Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 28
Search took 0.01 seconds.
Search: Posts Made By: Lakeview
Forum: General Discussion 05-31-2016, 08:32 AM
Replies: 6
Views: 558
Posted By Lakeview
Nxt 20-"the Real Price"

Cruising the new and used classified on MC dealers sites,I notice they are sitting on both new and leftover NXT-20's ???? Have they mislead the public on the price or are potential buyers just going...
Forum: General Discussion 03-18-2016, 02:25 PM
Replies: 33
Views: 1,732
Posted By Lakeview
The 80K ski/wakeboard boat

Either the banks are opening the floodgates to finance these boats,or lots of people have been hoarding cash these past yrs.A $700-$900. boat pymt every month just doesn't make sense to me in the...
Forum: General Discussion 03-18-2016, 08:21 AM
Replies: 33
Views: 1,732
Posted By Lakeview
Nxt 20-"the Real Price"

MC touts the 50K boat-but can you really drive away from a dealer with a useable equipped boat after writing a check for 50K???????
I see NXT 20 boats for 80K +

What are the real...
Forum: For Sale: Boats 09-25-2015, 08:10 AM
Replies: 0
Views: 566
Posted By Lakeview
Talking 1990 prostar powerslot

19 ft '90 prostar,mechanically perfect 1215 freshwater hrs,stored on lift,351 Indmar,bunk trailer with new tires,wheels,bearings,winch,full cover,bimini top,rear seat,interior 7 out of 10,new motor...
Forum: General Discussion 07-08-2015, 08:03 AM
Replies: 9
Views: 948
Posted By Lakeview
Nxt 20 ???

Looking for feedback on the NXT 20 for a 2016 purchase- 50K boat seems to have all the basics.

Forum: For Sale: Boats 06-24-2014, 10:21 AM
Replies: 1
Views: 776
Posted By Lakeview
1990 Prostar Pwrslot

1990 19 ft prostar,351 indmar,power slot trans,mechanically perfect,teak platform,full cover,fresh water only,Vanguard bunk trailer,new wheels bearings,tires,lights.
BLOWOUT PRICE $7200.Best deal in...
Forum: General Discussion 07-10-2013, 01:50 PM
Replies: 3
Views: 563
Posted By Lakeview
Help Please !!

Does anyone know who Mastercraft used as a sub contractor for Swim Platform "BRACKETS"??? I need a port side(left) for my '90 Prostar,and counted at least six other guys looking for...
Forum: General Discussion 07-12-2012, 05:30 PM
Replies: 44
Views: 4,209
Posted By Lakeview
Pass on the Atlanta boat-unless you have...

Pass on the Atlanta boat-unless you have unlimited funds,you'll be way over your head-plenty of good used mastercrafts and correct crafts out there-good luck
Forum: General Discussion 07-12-2012, 05:26 PM
Replies: 111
Views: 8,409
Posted By Lakeview
1990 prostar 190 with Powerslot- 1100 hrs :D

1990 prostar 190 with Powerslot- 1100 hrs :D
Forum: Engine / Drive Train 07-11-2012, 01:52 PM
Replies: 16
Views: 2,148
Posted By Lakeview
Not A Big Fan

I converted to an electronic module on my '85 Ski Nautique,and my '90 Prostar has the factory "prestolite" factory module.I experienced issues with both.If your dead set on going the electronic...
Forum: For Sale: Boats 03-15-2012, 03:53 PM
Replies: 0
Views: 1,055
Posted By Lakeview

1990 prostar,351 Indmar,POWERSLOT,1050 hrs,many new engine parts,exh manifolds,water pump,wires,belt,trans cooler,exhaust hoses,new motor box skin from copycat,dyna balanced 3 blade prop.Mechanically...
Forum: Engine / Drive Train 01-24-2012, 07:29 AM
Replies: 3
Views: 671
Posted By Lakeview
Try changing your fluid first,if the condition...

Try changing your fluid first,if the condition still exists check your damper plate on the flywheel(tranny has to come out).The springs wear over time and rattle.
Forum: General / Other 09-14-2011, 07:47 PM
Replies: 6,619
Views: 834,167
Posted By Lakeview
Red face '90 Prostar w/Powerslot

replaced the circ water pump with a new one from DIM,at 1087 Hrs.original pump squealing and not cooling-just plain worn out.Easy replacement-then did the oil and filter.Love the way my boat runs:D
Forum: Engine / Drive Train 08-20-2011, 08:38 PM
Replies: 2
Views: 675
Posted By Lakeview
Check this out

I had issues with my '90 prostar pwr slot last season-first check your linkage make sure your cable is engaging the arm fully.The clicking is most likely your pump which is located in the front of...
Forum: Engine / Drive Train 08-03-2011, 01:40 PM
Replies: 41
Views: 5,796
Posted By Lakeview
Talking My Indmar Experience

Just finished chasing the gremlins out of my '90 prostar-It was hard starting,stumbling,hard hot starts-
I cleaned rotor cap,replaced both fuel filters( lots of debris,water,rust),fresh fuel,checked...
Forum: Engine / Drive Train 07-13-2011, 09:00 PM
Replies: 52
Views: 11,306
Posted By Lakeview
Talking Easy fix

the transfer tube o rings are an easy fix and can be had from Summit or Jeg's,$2.99 for two,I also am in the process of replacing the front bowl gasket and metering block gasket with the newer blue...
Forum: General Discussion 04-21-2008, 09:29 AM
Replies: 14
Views: 1,026
Posted By Lakeview
Call or e-mail the holley tech line-they are very...

Call or e-mail the holley tech line-they are very helpful-don't make the mistake of putting too much carb on,you'll waste money and fuel.
Forum: General Discussion 04-21-2008, 09:25 AM
Replies: 10
Views: 3,060
Posted By Lakeview
Trans rattle

Make sure the noise is really from the trans and not a worn/broken spring on the damper plate that bolts to the flywheel.It will make the noise only at idle
Forum: General Discussion 08-08-2006, 04:00 PM
Replies: 8
Views: 888
Posted By Lakeview
Mid hull color mastercraft is Navy Blue-prostar...

Mid hull color mastercraft is Navy Blue-prostar 190 and ski boat is white,transom set is white.

One set left-$85.00 incl shipping

Rear side and transom set 190 - $50. incl shipping
Forum: General Discussion 08-08-2006, 11:47 AM
Replies: 8
Views: 888
Posted By Lakeview
Thumbs up '91 & up PROSTAR DECAL SET

:D I have two brand new sets of hull graphics,mid hull,rear side hull and stern.Made from high speed oracal these are better than the originals.
$85.00 per set includes shipping in U.S.:toast:
Forum: General Discussion 06-16-2006, 04:43 PM
Replies: 3
Views: 602
Posted By Lakeview
Talking Anyone have an ACCUSKI manual???????

:confused: My 90 prostar has a factory unit-Mastercraft has no info and the accuski website is not up yet.Hopefully someone out there has the original manual and can send it to me.Thanks!
Forum: General Discussion 04-03-2006, 12:35 AM
Replies: 2
Views: 598
Posted By Lakeview
Question Inner Bottom Weep Hole?????

WEEP HOLE???????? After removing the front floorboard on my 90 prostar,I tipped the trailer so the boat would be bow up,to remove leaves etc.I noticed approx 2" in front of my bilge mount basket...
Forum: Underwater Running Gear 03-19-2006, 06:02 PM
Replies: 3
Views: 802
Posted By Lakeview
Question Prop Advice

Need help and some input on a prop choice for my 90 prostar with pwr slot trans.Stock prop is a Federal 14" LH.What should I replace it with in the 4 blade category???? Wakeboarding and slalom...
Forum: General Discussion 03-05-2006, 08:49 AM
Replies: 1
Views: 586
Posted By Lakeview
Question Interior Input Needed!!

Looking for input for my prostar interior-Does MC still make the replacement skins(1990),if so are they comparable in price to a local boat interior shop for a new interior-seats,pads???Thanks...
Forum: General Discussion 03-01-2006, 12:00 PM
Replies: 4
Views: 641
Posted By Lakeview
Question Need exact info

Thanks guy's but I need exacto measurement due to my lake's restriction-hull only can be no longer than 19'-I know up to and including '89 they were 19'.Please help me on this one! :confused: From...
Showing results 1 to 25 of 28


All times are GMT -4. The time now is 08:22 PM.