Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 76
Search took 0.01 seconds.
Search: Posts Made By: woodrowskis
Forum: Tow Vehicles 08-13-2015, 02:30 PM
Replies: 38
Views: 1,667
Posted By woodrowskis
I am a guy much like yourself. I buy a vehicle...

I am a guy much like yourself. I buy a vehicle and keep it 10 years. Some folks earlier talked about put 180,000 miles in 3 years. While that is good, I don't think it is the same as what we do.
I...
Forum: Upholstery 07-06-2015, 11:43 AM
Replies: 31
Views: 3,970
Posted By woodrowskis
I had an '86. I know what you mean about the...

I had an '86. I know what you mean about the piping back then. For whatever reason the piping or placement of it, really dated the boat. When I re-upholstered I wanted it gone also.

My 2002, had no...
Forum: Engine / Drive Train 06-26-2015, 12:48 PM
Replies: 7
Views: 416
Posted By woodrowskis
I would agree to do a electrical tune up. Cap,...

I would agree to do a electrical tune up. Cap, rotor, points, condenser, plugs unless you know the previous owner recently changed them. If you are trying to troubleshoot the carb, you want the...
Forum: General Discussion 06-16-2015, 02:58 PM
Replies: 7
Views: 525
Posted By woodrowskis
this is going to set the rudder limits. try to...

this is going to set the rudder limits. try to get the tube threaded to the same factory location in the clamp. if you can't tell where it was previously adjust so that the rudder goes appx equal...
Forum: Engine / Drive Train 06-16-2015, 11:38 AM
Replies: 9
Views: 693
Posted By woodrowskis
I have had the very small surge tank (where the...

I have had the very small surge tank (where the radiator cap is) leak at the welding points. I would look at that closely. If that's it, get a radiator shop to weld it back up with a TIG welder. ...
Forum: Electrical 06-16-2015, 11:31 AM
Replies: 2
Views: 300
Posted By woodrowskis
i agree,probably the voltage. conenct a battery...

i agree,probably the voltage. conenct a battery charger to it (just to keep the voltage up.) If it doesn't go off, that's your problem.
Forum: General Discussion 01-26-2015, 04:29 PM
Replies: 21
Views: 2,617
Posted By woodrowskis
2015 Prostar

I saw a 2015 Prostar at the Houston boat show. I noticed what I thought was the blower exhaust coming out of the back of the engine box. I thought this a little unusual. Maybe it was not for the...
Forum: Engine / Drive Train 05-15-2014, 06:10 PM
Replies: 74
Views: 4,455
Posted By woodrowskis
I read the entire deal but was interrupted a few...

I read the entire deal but was interrupted a few times so its difficult to remember it all.

(1) If you are getting voltage to the distributor but not to the plugs, I agree on the cap and rotor....
Forum: Appearance 05-15-2014, 12:28 PM
Replies: 24
Views: 2,532
Posted By woodrowskis
Older Decals: trying Cassandra at Universal Products

She answered but says I have to get the part numbers from Mastercraft and have permission from Mastercraft.

I am tying to email my dealer and I can't get email through to them to confirm part...
Forum: Engine / Drive Train 09-30-2013, 11:14 AM
Replies: 32
Views: 1,953
Posted By woodrowskis
I have that sound in my boat. I do have motor...

I have that sound in my boat. I do have motor oil instead of transmission fluid. I am not sure what I think is the problem. I am going to get the alignment checked this winter when I slow down...
Forum: Electrical 06-06-2013, 08:44 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
I looked at my picture on my old sending unit. It...

I looked at my picture on my old sending unit. It had screws and I did remember it saying empty and full. However, I pulled my panel to get access to the tank to adjust the new unit ( I was going to...
Forum: Electrical 06-05-2013, 09:42 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
I had no idea those were adjusting screws. Mine...

I had no idea those were adjusting screws. Mine has two hex head bolts which look structural. I'll give it a shot. thanks.
Forum: Electrical 06-05-2013, 09:33 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
Sounds reasonable but I live on a ski lake where...

Sounds reasonable but I live on a ski lake where we fill with 5 gallons cans. And I share the boat with a neighbor. So just filling is not a good option for me. Before I started sharing it wasn't a...
Forum: Electrical 06-05-2013, 09:24 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
I could not find after about 30 minutes so I went...

I could not find after about 30 minutes so I went to the dealer. About $110. yes, a little disappointing
Forum: Electrical 06-03-2013, 08:26 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
Testing the sending unit versus the gauge was...

Testing the sending unit versus the gauge was going to be a pain. I ordered a sending unit. It fixed the problem. I have not filled it or driven to empty to check accuracy. But looking at the amount...
Forum: Engine / Drive Train 05-31-2013, 05:58 PM
Replies: 58
Views: 10,024
Posted By woodrowskis
I never figured out my problem. My boat runs well...

I never figured out my problem. My boat runs well as far as skiing. I am on a slalom course and pulls great passes and times out correct consistently. But it still makes a nasty noise at times. It...
Forum: Upholstery 05-31-2013, 04:52 PM
Replies: 9
Views: 1,236
Posted By woodrowskis
If you do not get a wrench on the back of the...

If you do not get a wrench on the back of the upper screws you can tear the panel material behind them. You can see a few tech tips on how people have tried differrent ways to repair this. Definitely...
Forum: Electrical 05-29-2013, 09:39 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
it may not be perfect, that could cause the full...

it may not be perfect, that could cause the full too soon issue, but it always worked accurately from 3/4 down to empty before. thats all I really care about.
Forum: Electrical 05-29-2013, 02:24 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
I did find a test method but I do need the...

I did find a test method but I do need the correct electrical connector and apparently need some resistors to confirm the gauge . Anyone know if it is the same resistors for the 3 pin? I may can...
Forum: Electrical 05-29-2013, 01:52 AM
Replies: 17
Views: 3,542
Posted By woodrowskis
Fuel Gauge inacurrate

2002 Mastercraft 197:
I am about to search history again but did not find the advice I was looking for last time. Anyway fuel gauge reads wrong. It does read now. It used to say empty. Dealer...
Forum: Engine / Drive Train 09-15-2012, 10:48 PM
Replies: 2
Views: 1,121
Posted By woodrowskis
Ticking noise in exhaust 2010 X14v

Noise in exhaust. Can feel it in the left bank in the muffler and the flex hose. Did not hold the SS tubing to feel due to temperature. Has anyone had catalyst come loose or baffle loose in the...
Forum: Electrical 01-31-2012, 06:52 PM
Replies: 8
Views: 3,794
Posted By woodrowskis
should have asked 1st time, but how much do you...

should have asked 1st time, but how much do you want for it?
you said you had an extra.

Not trying to nickel and dime you.
Forum: Electrical 01-31-2012, 05:14 PM
Replies: 8
Views: 3,794
Posted By woodrowskis
sorry, what is MDC?

sorry, what is MDC?
Forum: Engine / Drive Train 01-13-2012, 01:17 PM
Replies: 4
Views: 600
Posted By woodrowskis
transmissions are rotation specific. especially...

transmissions are rotation specific. especially for driving the pump.
I have seen a thread in the past telling how to change the rotation on a transmission if you think you might be up to it. It...
Forum: Electrical 01-13-2012, 01:13 PM
Replies: 3
Views: 942
Posted By woodrowskis
2002 model 197. I have had low batteries that...

2002 model 197.
I have had low batteries that would not crank.
Alarm never went off then. Maybe it has to be high enough for alarm
Showing results 1 to 25 of 76

 

All times are GMT -4. The time now is 07:20 AM.