Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 500
Search took 0.55 seconds.
Search: Posts Made By: kgrove
Forum: Off Topic Discussion Yesterday, 05:58 PM
Replies: 69
Views: 3,568
Posted By kgrove
My experience is you can predict the behavior of...

My experience is you can predict the behavior of an HOA better by knowing the demographics of the residents than you can by reading the rules themselves. I hate generalizing, but it seems retirees...
Forum: Electrical 08-24-2015, 03:57 PM
Replies: 6
Views: 193
Posted By kgrove
Took batteries out and had them tested. One of...

Took batteries out and had them tested. One of them was only at 6.8v. I'm going to replace both since they were almost three years old anyway. Fair chance that fixes the problem, or if the problem...
Forum: Electrical 08-23-2015, 04:02 PM
Replies: 6
Views: 193
Posted By kgrove
I think it's called the BIG... 2011 X-25 with a...

I think it's called the BIG... 2011 X-25 with a 4-5" screen dead center in the dash behind the steering wheel, small "mouse" to the right of that to move through screens and make selection. I didn't...
Forum: Electrical 08-23-2015, 01:45 PM
Replies: 6
Views: 193
Posted By kgrove
Pause in accessory power?

Yesterday I noticed a new problem. At idle, there was a brief pause in the power supplied to both the stereo and dc plug powering my air pump. About every 5-10 seconds, the stereo sound would stop...
Forum: General Discussion 08-21-2015, 11:07 AM
Replies: 10
Views: 458
Posted By kgrove
At the slow speed your talking about (10-15mph)...

At the slow speed your talking about (10-15mph) I'm not sure any wakeboard boat will have a clean wake.

My boat (X-25) has an earned reputation for not being friendly to beginners because of a big...
Forum: Off Topic Discussion 08-18-2015, 06:24 PM
Replies: 43
Views: 1,432
Posted By kgrove
Deer Valley in particular should not be crowded,...

Deer Valley in particular should not be crowded, but partly because it is more expensive. I haven't been to Park City in a few years, but it is a huge resort and I never found it any more crowded...
Forum: General Discussion 08-18-2015, 06:17 PM
Replies: 12
Views: 429
Posted By kgrove
At some point no amount of technique will get a...

At some point no amount of technique will get a rider up if they are too heavy relative to their upper body strength, but a couple things can help even the odds:

1) make sure the board is big...
Forum: Off Topic Discussion 08-16-2015, 04:11 PM
Replies: 43
Views: 1,432
Posted By kgrove
This is one of the biggest differences between JH...

This is one of the biggest differences between JH and the OP's experience at Keystone. JH can get really cold. Sun Valley is a little bit the same way. Being further north, both are more likely to...
Forum: General Discussion 08-10-2015, 03:49 PM
Replies: 41
Views: 2,203
Posted By kgrove
Eventually it would go through Powell, Mead,...

Eventually it would go through Powell, Mead, Mohave, Havasu, then work it's way down the Colorado to the Sea of Cortez. Phoenix, Los Angeles, San Diego, and all the farms in Arizona and southern /...
Forum: General Discussion 06-29-2015, 07:25 PM
Replies: 10
Views: 649
Posted By kgrove
One of those two activities is actually quite...

One of those two activities is actually quite difficult and takes real skill. The other is just silly, goofy fun.
Forum: General Discussion 06-29-2015, 04:56 PM
Replies: 37
Views: 2,140
Posted By kgrove
Yeti's indeed do insulate much better than cheap...

Yeti's indeed do insulate much better than cheap coolers. Whether it's worth it is really dependent on how you use the cooler. There are two ways coolers get warm - thermal loss through the walls or...
Forum: General Discussion 06-28-2015, 02:36 AM
Replies: 7
Views: 331
Posted By kgrove
Is there anything else electrical that seems to...

Is there anything else electrical that seems to be malfunctioning as well? Or just the screen? Have you checked breakers?
Forum: Off Topic Discussion 06-24-2015, 11:08 AM
Replies: 14,719
Views: 4,240,827
Posted By kgrove
From the angle the photo was taken, I don't think...

From the angle the photo was taken, I don't think that's his thumb! At least she's not laughing.
Forum: Trailers 05-28-2015, 01:23 PM
Replies: 49
Views: 3,540
Posted By kgrove
My trailer repair guy called and confirmed - UFP...

My trailer repair guy called and confirmed - UFP did indeed change the spec on the A60 actuator to 7500#, but has not updated the pdf on their website.
Forum: Trailers 05-28-2015, 12:44 AM
Replies: 49
Views: 3,540
Posted By kgrove
That't the plan. Possible UFP just hasn't updated...

That't the plan. Possible UFP just hasn't updated the pdf on their website for the new weight limit. Also possible one third party copied the info off the A75 and now it just keeps getting repeated...
Forum: Trailers 05-27-2015, 09:37 PM
Replies: 49
Views: 3,540
Posted By kgrove
hmmm… will have to call in the morning and...

hmmm… will have to call in the morning and confirm. UFP's website indicates the A60 is 6000#. I'm also a little suspicious that the pacific trailers website shows the "now 7500 lbs" comment for both...
Forum: Trailers 05-27-2015, 04:04 PM
Replies: 49
Views: 3,540
Posted By kgrove
So it turns out my master cylinder was bad and I...

So it turns out my master cylinder was bad and I have to do the UFP conversion, but I'm stuck. My trailer guy wants to install the UFP A75 because the trailer has a sticker that says it's rated to a...
Forum: Trailers 05-19-2015, 12:46 PM
Replies: 49
Views: 3,540
Posted By kgrove
There is fluid - kind of dirty gray. I'm not...

There is fluid - kind of dirty gray. I'm not getting slamming, but I'm also not getting a feeling of strong braking. I disconnected the pigtail connection and put the truck in reverse, and if I surge...
Forum: Trailers 05-19-2015, 12:57 AM
Replies: 49
Views: 3,540
Posted By kgrove
Damn... I think I probably need to do this as...

Damn... I think I probably need to do this as well. What's the best test to confirm my actuator is hosed? I'm thinking if I try backing up the trailer with the trailer plug disconnected should be...
Forum: General Discussion 05-18-2015, 01:34 PM
Replies: 4
Views: 445
Posted By kgrove
I'd start with Uship. You'll get multiple bids...

I'd start with Uship. You'll get multiple bids and will get to choose your shipping method as well as which shipper you use. Search hear - mostly good experiences.
Forum: General Discussion 04-29-2015, 07:33 PM
Replies: 13
Views: 914
Posted By kgrove
I've always thought the automated aspect of the...

I've always thought the automated aspect of the ballast systems was not worth much anyway. Generically there are two ways you can add plumbed ballast.

One, you can add bags in series with your...
Forum: General Discussion 04-29-2015, 07:16 PM
Replies: 7
Views: 406
Posted By kgrove
The 750 won't fit in the rear locker, at least...

The 750 won't fit in the rear locker, at least not without holding less than 750#. The rear facing seat takes up a portion of the rear most section of the locker, so the actual storage volume is...
Forum: General Discussion 04-21-2015, 11:29 AM
Replies: 14
Views: 831
Posted By kgrove
From a performance standpoint (stability,...

From a performance standpoint (stability, strength), the 4 pt tower is at least as good as the 2 pt tower. The 4 pt tower is a pain in the a$$ to lower if you frequently need to drop the tower for...
Forum: General Discussion 04-15-2015, 12:32 PM
Replies: 11
Views: 773
Posted By kgrove
Even when opening both gas caps, mine still...

Even when opening both gas caps, mine still sometimes burped gas at the end but nowhere near as frequently. The only way to guarantee it didn't happen was to stop filling just a little bit before I...
Forum: General Discussion 03-25-2015, 01:22 PM
Replies: 30
Views: 1,323
Posted By kgrove
Agree NADA not a great source, but there isn't a...

Agree NADA not a great source, but there isn't a great source of actual sales data that I'm aware of to tell you real values. What I usually do to estimate value is scan onlyinboards and boatttrader,...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 04:01 AM.