Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 31
Search took 0.00 seconds.
Search: Posts Made By: eddyb
Forum: General / Other 06-24-2014, 06:43 AM
Replies: 1
Views: 146
Posted By eddyb
Depth Gauge Removal

Need to replace my depth gauge at the back of boat does anyone have any suggestions on how to remove it. It's glued down pretty well.
Thanks Ed
Forum: Engine / Drive Train 09-26-2012, 02:41 PM
Replies: 2
Views: 430
Posted By eddyb
Transmission level check

The manual says "Quickly re-insert it fully and immediately remove" does this mean screw it in, or insert to the treads and remove?

Thanks
Forum: Storage / Winterization 09-16-2012, 04:30 PM
Replies: 9
Views: 1,230
Posted By eddyb
do i have to worry about fogging oil in the...

do i have to worry about fogging oil in the engine oil like so people have posted
Forum: Storage / Winterization 09-16-2012, 10:05 AM
Replies: 9
Views: 1,230
Posted By eddyb
Oil change after fogging

If I fog through the spark plugs (like I have done since I got my x10 a couple of years ago) how important is it change the oil again in the spring if I just changed it in the fall?

Thanks Ed
Forum: Storage / Winterization 09-26-2011, 12:24 PM
Replies: 10
Views: 1,378
Posted By eddyb
Fogging consensus on MCX

Still trying to get this clear. Is it better to fog through the spark plugs, or not fog at all? If I do fog do I have to change the spark plugs, or are my new plugs from last year good enough? I...
Forum: Engine / Drive Train 05-23-2011, 10:28 AM
Replies: 2
Views: 199
Posted By eddyb
gapping spark plugs

Changed the spark plugs on my 2005 mcx before putting it away for the winter. I didn't think of it then, but now that Iím getting ready to use it was I suppose to gap the spark plugs, and if so...
Forum: Storage / Winterization 09-28-2010, 03:00 PM
Replies: 2
Views: 728
Posted By eddyb
fogging efi

Would like some opinions on whether to fog an efi engine through the flame arrestor, or is there a better way?
Forum: Wakeboarding & Wakeskating 08-26-2010, 07:30 PM
Replies: 6
Views: 2,360
Posted By eddyb
wake surfing behind x10

looking at buying a wake surfer and was wondering if my 2005 x10 was good enough to surf behind without adding any extra sacks?

thanks ed
Forum: Electrical 07-05-2010, 03:59 PM
Replies: 0
Views: 360
Posted By eddyb
speedometer wiring

does anyone have a speedometer/paddlewheel wiring diagram for an 05 x10? the speedometer reads 0 all the time and i'm hoping it's just a lose wire.

thanks
Forum: General / Other 05-24-2010, 04:32 PM
Replies: 3
Views: 898
Posted By eddyb
it's a 2005 x10

it's a 2005 x10
Forum: General / Other 05-24-2010, 03:10 PM
Replies: 3
Views: 898
Posted By eddyb
Speedometer not working

My speedometer stop working late last year and still doesnít work this year. It was working fine, then while anchored, I started playing with the speaker wires under the dash, and after that the...
Forum: Storage / Winterization 10-02-2009, 09:17 PM
Replies: 4
Views: 734
Posted By eddyb
how do you suck up the antifreeze

how do you suck up the antifreeze
Forum: Storage / Winterization 10-02-2009, 06:54 PM
Replies: 4
Views: 734
Posted By eddyb
draining the block

My first time winterization my x10, and wondering if draining the block is enough protection or should I run antifreeze though it? I drained the block and removed most of the hoses. I feel pretty...
Forum: Engine / Drive Train 09-29-2009, 06:04 AM
Replies: 9
Views: 641
Posted By eddyb
I did. After draining whatever that green stuff...

I did. After draining whatever that green stuff was I placed 15w40 in like the maual said to do
Forum: Engine / Drive Train 09-28-2009, 09:02 AM
Replies: 9
Views: 641
Posted By eddyb
I donít think it was coolant but it had that same...

I donít think it was coolant but it had that same look and smell as coolant
Forum: Engine / Drive Train 09-28-2009, 08:33 AM
Replies: 9
Views: 641
Posted By eddyb
Transmission Fluid

I changed the transmission fluid this past weekend for the first time on my 20005 x10 since I bought it last year. The spec sheet said to use 15w 40 but when I pulled the old stuff out it was green...
Forum: Storage / Winterization 08-31-2009, 05:06 PM
Replies: 23
Views: 3,043
Posted By eddyb
I'm reading this thread and would like to know...

I'm reading this thread and would like to know what you mean by the heater.

Thanks
Forum: Trailers 08-22-2009, 10:05 AM
Replies: 3
Views: 515
Posted By eddyb
Is it the little hole on the hub

Is it the little hole on the hub
Forum: Trailers 08-21-2009, 03:52 PM
Replies: 3
Views: 515
Posted By eddyb
refilling bearing oil

I accidentally knock off the clear cover for my bearing oil when I was removing the tire, and I would like to know how to refill it

Thanks
Forum: Wakeboarding & Wakeskating 08-12-2009, 07:49 AM
Replies: 1
Views: 1,000
Posted By eddyb
wakeboard shop around detroit

does any one know a good wakeboard place anywhare around the detroit/toledo area?

ed
Forum: Trailers 08-07-2009, 06:58 PM
Replies: 8
Views: 803
Posted By eddyb
It does have a hole for the pin. Is it possible...

It does have a hole for the pin. Is it possible that the steel is so soft that it would ware out? Also I do not have an UFP actuator.
Forum: Trailers 08-04-2009, 09:39 AM
Replies: 8
Views: 803
Posted By eddyb
How do I find the trailer info? I think the...

How do I find the trailer info? I think the model is an act 75, but when I look this up I get nothing.

Ed
Forum: Trailers 08-03-2009, 09:57 PM
Replies: 8
Views: 803
Posted By eddyb
reverse pin

This is a follow up to my post about backing up my trailer with my atv. Does any one know why sticking a pin through the trailer tongue did not pevent the brakes from locking up when I reversed with...
Forum: Trailers 08-02-2009, 09:32 AM
Replies: 2
Views: 368
Posted By eddyb
moving trailer with atv

how can i prevent my trailer wheels from locking up in reverse when i don't have a wire harness on my atv. i tried placing a bolt through the holes at the front of the trailer which i thought was to...
Forum: Engine / Drive Train 06-26-2009, 10:07 AM
Replies: 2
Views: 378
Posted By eddyb
that's what i was hoping to hear thanks

that's what i was hoping to hear

thanks
Showing results 1 to 25 of 31

 

All times are GMT -4. The time now is 03:48 PM.