Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: Hrkdrivr
Forum: Engine / Drive Train 07-28-2014, 07:11 PM
Replies: 8
Views: 919
Posted By Hrkdrivr
I put the boat on the market for sale. I didn't...

I put the boat on the market for sale. I didn't have time to just change the pressure regulator and the service department wasn't allowed by MC to change just that part; they were required to change...
Forum: For Sale: Boats 06-28-2014, 04:28 PM
Replies: 28
Views: 1,121
Posted By Hrkdrivr
I just listed my '06 X-45 with the 8.1 engine for...

I just listed my '06 X-45 with the 8.1 engine for consignment sale here: ...
Forum: Engine / Drive Train 08-04-2013, 04:47 PM
Replies: 8
Views: 919
Posted By Hrkdrivr
Mark After replacing the pump, the issue is NOT...

Mark

After replacing the pump, the issue is NOT resolved. Sigh. Fuel pressures are erratic in the mid-RPM ranges. After a couple hours of pulling boarders, the engine starts to surge when trying...
Forum: Engine / Drive Train 07-29-2013, 10:50 PM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
If you have a new filter/gasket, use them, but if...

If you have a new filter/gasket, use them, but if all you have for now is the old ones and if they're clean I would go ahead and use them.




I disconnected the batteries before I messed with the...
Forum: Engine / Drive Train 07-25-2013, 09:39 AM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
I replaced mine because most of the rubber...

I replaced mine because most of the rubber washers were ruined, and I lost one...but you could probably just replace the rubber washers.

When I ordered a new fuel filter, it came with a new big...
Forum: Engine / Drive Train 07-25-2013, 09:34 AM
Replies: 11
Views: 986
Posted By Hrkdrivr
Same motor in an X-45. I use a K&N wrench-off...

Same motor in an X-45. I use a K&N wrench-off oil filter since I've had a hard time with strap wrenches in the tight workspace.
Forum: Engine / Drive Train 07-22-2013, 10:32 PM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
I did. I even photographed the module before...

I did. I even photographed the module before removal and then used the photo as a reference to align when I re-installed. (Fuel pump module, not level-sender)
Forum: Appearance 07-22-2013, 09:45 AM
Replies: 29
Views: 2,413
Posted By Hrkdrivr
Man that's a pretty boat! Sometimes less is...

Man that's a pretty boat! Sometimes less is more.

Think about it this way...those of us who know, will know it's an MC with or without decals; those who don't know don't appreciate what they're...
Forum: Trailers 07-22-2013, 09:42 AM
Replies: 12
Views: 887
Posted By Hrkdrivr
Nice work...sorry! Welcome to the club! Glad...

Nice work...sorry! Welcome to the club! Glad nobody got hurt...

What kind of tire?
Forum: Engine / Drive Train 07-22-2013, 09:40 AM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
Anybody have a really hard time getting the...

Anybody have a really hard time getting the cap-head screws to thread in?

For me it was like the threaded female receptacles embedded into the tank were just a little out of place, or the tank had...
Forum: General / Other 07-22-2013, 09:34 AM
Replies: 32
Views: 4,544
Posted By Hrkdrivr
Bungee55, wow! Amazing piece of engineering,...

Bungee55, wow! Amazing piece of engineering, but, wow!

Who fabricated the piece? Did it work?
Forum: General / Other 07-22-2013, 09:32 AM
Replies: 32
Views: 4,544
Posted By Hrkdrivr
duplicate post

duplicate post
Forum: Engine / Drive Train 07-19-2013, 07:00 PM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
You can see the mystery thing in this pic (right...

You can see the mystery thing in this pic (right side). Also, even though this is an '06 boat, it has the corrugated hose, which I was able to reuse with new hose clamps. You can also see the...
Forum: Engine / Drive Train 07-19-2013, 06:55 PM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
Anybody have one of these at the bottom of their module?

This looks like another filter element inside the canister. It's all the way at the bottom and the pump intake nozzle plugs down into the middle of it. It has two diaphragm-like valve things on the...
Forum: Engine / Drive Train 07-16-2013, 10:56 PM
Replies: 8
Views: 919
Posted By Hrkdrivr
I just pulled the fuel module. I replaced the...

I just pulled the fuel module. I replaced the pump with a new Airtex. New filter should be here tomorrow and I'll be able to reinstall everything and check it out.

No comments on what the fuel...
Forum: Engine / Drive Train 07-12-2013, 11:50 PM
Replies: 8
Views: 919
Posted By Hrkdrivr
Fuel pump? Fuel pressure regulator? Both?

Last Friday the engine was surging with a boarder on the rope and RPM around 2,800. Surges were +/- 200-300 rpm. You could hear it and feel it. It happened both on cruise control and when using...
Forum: Engine / Drive Train 07-09-2013, 10:05 PM
Replies: 460
Views: 80,422
Posted By Hrkdrivr
Asked on another thread, but does anyone know the...

Asked on another thread, but does anyone know the Airtex/Walbro/AC Delco/Bosch pump part number for an L-18 engine? I picked up an Airtex E2065 at Advance Auto and was wondering if it's...
Forum: Engine / Drive Train 07-09-2013, 07:00 PM
Replies: 10
Views: 2,473
Posted By Hrkdrivr
That explains a lot...thanks! And you're right,...

That explains a lot...thanks! And you're right, my pump is submerged like the fuel pump 101 thread



Will do. Any idea on the part number/model number to replace it? (I will go back over the...
Forum: Engine / Drive Train 07-08-2013, 11:28 PM
Replies: 10
Views: 2,473
Posted By Hrkdrivr
I found some pictures on the "Fuel Pump 101"...

I found some pictures on the "Fuel Pump 101" thread here:

http://www.mastercraft.com/teamtalk/showthread.php?t=25783&highlight=fuel+pump

The "brass fitting, inlet side" you mention ("clean the...
Forum: Engine / Drive Train 07-08-2013, 09:13 PM
Replies: 10
Views: 2,473
Posted By Hrkdrivr
Bump...anyone have pics?

Bump...anyone have pics?
Forum: Engine / Drive Train 07-06-2013, 03:28 PM
Replies: 10
Views: 2,473
Posted By Hrkdrivr
Tateau18 and Andre, do either of you have...

Tateau18 and Andre, do either of you have pictures of how to check that filter?

I had the same issues yesterday on our '06 X-45/L18. I was going to post a video, but it's exactly like the viedo...
Forum: MasterCraft In Your Area 05-27-2013, 10:28 PM
Replies: 5
Views: 1,446
Posted By Hrkdrivr
Now it takes me to a whole other site... ...

Now it takes me to a whole other site... http://afwake.com/
Forum: Off Topic Discussion 11-18-2012, 10:11 PM
Replies: 238
Views: 14,088
Posted By Hrkdrivr
Is the pocket clip on the Kel-Tec aftermarket or...

Is the pocket clip on the Kel-Tec aftermarket or did it come with the gun? That would be handy on an LCP. I bet it could be adapted to a number of guns. Neat idea.
Forum: Off Topic Discussion 11-18-2012, 10:05 PM
Replies: 238
Views: 14,088
Posted By Hrkdrivr
My new CC piece...

Springfield XDS .45...LOVE it!

Previous carry gun was an LCP .380. Tried an XDM .40 (4.5") but it was too heavy and bulky.
Forum: Upholstery 08-03-2012, 07:56 AM
Replies: 75
Views: 13,613
Posted By Hrkdrivr
That is, hands down, the sharpest interior re-do...

That is, hands down, the sharpest interior re-do I've seen! Wow. Congrats!
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 06:01 PM.