TeamTalk > Search Forums Search Results

User Name Remember Me? Password

Showing results 1 to 24 of 24 Search took 0.00 seconds. Search: Posts Made By: Stutsman230

Forum: MasterCraft In Your Area 01-20-2013, 07:27 PM

Replies: 308 Important: TeamTalk Members Map Views: 9,340 Posted By Stutsman230 Phoenix, Az 85028 Hydrofoiling Phoenix, Az 85028 Hydrofoiling

Forum: General Discussion 06-06-2012, 09:31 PM

Replies: 9 Service in Phoenix Views: 433 Posted By Stutsman230 I have used AZ Mastercraft and now Az Luxury... I have used AZ Mastercraft and now Az Luxury Marine since 2002. I have purchased two used Mastercraft boats from them. They have always been very upfront and honest in our financial dealings. Both...

Forum: General Discussion 06-03-2012, 11:13 PM

Replies: 24 Opinions needed Views: 1,581 Posted By Stutsman230 I just experienced a freshwater pump problem on a... I just experienced a freshwater pump problem on a friends boat (not Mastercraft). It is a 2006 boat and it has a 5.7 liter Mercruiser installation. The bearings had gone bad in the pump and we needed...

Forum: Trailers 05-21-2012, 09:48 PM

Replies: 35 Surge brakes pulsating or "machine gunning" Views: 1,952 Posted By Stutsman230 I have been told that there is an orifice in the... I have been told that there is an orifice in the actuator. The old orifice may have been smaller. Talk to Jim at Arizona Luxury Marine about your problem.

Forum: Trailers 05-10-2012, 09:28 PM

Replies: 9 Trailer project with pics Views: 848 Posted By Stutsman230 I used a heat gun and a putty knife to remove the... I used a heat gun and a putty knife to remove the adhesive. M/C dealer suggestion. Worked great! Be careful to not blister the fiberglass by applying too much heat.

Forum: General Discussion 04-04-2012, 03:08 PM

Replies: 97 Poll: How often do you run your bilge blower? Views: 4,482 Posted By Stutsman230 I always open the engine cover and smell for... I always open the engine cover and smell for fumes when we pull up to the ramp at the beginning of the day. Then I still run the blower while loading the boat before launching. I always smell for...

Forum: MasterCraft In Your Area 03-04-2012, 09:45 PM

Replies: 5 Where to skii near Phoenix Views: 457 Posted By Stutsman230 Coz, you are so right! Apache is the prettiest of... Coz, you are so right! Apache is the prettiest of them all. Most people don't like the dirt road from Canyon or Roosevelt that's required to get there. Weekdays are always the best. This time of year...

Forum: MasterCraft In Your Area 03-04-2012, 05:50 PM

Replies: 5 Where to skii near Phoenix Views: 457 Posted By Stutsman230 I live in Phoenix. The lakes currently available... I live in Phoenix. The lakes currently available are in order of size: Roosevelt Lake, Lake Pleasant, Canyon Lake and Saguaro Lake. Bartlett Lake is too low to use the ramps which makes it very...

Forum: Trailers 03-04-2012, 05:27 PM

Replies: 6 Trailer lights won't work Views: 430 Posted By Stutsman230 Do the trailer lights work when the headlights... Do the trailer lights work when the headlights are turned back off? I have found that when trailer lights go off and on with different combinations of car light switches it's always a problem with...

Forum: Trailers 02-17-2012, 11:58 PM

Replies: 5 Replacement Trailer Axles Views: 924 Posted By Stutsman230 I was able to get the replacement axles. It took... I was able to get the replacement axles. It took 3 weeks to have them fabricated and shipped to Phoenix. They were sourced from UFP. The cost was $1500 which included shipping the axles, arms, disk...

Forum: Trailers 01-19-2012, 10:23 AM

Replies: 5 Replacement Trailer Axles Views: 924 Posted By Stutsman230 It seems they aren't being used in new designs or... It seems they aren't being used in new designs or haven't been manufactured for a while. They quoted my dealer a 4 to 5 week leadtime. My front axle was replaced a few years ago by the previous owner...

Forum: Trailers 01-18-2012, 09:54 PM

Replies: 5 Replacement Trailer Axles Views: 924 Posted By Stutsman230 Replacement Trailer Axles Anyone having problems finding replacement axles for 2002 Mastercraft trailer? The trailer has UFP torsion suspension and axles. The boat is a 2002 230VRS Maristar.

Forum: General Discussion 08-12-2011, 05:30 PM

Replies: 36 What is your Gallons Per Hour (GPH)? Views: 3,252 Posted By Stutsman230 We have a 2002 230VRS with the LTR motor. We use... We have a 2002 230VRS with the LTR motor. We use the boat for hydrofoiling only. Original prop. We pull at 21 to 25 mph. 3 to 4 people in boat. No ballast. We use 4.5 gph.

Forum: General Discussion 08-10-2011, 08:02 PM

Replies: 26 Prostar 190 LT-1 vs Standard TBI Views: 3,460 Posted By Stutsman230 I have an 97 PS190 with the LT1 and the power... I have an 97 PS190 with the LT1 and the power slot. I have always run it on unleaded regular and it is awesome. The only problem I have had was cooling with the factory water bleeds on the low end of...

Forum: General Discussion 08-02-2011, 11:53 PM

Replies: 12 Drivers side panel falling off on 2002 x10? Views: 861 Posted By Stutsman230 I have a 2002 230VRS and had the same problem. I... I have a 2002 230VRS and had the same problem. I JB welded flat washers to the back side and made sure that the epoxy made it into all the cracks in the panel. I found some nut plates at Ace Hardware...

Forum: General Discussion 07-30-2011, 03:55 PM

Replies: 11 Engine Life ? Views: 1,004 Posted By Stutsman230 I have a 1997 PS190 with the LT1 engine and it... I have a 1997 PS190 with the LT1 engine and it has 1100 hours on it and it runs awesome. We have it serviced every 50 hours just like the manual says. Never had engine problems.

Forum: General Discussion 07-04-2011, 03:38 PM

Replies: 32 Blower Confusion Views: 1,957 Posted By Stutsman230 The boat was a 1997 PS190 and the circuit breaker... The boat was a 1997 PS190 and the circuit breaker was located directly under the blower switch on the dash. I don't have pictures showing the dash as the boat is at the dealer on consignment.

Forum: General Discussion 07-03-2011, 10:24 PM

Replies: 32 Blower Confusion Views: 1,957 Posted By Stutsman230 I've had problems with circuit breakers in the... I've had problems with circuit breakers in the past on a PS with about 500 hours on it. The blower wouldn't run and I thought the motor was bad/intermittent but turned out to be the connections...

Forum: General Discussion 07-03-2011, 10:15 PM

Replies: 2 grounding posts Views: 193 Posted By Stutsman230 Did you say that this has always been a problem?... Did you say that this has always been a problem? If it just started showing up there may have been a small order of grounds problem and as connections get corroded the voltage drop is getting bigger...

Forum: Audio/Stereo 07-03-2011, 10:09 PM

Replies: 90 Annoying hiss from speakers while boat is running Views: 5,813 Posted By Stutsman230 Did you say that this has always been a problem?... Did you say that this has always been a problem? If it just started showing up there may have been a small order of grounds problem and as connections get corroded the voltage drop is getting bigger...

Forum: General Discussion 04-28-2011, 11:13 AM

Replies: 8 Am I missing a throttle return spring? Views: 971 Posted By Stutsman230 I like the idea of the straight pull! I'm going... I like the idea of the straight pull! I'm going to follow your lead. Maybe it will reduce the overshoot or at least help the sensitivity.

Forum: General Discussion 04-24-2011, 11:38 PM

Replies: 8 Am I missing a throttle return spring? Views: 971 Posted By Stutsman230 I have a 2002 Maristar 230 VRS/LTR with Perfect... I have a 2002 Maristar 230 VRS/LTR with Perfect Pass installed. It is the satellite version. There are no additional springs. I do find that the speed will overshoot quite a bit if the driver gives...

Forum: General Discussion 04-16-2011, 10:05 PM

Replies: 84 MasterCraft Strut Design Flow Analysis Views: 6,396 Posted By Stutsman230 IMHO I believe that the bullet does nothing more... IMHO I believe that the bullet does nothing more than "straighten" the water flow into the leading edge of the prop. The propeller is most efficient when all the propeller blades get equal non...

Forum: Off Topic Discussion 02-21-2011, 10:51 PM

Replies: 523 profession age and location Views: 47,968 Posted By Stutsman230 64 years old. Grew up in southern cal but moved... 64 years old. Grew up in southern cal but moved to N. Phoenix in 1974. Electronics engineer with an optical scanning company. The wife and I are into hydrofoiling. Our newest M/C is a 2002 Maristar...

Showing results 1 to 24 of 24