Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Skyskiguy
Forum: Upholstery 06-17-2018, 05:04 PM
Replies: 5
Views: 150
Posted By Skyskiguy
I’ve had excellent results with...

I’ve had excellent results with...
Forum: General Discussion 06-12-2018, 11:03 AM
Replies: 9
Views: 560
Posted By Skyskiguy
Yes, in some areas the canyon walls are coated...

Yes, in some areas the canyon walls are coated with mussels. I was at Bullfrog in April - upstream from Bullfrog most of the canyon walls are covered with them. It created a gray “ring” around the...
Forum: Wakesurfing 06-10-2018, 09:57 PM
Replies: 5
Views: 123
Posted By Skyskiguy
All three pumps are behind the carpeted modesty...

All three pumps are behind the carpeted modesty panel at the rear of the engine compartment. Remove the pumps then pull the brass covers to reveal the impeller.
Forum: Wakesurfing 06-10-2018, 06:49 PM
Replies: 5
Views: 123
Posted By Skyskiguy
Have you checked the impellers in the pumps?

Have you checked the impellers in the pumps?
Forum: Trailers 06-05-2018, 09:44 PM
Replies: 6
Views: 285
Posted By Skyskiguy
Used Reliable brand actuator parts that are in...

Used Reliable brand actuator parts that are in good working order will likely be hard to find - and probably a temporary fix.
Forum: Trailers 06-04-2018, 08:16 PM
Replies: 6
Views: 285
Posted By Skyskiguy
If you’re lucky you might find a used one. ...

If you’re lucky you might find a used one. Likely going to have to swap the whole thing for a UFP.
Forum: For Sale: Boats 05-26-2018, 09:29 PM
Replies: 8
Views: 1,966
Posted By Skyskiguy
Search is finally over. Thanks, Srock!

Search is finally over.
Thanks, Srock!
Forum: Trailers 05-22-2018, 07:43 PM
Replies: 7
Views: 392
Posted By Skyskiguy
Ramp n Clamp

Ramp n Clamp
Forum: General / Other 05-22-2018, 07:03 PM
Replies: 12
Views: 327
Posted By Skyskiguy
This is correct. Insert top end of bi-fold panel...

This is correct. Insert top end of bi-fold panel first, unfolded about ½ way. Then push the bottom into my place as you finish opening it up fully.
Forum: General / Other 05-22-2018, 04:03 PM
Replies: 3
Views: 189
Posted By Skyskiguy
Look for an in-line fuse behind the helm.

Look for an in-line fuse behind the helm.
Forum: General / Other 05-20-2018, 12:39 PM
Replies: 3
Views: 122
Posted By Skyskiguy
Replacing the heater core is an easy DIY. Your...

Replacing the heater core is an easy DIY. Your description of the bypass method is accurate - simply disconnect both the supply and return hoses from the core and join them, bypassing the core until...
Forum: For Sale: Boats 05-20-2018, 12:19 AM
Replies: 8
Views: 1,966
Posted By Skyskiguy
Awesome! Sold! Sent you a PM. Thank you!

Awesome! Sold! Sent you a PM.
Thank you!
Forum: Electrical 05-13-2018, 05:58 PM
Replies: 3
Views: 122
Posted By Skyskiguy
Look for a 2 amp in-line fuse behind the helm.

Look for a 2 amp in-line fuse behind the helm.
Forum: Off Topic Discussion 05-11-2018, 02:05 AM
Replies: 19
Views: 790
Posted By Skyskiguy
I have a 2010 ESV. Love it for towing the boat. ...

I have a 2010 ESV. Love it for towing the boat. Full time AWD isn’t necessary but was standard in 2010. 6.2 is awesome and 6 speed tranny has been flawless. Gas mileage is lousy. Had to replace...
Forum: General Discussion 05-03-2018, 08:38 AM
Replies: 24
Views: 1,223
Posted By Skyskiguy
I have it on my transom. PO had it installed. ...

I have it on my transom. PO had it installed. It’s held up great and still looks phenomenal.
Forum: General Discussion 05-03-2018, 12:00 AM
Replies: 5
Views: 274
Posted By Skyskiguy
Push down then turn ¼ turn, counter clockwise. ...

Push down then turn ¼ turn, counter clockwise. Then it should pull up and out.
Forum: General Discussion 04-30-2018, 03:38 PM
Replies: 4
Views: 346
Posted By Skyskiguy
I think it is HDPE - plastic.

I think it is HDPE - plastic.
Forum: Storage / Winterization 04-27-2018, 10:33 PM
Replies: 5
Views: 770
Posted By Skyskiguy
They didn’t get the heater core blown out. I...

They didn’t get the heater core blown out. I always blow mine dry before pouring antifreeze in. Just running antifreeze through they block will not likely clear the core of all the water. ...
Forum: Wakesurfing 04-16-2018, 10:08 PM
Replies: 26
Views: 1,163
Posted By Skyskiguy
On the lower step and as far back as will hold. ...

On the lower step and as far back as will hold. The beauty of the SeaStow handle used on the BoB v5 is that the suction cups are small enough to fit on that lower step.
Forum: Wakesurfing 04-16-2018, 02:22 PM
Replies: 26
Views: 1,163
Posted By Skyskiguy
A more affordable option is the BoBv5 home-made...

A more affordable option is the BoBv5 home-made suck gate. Tried one on my X30 and it does remarkably well at creating a very nice...
Forum: Wakesurfing 04-16-2018, 02:16 PM
Replies: 26
Views: 1,163
Posted By Skyskiguy
Go Surf Assist

Go Surf Assist
Forum: For Sale: Boats 04-14-2018, 09:43 PM
Replies: 8
Views: 1,966
Posted By Skyskiguy
Still looking. Anyone have one they'd part with?

Still looking. Anyone have one they'd part with?
Forum: For Sale: Watersports Equipment 04-14-2018, 09:35 PM
Replies: 1
Views: 417
Posted By Skyskiguy
Bump. Anyone in need of a bag? $140.

Bump. Anyone in need of a bag? $140.
Forum: General Discussion 04-14-2018, 06:34 PM
Replies: 5
Views: 405
Posted By Skyskiguy
The depression is indeed there for a latch - the...

The depression is indeed there for a latch - the Maristar series had a ski locker in the floor in place of a KGB tank. The latch to open the ski locker would go in the depression.
Forum: General Discussion 04-14-2018, 10:39 AM
Replies: 653
Views: 132,035
Posted By Skyskiguy
I mounted mine on a bracket I fabricated to bolt...

I mounted mine on a bracket I fabricated to bolt to one of the tower bolts UNDER the top deck, just in front of the driver. It picks up satellite signal just fine through the fiberglass.
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 04:16 PM.


2018