Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: MattsCraft
Forum: Find A Pull / Give a Pull 07-22-2016, 09:49 AM
Replies: 2
Views: 111
Posted By MattsCraft
OMG - I just got back from there yesterday - Wish...

OMG - I just got back from there yesterday - Wish I would have known, of course can't help with a ski pull, but certainly would have helped drink some Captain with ya!:(
Forum: General Discussion 07-22-2016, 09:46 AM
Replies: 5
Views: 363
Posted By MattsCraft
So I am not 100% sure on 2010 version, however it...

So I am not 100% sure on 2010 version, however it it helps on my 2013, I find using the profile to fill and empty works best. Make sure your 3 switch's are not activated also.

I have each profile...
Forum: MasterCraft In Your Area 07-22-2016, 09:31 AM
Replies: 124
Views: 4,474
Posted By MattsCraft
No way big boy - I am campaigning as we speak and...

No way big boy - I am campaigning as we speak and have deeper pockets than you!:rolleyes:
Forum: General Discussion 07-22-2016, 09:29 AM
Replies: 66
Views: 4,955
Posted By MattsCraft
OMG - That is just painful to look at. Man O...

OMG - That is just painful to look at. Man O Man:confused::confused::confused:
Forum: MasterCraft In Your Area 07-20-2016, 07:26 AM
Replies: 124
Views: 4,474
Posted By MattsCraft
Sneak Peek - Going for Top Tow Rig this...

Sneak Peek - Going for Top Tow Rig this year:rolleyes::rolleyes::rolleyes: Hopefully get all the Bling done in time:D:D:D
Forum: General Discussion 07-20-2016, 07:19 AM
Replies: 20
Views: 571
Posted By MattsCraft
Sounds like he has a seadeck pad - I have the...

Sounds like he has a seadeck pad - I have the same issue, look forward to a solution.

I'm thinking bleach, but don't want to change the color:confused::confused::confused:
Forum: MasterCraft In Your Area 07-18-2016, 08:08 AM
Replies: 124
Views: 4,474
Posted By MattsCraft
Ohhh - A hit below the belt - LOL

Ohhh - A hit below the belt - LOL
Forum: General Discussion 07-14-2016, 08:45 AM
Replies: 5
Views: 264
Posted By MattsCraft
The Ilmors run a lot cooler than the Indmars:D ...

The Ilmors run a lot cooler than the Indmars:D The thermostat is at 140 degrees, this is a good thing, unless you have a heater:rolleyes: My MCX was 160, and on a hot day, at idle speed would climb...
Forum: General Discussion 07-13-2016, 04:42 PM
Replies: 2
Views: 133
Posted By MattsCraft
Every system on the new boats runs off of the...

Every system on the new boats runs off of the house Batt. I had voltage issues on a standard size Batt after only 1 year of life, and all my Batts are on a float charger when not in use.

I think...
Forum: General Discussion 07-13-2016, 08:35 AM
Replies: 24
Views: 965
Posted By MattsCraft
Z - I had an '09 X2 - That is '09 vinyl - The...

Z - I had an '09 X2 - That is '09 vinyl - The Blue will get hot in the sun, had the same color in my boat.
Forum: Trailers 07-12-2016, 04:51 PM
Replies: 15
Views: 3,144
Posted By MattsCraft
See this post for the service...

See this post for the service bulletin.:D

http://www.mastercraft.com/teamtalk/showthread.php?t=66806
Forum: MasterCraft In Your Area 07-12-2016, 10:42 AM
Replies: 124
Views: 4,474
Posted By MattsCraft
I am sure your neighbors will love that:rolleyes:

I am sure your neighbors will love that:rolleyes:
Forum: Underwater Running Gear 07-12-2016, 10:39 AM
Replies: 5
Views: 209
Posted By MattsCraft
I'm pretty sure you should have a Lenco electric...

I'm pretty sure you should have a Lenco electric actuator. Remove the pin from the tab and let it drop down. Remove the 3 screws from the top of the actuator, there will be a rubber gasket, inside,...
Forum: Underwater Running Gear 07-12-2016, 08:51 AM
Replies: 5
Views: 209
Posted By MattsCraft
Most likely a bad actuator - Remove it & bench...

Most likely a bad actuator - Remove it & bench test first would be my recommendation.
Forum: General Discussion 07-08-2016, 10:40 AM
Replies: 288
Views: 18,722
Posted By MattsCraft
^^^^ Ditto - oh my, would not to be that...

^^^^ Ditto - oh my, would not to be that guy:rolleyes:
Forum: MasterCraft In Your Area 06-21-2016, 09:36 AM
Replies: 124
Views: 4,474
Posted By MattsCraft
We, of course are in!!!:rolleyes::);):D:D:D

We, of course are in!!!:rolleyes::);):D:D:D
Forum: General Discussion 06-10-2016, 07:40 AM
Replies: 8
Views: 662
Posted By MattsCraft
What everyone else said - 1200-1500 gives plenty...

What everyone else said - 1200-1500 gives plenty of juice to the pumps.

Assuming your boat fills & drains from the bottom - I find that sitting still is best to fill and in motion to empty.
Forum: Off Topic Discussion 06-10-2016, 07:32 AM
Replies: 17
Views: 859
Posted By MattsCraft
With all your money go with Bose, expensive but...

With all your money go with Bose, expensive but once you go Bose, you will never go back - lol.
Forum: General Discussion 06-10-2016, 07:28 AM
Replies: 57
Views: 5,506
Posted By MattsCraft
List the boat - KGB-Full - As much weight as you...

List the boat - KGB-Full - As much weight as you can on the surf side - Stock +600 on surf side - 11.2 MPH - opposite tab 100% - Center tab 40-60%
Forum: General / Other 05-28-2016, 09:53 AM
Replies: 16
Views: 645
Posted By MattsCraft
OK - If you care to read on and some good info...

OK - If you care to read on and some good info attached - Johnson Impeller's are either Nitrile or Neoprene. Also, from WD40...
Forum: General / Other 05-26-2016, 03:45 PM
Replies: 16
Views: 645
Posted By MattsCraft
Agree to disagree- impellers are not rubber &...

Agree to disagree- impellers are not rubber & WD-40 will have no adverse effect one- Two, I replace mine every year use the same method for 10 years, old one that comes out is saved as a spare and...
Forum: General / Other 05-25-2016, 09:39 AM
Replies: 16
Views: 645
Posted By MattsCraft
Remove the hose clamp that is in the way, remove...

Remove the hose clamp that is in the way, remove the 4 screws for the cover. There is a rubber gasket, should get a new one with the new impeller. Spray is some WD-40, with the push button start,...
Forum: General Discussion 05-24-2016, 01:06 AM
Replies: 18
Views: 782
Posted By MattsCraft
He is an old man now - When he was 18 maybe, now...

He is an old man now - When he was 18 maybe, now he is just like me, won't get in until water is 75:rolleyes:
Forum: General Discussion 05-23-2016, 12:12 PM
Replies: 18
Views: 782
Posted By MattsCraft
Ha, ha - I should have used the pic from the port...

Ha, ha - I should have used the pic from the port side, no sacrificial anode on that one, lol.

At the end of the day, we achieved exactly what we were looking for, taller wave, even weighting and...
Forum: General Discussion 05-23-2016, 11:16 AM
Replies: 18
Views: 782
Posted By MattsCraft
Done & done - Not sure why you think they came of...

Done & done - Not sure why you think they came of an SS boat. I can't reveal where they came from8p
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 10:44 AM.