Go Back   TeamTalk > Search Forums

Showing results 1 to 17 of 17
Search took 0.05 seconds.
Search: Posts Made By: Skunkworks
Forum: Engine / Drive Train 07-12-2018, 04:17 PM
Replies: 5
Views: 319
Posted By Skunkworks
It would seem that if you put a level on the...

It would seem that if you put a level on the floor along the centerline of the boat, then you would be able to determine dead level. This would relieve you having to put it back in the water. If...
Forum: Engine / Drive Train 07-12-2018, 04:06 PM
Replies: 8
Views: 970
Posted By Skunkworks
My experience (more from the automotive world)...

My experience (more from the automotive world) would point more to an Oxygen sensor than a coil causing the engine to run rich.

BTW, how are you reading and clearing the DTC codes? Did you purchase...
Forum: General Discussion 07-11-2018, 06:03 PM
Replies: 8
Views: 460
Posted By Skunkworks
I will be replacing the impeller this weekend and...

I will be replacing the impeller this weekend and checking the inlet to the transmission cooler for debris. Also, will try the "burping" technique mentioned on the forum as well. Another...
Forum: General Discussion 07-09-2018, 07:01 PM
Replies: 8
Views: 460
Posted By Skunkworks
I was able to duplicate the problem and it...

I was able to duplicate the problem and it appears that the temp had gone up to about 180 degrees and then went into Limp Home. After running at lower RPM's the temp came down to 160 and I was good...
Forum: General Discussion 07-09-2018, 06:52 PM
Replies: 8
Views: 460
Posted By Skunkworks
I was able to duplicate the problem and it...

I was able to duplicate the problem and it appears that the temp had gone up to about 180 degrees and then went into Limp Home. After running at lower RPM's the temp came down to 160 and I was good...
Forum: General Discussion 07-09-2018, 06:40 PM
Replies: 16
Views: 2,106
Posted By Skunkworks
What was determined to be the problem of the...

What was determined to be the problem of the overheating? I am experiencing similar on my 2005 X45 with LQ9.
Forum: General Discussion 07-03-2018, 11:15 AM
Replies: 8
Views: 460
Posted By Skunkworks
What did you have corrected so that it stopped...

What did you have corrected so that it stopped going into limp mode (idle)? Thanks.
Forum: General Discussion 07-02-2018, 02:36 PM
Replies: 5
Views: 281
Posted By Skunkworks
Yes. The bolt goes where you indicated. There...

Yes. The bolt goes where you indicated. There should be a bracket or arm that comes off the engine and goes over the nipple and bushing. The bolt holds the bracket in place. This keeps the pump...
Forum: General Discussion 07-02-2018, 01:02 PM
Replies: 8
Views: 460
Posted By Skunkworks
LQ9 Limp home

After cruising around and enjoying the 2005 X45 w/ LQ9 for a couple hours yesterday, we were on our way home. All was fine... running around 3,000 rpms, oil pressure, water temp, volts, everything...
Forum: General Discussion 07-02-2018, 12:54 PM
Replies: 5
Views: 281
Posted By Skunkworks
The bolt turned out to be a 5/16 x 18, 1 inch...

The bolt turned out to be a 5/16 x 18, 1 inch long.
Forum: General Discussion 06-25-2018, 11:08 AM
Replies: 5
Views: 281
Posted By Skunkworks
Raw Water Pump bolt

Hi guys. Just have a quick repair to make to get the 2005 X45 w/ LQ9 back in the water. It seems the bolt that holds the bracket to the raw water pump from underneath is missing and I can't find...
Forum: General Discussion 09-14-2017, 09:05 PM
Replies: 0
Views: 471
Posted By Skunkworks
Zero Flex Tower Wake Rack Cover

During the tropical storm in GA, one of the covers for the wake rack disappeared in the wind. Any ideas on where to get new covers? Can't find anything via Google. The covers were quite faded...
Forum: General Discussion 05-20-2015, 08:56 PM
Replies: 8
Views: 2,467
Posted By Skunkworks
After some investigation of the LQ9 and for...

After some investigation of the LQ9 and for information - the water pump fitting closest to the engine block (toward the bow of boat) is flow from the engine; the water pump fitting toward the stern...
Forum: General Discussion 05-18-2015, 03:35 PM
Replies: 8
Views: 2,467
Posted By Skunkworks
Talking Brilliant :D. That is where I thought to connect...

Brilliant :D. That is where I thought to connect the heater hoses, but I wanted to be sure. Do you know which is the inlet and which is the outlet for the waterpump? (My Maradyne heater recommends...
Forum: General Discussion 04-23-2015, 07:36 PM
Replies: 8
Views: 2,467
Posted By Skunkworks
Anyone with an LQ9 and a heater? Thanks. David

Anyone with an LQ9 and a heater?

Thanks.

David
Forum: General Discussion 04-10-2015, 07:31 PM
Replies: 8
Views: 2,467
Posted By Skunkworks
2005 X45 LQ9 Heater Connection at Engine

I am installing a heater in my 2005 X45 with the Cadillac LQ9. Does anyone have pictures of where to connect the heater valves to the engine? It is a closed cooling system. Any recommended valves or...
Forum: Engine / Drive Train 03-30-2015, 05:01 PM
Replies: 0
Views: 475
Posted By Skunkworks
2005 X45 LQ9 Heater Connection at Engine

I am installing a heater in my 2005 X45 with the Cadillac LQ9. Does anyone have pictures of where to connect the heater valves to the engine? It is a closed cooling system. Any recommended valves...
Showing results 1 to 17 of 17

 

All times are GMT -4. The time now is 05:45 AM.


2018