
OK, I spoke with several dealers in the area and...

OK, I spoke with several dealers in the area and got quotes from $85 to $130 per tire plus mount/balance.

I then spoke with a good friend who owns a large tire dealership and also is a...
Forum: Engine / Drive Train 04-23-2013, 10:28 AM
Replies: 7
Views: 2,236
Posted By jchance
I'vebeen under there and have had everything...

I'vebeen under there and have had everything loose. We tried to tighten the nut to see if we could get the steady stream back to a few drops but it is just too old and needs to be replaced at this...
Showing results 1 to 25 of 53

 

All times are GMT -4. The time now is 04:44 PM.