Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 144
Search took 0.15 seconds.
Search: Posts Made By: Bob B
Forum: Trailers Yesterday, 11:15 AM
Replies: 1
Views: 90
Posted By Bob B
MODELS A-60, breakaway cable

Do I have to remove the tongue to install the cable? I have looked at the dwg. but it covered with a bottom plate.
Forum: Trailers 07-21-2014, 09:42 AM
Replies: 4
Views: 171
Posted By Bob B
I have a Mastercraft 2002 trailer and I bent a...

I have a Mastercraft 2002 trailer and I bent a spindle in 2009. I had to replace the axle.
The axle was a Dyra-flex 5200Lbs.
Purchased the replacement from UFP.
Forum: General Discussion 06-30-2014, 11:19 AM
Replies: 3
Views: 226
Posted By Bob B
add hoses to the grease fittings

There was a post that showed how to add hoses to the grease fittings for the rudder and the steering.
Can some one direct me to the thread or tell me there I can buy the hoses?
Forum: General Discussion 06-23-2014, 09:47 PM
Replies: 16
Views: 404
Posted By Bob B
That's what I did. I ordered thru my dealer. And...

That's what I did. I ordered thru my dealer. And I was at my house in 2 days.
Forum: General Discussion 06-21-2014, 02:25 PM
Replies: 4
Views: 188
Posted By Bob B
mastercraft medallion mdc 7018-00001-01 is what...

mastercraft medallion mdc 7018-00001-01 is what is in my boat.
One connector has 10 contacts and the other has 24 contacts.
Any more suggestions?
Forum: General Discussion 06-18-2014, 02:51 PM
Replies: 4
Views: 188
Posted By Bob B
gages 2002 Prostar197 not working. kill switch doesn't stop boat

The gages on my 2002 Prostar 197 are not working. Boat runs OK and when I pull kill switch it still runs.. Any suggestions on what is wrong?
Forum: General Discussion 06-11-2014, 12:11 AM
Replies: 10
Views: 315
Posted By Bob B
I tow my 2002 197 with a cover and I don' t use...

I tow my 2002 197 with a cover and I don' t use poles.(600 mile round trip)
Forum: General / Other 06-05-2014, 08:29 PM
Replies: 13
Views: 542
Posted By Bob B
[QUOTE=Bob B;1051954]Why don't you just tie a...

[QUOTE=Bob B;1051954]Why don't you just tie a bowline

I didn't know that you wanted to adjust the length of the line.
Forum: General / Other 06-05-2014, 07:26 PM
Replies: 13
Views: 542
Posted By Bob B
Why don't you just tie a bowline knot?

Why don't you just tie a bowline knot?
Forum: General / Other 05-21-2014, 01:06 PM
Replies: 3
Views: 146
Posted By Bob B
If It Is “perfectpass”, It Should Have An Arrow...

If It Is “perfectpass”, It Should Have An Arrow On Top Of The Cap. Point It Fwd.
Forum: General Discussion 05-15-2014, 01:34 PM
Replies: 2
Views: 148
Posted By Bob B
If it is a PerfectPass system: phone 902-468-2150

If it is a PerfectPass system:

phone 902-468-2150
Forum: General Discussion 05-12-2014, 11:12 PM
Replies: 4
Views: 242
Posted By Bob B
If you are testing the paddle wheel before...

If you are testing the paddle wheel before installation , the wheel needs to be rotating. I used a tube inflater to spin the wheel.
Yes, it is direct current.(DC)
Forum: Trailers 04-02-2014, 07:14 PM
Replies: 37
Views: 1,285
Posted By Bob B
I have a 2002 Prostar 197. I make at least one...

I have a 2002 Prostar 197. I make at least one round trip, and sometimes more, of 600 miles every year to a lake. I have been doing this since 2002. I tow with the Mastercraft cover that I purchased...
Forum: Trailers 04-02-2014, 04:41 PM
Replies: 37
Views: 1,285
Posted By Bob B
cover on.

cover on.
Forum: General Discussion 03-29-2014, 12:16 PM
Replies: 67
Views: 3,466
Posted By Bob B
That is what many private lakes in my area are...

That is what many private lakes in my area are doing and BIG fines if you are the one that bring them into the lake.

Also,Car wash close to my lake has just installed this equipment:

Normally the...
Forum: General Discussion 03-29-2014, 11:14 AM
Replies: 67
Views: 3,466
Posted By Bob B
If you drain your motor, bilge, etc. on the ramp...

If you drain your motor, bilge, etc. on the ramp before you put the boat in the water that water run into the lake.
Forum: General Discussion 02-20-2014, 12:22 PM
Replies: 12
Views: 487
Posted By Bob B
still doesn't work for me.

still doesn't work for me.
Forum: General Discussion 02-20-2014, 12:07 PM
Replies: 12
Views: 487
Posted By Bob B
I tried that yesterday and it did not work. I...

I tried that yesterday and it did not work. I will try again today. Thx.
Forum: General Discussion 02-19-2014, 09:23 PM
Replies: 12
Views: 487
Posted By Bob B
..Why?

..Why?
Forum: General Discussion 02-19-2014, 08:49 PM
Replies: 12
Views: 487
Posted By Bob B
Because it says my e mail already has an acct.....

Because it says my e mail already has an acct.. Note .. This is on mastercraft.com, design a boat.
Forum: General Discussion 02-19-2014, 05:42 PM
Replies: 12
Views: 487
Posted By Bob B
password on Mastercraft.com

How do I reset my password on Mastercraft.com?
I am trying to design a 2014 PROSTAR 197.
The site will not let my chg my password because I do not know the hull Id of my current boat.
I can’t send...
Forum: Electrical 02-09-2014, 10:37 AM
Replies: 6
Views: 759
Posted By Bob B
http://www.perfectpass.com/?q=troubleshooting

http://www.perfectpass.com/?q=troubleshooting
Forum: Trailers 01-23-2014, 05:16 PM
Replies: 9
Views: 428
Posted By Bob B
Yes it included brakes

Yes it included brakes
Forum: Trailers 01-23-2014, 03:26 PM
Replies: 9
Views: 428
Posted By Bob B
In 2009, I replaced the axle on my 2002 Prostar...

In 2009, I replaced the axle on my 2002 Prostar 197 trailer.
Purchased axle from UPF for $628 and drop shipped to a local trailer repair shop.
They charged $120 to install.
Forum: General Discussion 01-19-2014, 11:14 AM
Replies: 230
Views: 19,410
Posted By Bob B
I bought a MC 1982 Stars & Stripes in 1983.

I bought a MC 1982 Stars & Stripes in 1983.
Showing results 1 to 25 of 144

 

All times are GMT -4. The time now is 04:19 AM.