Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 194
Search took 0.01 seconds.
Search: Posts Made By: 2010Prostar197
Forum: General Discussion Yesterday, 11:09 AM
Replies: 30
Views: 3,157
Posted By 2010Prostar197
Reliable to UFP Actuator Retrofit Now Available

I believe it was around 400 shipped for both the new tongue and inner member for dual discs. Somehow 169 for the new tongue rings a bell. (Been a year and a half since I did it). Both pieces are...
Forum: Engine / Drive Train 07-27-2014, 03:54 PM
Replies: 16
Views: 641
Posted By 2010Prostar197
Do they have replacement u-joints or is it just a...

Do they have replacement u-joints or is it just a complete assembly???
Forum: Engine / Drive Train 07-26-2014, 01:46 AM
Replies: 8
Views: 285
Posted By 2010Prostar197
Good question. Many have been converted to the...

Good question. Many have been converted to the newer style. Either that or he has a hose leaking and a big hole in the bottom of the boat. 😀
Forum: Engine / Drive Train 07-26-2014, 12:15 AM
Replies: 8
Views: 285
Posted By 2010Prostar197
Water from shaft?

Old style packing equals no water. New style "dripless" has a steady stream from under the boat where the shaft exits. Look to see if you have a 3/8 inch hose going from the engine to where the...
Forum: Engine / Drive Train 07-25-2014, 12:52 PM
Replies: 18
Views: 453
Posted By 2010Prostar197
Engine Noise 2010 X15 MCX

Have you by chance tried a stethoscope (Harbor Freight?) and tried to localize it??

Many years ago our Supra with a PCM engine had a similar noise which ended up being the impeller inside of the...
Forum: Engine / Drive Train 07-24-2014, 09:47 PM
Replies: 3
Views: 156
Posted By 2010Prostar197
Transmission not engaging

Did the shaft disengage because a nut backed out??

Worn strut bearings shouldn't make the shaft disengage should it?
Forum: Trailers 07-24-2014, 04:46 PM
Replies: 8
Views: 243
Posted By 2010Prostar197
I think 1/8 npt Take the part you have in with...

I think 1/8 npt

Take the part you have in with you. The local Napa store here has the brass ones. Standard part but you can get them in steel or brass. Kodiak carries the brass ones. I believe...
Forum: Trailers 07-24-2014, 03:42 PM
Replies: 8
Views: 243
Posted By 2010Prostar197
I'm trying to think why someone would take 4 of...

I'm trying to think why someone would take 4 of the fittings off to start with?

Either way the calipers probably have water in them. Four bleeder screws (preferably brass) and bleed the brakes. ...
Forum: Trailers 07-24-2014, 03:01 PM
Replies: 8
Views: 243
Posted By 2010Prostar197
Interesting all 4 are missing the nipple assembly...

Interesting all 4 are missing the nipple assembly that the bleeder hose fits on. Is this brand new??? Or new to you???
Forum: Trailers 07-24-2014, 12:56 PM
Replies: 10
Views: 404
Posted By 2010Prostar197
It's a direct replacement for the Reliable swing...

It's a direct replacement for the Reliable swing away tongue setup. Basically pull the pin and remove the bolt. It requires removing and reinstalling the brake line and then bleeding the brakes and...
Forum: Trailers 07-23-2014, 11:14 PM
Replies: 10
Views: 404
Posted By 2010Prostar197
It still depends on the brand. Our 2010 had the...

It still depends on the brand. Our 2010 had the junk Reliable setup which unless you find a dealer that has a used or spare slide out part the next step is to do the UFP upgrade. If it isn't a...
Forum: Trailers 07-23-2014, 10:03 PM
Replies: 10
Views: 404
Posted By 2010Prostar197
Reliable tongue?? Pictures??

Reliable tongue?? Pictures??
Forum: Trailers 07-22-2014, 12:56 PM
Replies: 1
Views: 127
Posted By 2010Prostar197
Yes. It's under the plate and has to be removed.

Yes. It's under the plate and has to be removed.
Forum: General Discussion 07-22-2014, 10:20 AM
Replies: 7
Views: 354
Posted By 2010Prostar197
Tranny noise when power loading

Mine did that until I aligned the coupling behind the transmission. It was 5 thousandths out of round from the factory.

i attributed the noise to being on a solid trailer rather than in water where...
Forum: MasterCraft In Your Area 07-21-2014, 08:07 PM
Replies: 530
Views: 25,888
Posted By 2010Prostar197
GoBolts---the link you have is missing something...

GoBolts---the link you have is missing something however going back to post one got me to the map. Guess I should have gone back to the beginning. :-)
Forum: MasterCraft In Your Area 07-21-2014, 04:54 PM
Replies: 530
Views: 25,888
Posted By 2010Prostar197
Is there a link to show the totals???

Is there a link to show the totals???
Forum: Engine / Drive Train 07-20-2014, 10:00 PM
Replies: 31
Views: 716
Posted By 2010Prostar197
Also seen a bad coil cause it. Low high voltage...

Also seen a bad coil cause it. Low high voltage at the plug will cause the spark to blow out under load
Forum: Engine / Drive Train 07-20-2014, 09:58 PM
Replies: 31
Views: 716
Posted By 2010Prostar197
88 tristar 351 stalling won't acelerate

I have seen a cam chain skip a tooth and cause the lack of power you are describing. Valves are not closed/open correctly. A vacuum check yields what kind of vacuum at idle?? Any back firing...
Forum: Engine / Drive Train 07-20-2014, 09:11 PM
Replies: 31
Views: 716
Posted By 2010Prostar197
Do you see two healthy squirts of gas when you...

Do you see two healthy squirts of gas when you open the throttle from idle?
Forum: General Discussion 07-17-2014, 05:38 PM
Replies: 10
Views: 410
Posted By 2010Prostar197
Thanks... Auto Zones in this area carry the 2044...

Thanks...

Auto Zones in this area carry the 2044 in stock but have to order the 2065.

Good to know info!
Forum: General Discussion 07-17-2014, 01:28 PM
Replies: 10
Views: 410
Posted By 2010Prostar197
It's the same pump used in cars/trucks that use...

It's the same pump used in cars/trucks that use ethanol with no problems, right??

I thought the E2065 was the preferred pump because of the pressure or is the the 2044 the new preferred pump?
Forum: General Discussion 07-13-2014, 09:11 PM
Replies: 9
Views: 615
Posted By 2010Prostar197
Some things are a good price, some are not. ...

Some things are a good price, some are not. White foam gasket for Indmar raw water pump is 18.72 at Mastercraft Depot versus 3.73 at Skidim. However they do have specialty items that no one else...
Forum: Engine / Drive Train 07-12-2014, 02:25 PM
Replies: 460
Views: 80,475
Posted By 2010Prostar197
Does anyone know the size of the Oetiker style...

Does anyone know the size of the Oetiker style earless clamp that is on there originally? Number should be embossed on the clamp.
Forum: Trailers 06-18-2014, 09:52 PM
Replies: 6
Views: 313
Posted By 2010Prostar197
Reliable to UFP conversion, help?

Leave the nut on the bottom but a couple threads loose of tight. Whacking the nut upwards beats mushrooming the threads.
Forum: Electrical 06-16-2014, 02:27 PM
Replies: 13
Views: 475
Posted By 2010Prostar197
I had one like that where the ignition switch was...

I had one like that where the ignition switch was at fault. Kept springing back however holding it in the run position allowed us to get back to the trailer.

Of course the kill switch coming apart...
Showing results 1 to 25 of 194

 

All times are GMT -4. The time now is 04:10 PM.