Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 492
Search took 0.02 seconds.
Search: Posts Made By: cruiser
Forum: General / Other 06-24-2015, 11:52 AM
Replies: 4
Views: 165
Posted By cruiser
I agree, Have tried to tighten all bolts and are...

I agree, Have tried to tighten all bolts and are snug with no movement.
Forum: General / Other 06-24-2015, 11:31 AM
Replies: 4
Views: 165
Posted By cruiser
Thanks Eric. I guess I must be lucky the...

Thanks Eric. I guess I must be lucky the stringers are rock solid.
Forum: General / Other 06-24-2015, 11:24 AM
Replies: 4
Views: 165
Posted By cruiser
1981 stars and stripes wood stringers

My 81 S & S has fiberglass over the stringers, would that be original. Everyone says they are wood. If so would the stringers be wood encapsulated with glass. And the newer boats be a fiberglass.
Forum: Engine / Drive Train 06-15-2015, 01:20 PM
Replies: 24
Views: 730
Posted By cruiser
Soaked in carb cleaner overnite, then ultrasonic...

Soaked in carb cleaner overnite, then ultrasonic cleaner for about an hour. If the float bowl on the secondaries is set too high would it drip from the primarys?
Forum: Appearance 06-11-2015, 06:01 PM
Replies: 15
Views: 385
Posted By cruiser
Sorry to hear about your brother. When you get...

Sorry to hear about your brother. When you get your boat on the water you can thing of Him.

My Brother was a police officer that was shot in the line of Duty, He had a place at the lake that I live...
Forum: Appearance 06-11-2015, 04:58 PM
Replies: 15
Views: 385
Posted By cruiser
Inside just before the corner bracket.

Inside just before the corner bracket.
Forum: Appearance 06-11-2015, 04:57 PM
Replies: 15
Views: 385
Posted By cruiser
You should be good to go.

You should be good to go.
Forum: Appearance 06-11-2015, 04:54 PM
Replies: 15
Views: 385
Posted By cruiser
My measurements based on your drawing are 72 wide...

My measurements based on your drawing are 72 wide and 19 high.
Forum: Appearance 06-11-2015, 04:48 PM
Replies: 15
Views: 385
Posted By cruiser
Just measured my 1981 S&S. Just under the upper...

Just measured my 1981 S&S. Just under the upper moulding to the corner of the glass where the bracket is 101 inches. Just above the lower moulding to the corner of the glass where the bracket is 119...
Forum: Engine / Drive Train 06-10-2015, 09:16 AM
Replies: 24
Views: 730
Posted By cruiser
When I rebuilt the carb I soaked it overnite and...

When I rebuilt the carb I soaked it overnite and used a ultrasonic. It was pretty clean when I assembled it.
Forum: Engine / Drive Train 06-10-2015, 08:18 AM
Replies: 24
Views: 730
Posted By cruiser
Last spring ran a new fuel line from tank and...

Last spring ran a new fuel line from tank and installed a new fuel/water separator. will check fuel tank vent. Boat performs great, it just wants to stall after idoling for a few minutes. I think it...
Forum: Engine / Drive Train 06-09-2015, 10:26 PM
Replies: 24
Views: 730
Posted By cruiser
yes, I installed a back fire preventer kit when I...

yes, I installed a back fire preventer kit when I rebuilt the carb. It is very frustrating when the boat stalls all the time when trying to pull skiers.
Forum: Engine / Drive Train 06-09-2015, 05:37 PM
Replies: 24
Views: 730
Posted By cruiser
Will check power valve. If I did have a back fire...

Will check power valve. If I did have a back fire the kit should have prevented the power valve from blowing. Also I have mics and toolmakers square to check for warpage.
Forum: Engine / Drive Train 06-09-2015, 03:36 PM
Replies: 24
Views: 730
Posted By cruiser
Power valve is ok. Installed kit when I rebuilt...

Power valve is ok. Installed kit when I rebuilt carb.
Forum: Engine / Drive Train 06-09-2015, 03:19 PM
Replies: 24
Views: 730
Posted By cruiser
Just tried to blow through the inlet. Needle...

Just tried to blow through the inlet. Needle closed off 100%. Cant be leaking from there.
Forum: Engine / Drive Train 06-09-2015, 02:27 PM
Replies: 24
Views: 730
Posted By cruiser
just rebuilt the carb.. Only has about 10 hours...

just rebuilt the carb.. Only has about 10 hours run time.
Forum: Engine / Drive Train 06-09-2015, 02:19 PM
Replies: 24
Views: 730
Posted By cruiser
4160 carb

Just took off the front bowl and expected to have gas spilling out and was totally dry. Had been sitting all winter. Is this normal. Needle and seat spotless float was set to proper setting. Last...
Forum: Off Topic Discussion 05-15-2015, 06:27 PM
Replies: 8,130
Views: 512,997
Posted By cruiser
Unhappy Ice Tea tonite, On call for the next three nites.

Ice Tea tonite, On call for the next three nites.
Forum: Trailers 05-09-2015, 02:23 PM
Replies: 13
Views: 883
Posted By cruiser
I guess I'll do as Peter does. Jackstands and...

I guess I'll do as Peter does. Jackstands and call it good.
Forum: Trailers 05-09-2015, 12:32 PM
Replies: 13
Views: 883
Posted By cruiser
Wheel is in center of fender well, measures from...

Wheel is in center of fender well, measures from center of ball to front of bow bracket 62.5 inches. The bracket looks as if it is in the correct location based on the frame width.(Not hanging over...
Forum: Trailers 05-08-2015, 09:10 PM
Replies: 13
Views: 883
Posted By cruiser
OK, pics tomorrow.

OK, pics tomorrow.
Forum: Trailers 05-08-2015, 06:44 PM
Replies: 13
Views: 883
Posted By cruiser
I also believe that when Im towing the trailer...

I also believe that when Im towing the trailer is always trying to come off the trailer ball????
Forum: Trailers 05-08-2015, 06:42 PM
Replies: 13
Views: 883
Posted By cruiser
Boat tows great. Just a pain when your trying to...

Boat tows great. Just a pain when your trying to work on thing when not hooked up to the tow vehicle.2
Forum: Trailers 05-08-2015, 10:18 AM
Replies: 13
Views: 883
Posted By cruiser
Tongue Weight

1981 Mastercraft with original trailer. I have almost no tongue weight. If I walk to the back of the boat on the trailer it will fall to the stern. Is anybody else having this problem? Would moving...
Forum: Off Topic Discussion 04-20-2015, 05:14 PM
Replies: 6,325
Views: 930,540
Posted By cruiser
That's why they call it fishing not catching.

That's why they call it fishing not catching.
Showing results 1 to 25 of 492

 

All times are GMT -4. The time now is 10:43 PM.