Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: etduc
Forum: Off Topic Discussion 09-22-2017, 09:44 AM
Replies: 15,843
Views: 5,659,847
Posted By etduc
[QUOTE=TyTanium;1376407]And not enough zoom...

[QUOTE=TyTanium;1376407]And not enough zoom :D[/Q

Here you go! :rolleyes:
Forum: Off Topic Discussion 09-20-2017, 09:33 PM
Replies: 15,843
Views: 5,659,847
Posted By etduc
Dudes, explain the 8th girl!

Dudes, explain the 8th girl!
Forum: Engine / Drive Train 09-13-2017, 02:13 PM
Replies: 4
Views: 214
Posted By etduc
According to engine specs. Max rpm is 5000 rpm. ...

According to engine specs. Max rpm is 5000 rpm. I assume you check fuel pressure at schrader valve. That doesn't check spray at injector nozzles.

Check you compression. (IIRC should be 200-250...
Forum: Engine / Drive Train 09-05-2017, 03:50 PM
Replies: 18
Views: 354
Posted By etduc
Yep. Some 302 (HO) will have the same firing...

Yep.
Some 302 (HO) will have the same firing order. Earlier 260,289,302, had a slightly different
firing order. So surfing the web, persons can get the wrong firing order.
Here's another link:...
Forum: Engine / Drive Train 09-05-2017, 03:08 PM
Replies: 18
Views: 354
Posted By etduc
What Peter said....

What Peter said. ^
https://www.youtube.com/watch?v=Y3hZrW4Ryo4

Should be a 600cfm carb.
Forum: General Discussion 08-28-2017, 05:55 PM
Replies: 28
Views: 996
Posted By etduc
THIS^^^^ Other bad news. You can get a smaller...

THIS^^^^ Other bad news.

You can get a smaller ID cutless bearing. Good luck getting it over the non machine shaft. I know, some would use emory cloth and sand the area. Temporary fix. At...
Forum: Off Topic Discussion 08-28-2017, 10:19 AM
Replies: 16
Views: 717
Posted By etduc
That's more info. Don't use open flame, at floor...

That's more info.

Don't use open flame, at floor level. Explosion risk, and carbon monoxide risk. Heater should be suspended, from ceiling, and have a source of fresh air. Electric heater, would...
Forum: General Discussion 08-24-2017, 04:49 PM
Replies: 10
Views: 695
Posted By etduc
It sounds fixable. There are shops around, that...

It sounds fixable. There are shops around, that fix trailers. Doesn't have to be a boat dealer.
Post a picture.
Forum: Engine / Drive Train 08-21-2017, 09:51 AM
Replies: 3
Views: 235
Posted By etduc
1)10w-40 (Lots of people use Rotella) You need a...

1)10w-40 (Lots of people use Rotella) You need a high zinc oil, for the flat tappet cam/lifters. Us a hand pump, similar to this: ...
Forum: Engine / Drive Train 08-21-2017, 09:38 AM
Replies: 8
Views: 429
Posted By etduc
Since the boat is a 1998. On it's second engine,...

Since the boat is a 1998. On it's second engine, 1st engine being an Indmar. That points to previous owner abuse, or lack of maintenance.
Forum: General Discussion 08-16-2017, 01:58 PM
Replies: 25
Views: 1,251
Posted By etduc
In an email from, David Goode. The county, just...

In an email from, David Goode. The county, just pulled the permit, siting alae bloom break out.
Forum: Waterskiing & Barefooting 08-08-2017, 09:21 AM
Replies: 1
Views: 147
Posted By etduc
Not specific, they go either style. Normal or...

Not specific, they go either style. Normal or goofy foot. :rolleyes:
Forum: General Discussion 08-07-2017, 02:35 PM
Replies: 26
Views: 1,256
Posted By etduc
I can speak, for the Response LXI. For those...

I can speak, for the Response LXI. For those years, there are two engines. Monson 340 (what I have) and Monson 360. The 340 will do 48 mph+, with driver. :D

One thing to consider, when you start...
Forum: Engine / Drive Train 08-02-2017, 09:27 AM
Replies: 3
Views: 183
Posted By etduc
Method for checking fluid level, has not changed...

Method for checking fluid level, has not changed in years. Run the engine, with fake-a-lake or in the water...a couple of minutes. Some say put engine in gear, some don't. If on the trailer, don't...
Forum: Engine / Drive Train 07-31-2017, 05:04 PM
Replies: 35
Views: 1,427
Posted By etduc
I loved those cars, always wanted one!

I loved those cars, always wanted one!
Forum: General Discussion 07-27-2017, 05:58 PM
Replies: 13
Views: 1,045
Posted By etduc
Mastercraft come to Longview, TX! Plenty of...

Mastercraft come to Longview, TX! Plenty of experience workers (Skeeter Industries, just down the road.) LEDCO (Longview Enconomic Development Corpoartion, in full swing...tell them I sent you. ...
Forum: Engine / Drive Train 07-24-2017, 09:55 AM
Replies: 2
Views: 144
Posted By etduc
Honestly, I haven't cleaned mine in over 2 years....

Honestly, I haven't cleaned mine in over 2 years. But a better practice, is with oil change.

K&N has a cleaning kit, available, (most online auto stores). Any soap and water will work.

As to...
Forum: General Discussion 07-21-2017, 05:24 PM
Replies: 47
Views: 3,244
Posted By etduc
Ocean dynamics, made a passenger side, for my 205...

Ocean dynamics, made a passenger side, for my 205 a couple of years ago. I made a card board pattern, then sent them all the parts of the frame. They're easy to deal with. Turn around in fall was 5...
Forum: General Discussion 07-11-2017, 05:53 PM
Replies: 19
Views: 1,272
Posted By etduc
Sure it's possible. Horse Power, and a flat...

Sure it's possible. Horse Power, and a flat bottom hull. Mastercraft had them, too.

What most people don't not know, to go this fast, in this type of boat. You need weight, in the boat. To keep...
Forum: General Discussion 07-07-2017, 09:14 AM
Replies: 9
Views: 357
Posted By etduc
Since you have a 20 year old boat. Why not just,...

Since you have a 20 year old boat. Why not just, go ahead, and do a trans rebuild?
Forum: Engine / Drive Train 07-06-2017, 09:19 AM
Replies: 16
Views: 705
Posted By etduc
I'm betting, on a bad seal. Clean with brake...

I'm betting, on a bad seal. Clean with brake cleaner, as it will evaporate. If you can find, the leak...clean the bilge...stuff newspaper under trans...let is sit.

You'd be surprised, how fast it...
Forum: Engine / Drive Train 07-05-2017, 05:00 PM
Replies: 16
Views: 705
Posted By etduc
Sounds like, a bad tranny seal (usually the front...

Sounds like, a bad tranny seal (usually the front seal). Fill cap, not tight. Crack hydraulic hose. (Usually, at a fitting)

A seal leak, is fairly slow. ( On my 205, I could get a full day,...
Forum: What is this boat worth? 06-30-2017, 01:05 PM
Replies: 10
Views: 959
Posted By etduc
Yes. What about the trailer?

Yes. What about the trailer?
Forum: Trailers 06-27-2017, 02:47 PM
Replies: 11
Views: 677
Posted By etduc
Single axle are fine for short hauls. They can...

Single axle are fine for short hauls. They can tend, to whip the tow vehicle around. So keep speed below 65 mph.

For long hauls, tandem axles are the way to go. A decent trailer, improves...
Forum: General Discussion 06-26-2017, 05:35 PM
Replies: 15
Views: 731
Posted By etduc
1995 have two engine options. 285 hp vs. 300...

1995 have two engine options. 285 hp vs. 300 hp,at the crank.

Either engine is more, than capable. My 94 205 (285 hp) pulled 2 bare bare footers (190lbs each) multiple times.

So don't knock at...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 03:40 PM.