Go Back   TeamTalk > Search Forums

Showing results 1 to 25 of 385
Search took 0.02 seconds.
Search: Posts Made By: MLA
Forum: Off Topic Discussion Today, 12:25 AM
Replies: 232
Views: 14,603
Posted By MLA
Sun rise over Lake Mead from Temple Bar marina,...

Sun rise over Lake Mead from Temple Bar marina, Sat a week ago. 20 minutes later, we were surfing.

http://i45.photobucket.com/albums/f97/Lake_Mead_Tiges/IMG_5926_zps5f034c1b.jpg...
Forum: Storage / Winterization Yesterday, 10:14 PM
Replies: 22
Views: 450
Posted By MLA
If you drain the block of water prior to the...

If you drain the block of water prior to the introduction of the marine/rv antifreeze, is will fill, once you fire the engine back up. This insures you have nearly zero dilution of the antifreeze....
Forum: General / Other 09-28-2014, 05:36 PM
Replies: 7
Views: 259
Posted By MLA
Drill, tap and install one

Drill, tap and install one
Forum: Audio/Stereo 09-21-2014, 08:11 PM
Replies: 2
Views: 183
Posted By MLA
Wet Sounds SD-6 if you are certain that those...

Wet Sounds SD-6 if you are certain that those will be in the near future. For a single amp for a pro-485, the HT-2 is perfect.
Forum: Electrical 09-16-2014, 03:41 PM
Replies: 5
Views: 212
Posted By MLA
Ideally, you would be looking at 2 amps to drive...

Ideally, you would be looking at 2 amps to drive a pair of Rev-10 and 2 subs, then I guess theres an amp for the in-boats. I would do a large gauge trunk like off the battery/battery switch to amp...
Forum: Electrical 09-14-2014, 09:07 PM
Replies: 5
Views: 212
Posted By MLA
1) 12V batteries could not be wired in series on...

1) 12V batteries could not be wired in series on a 12V engine system. But to answer your basic question, no, the alternator would not do well at recharging them if they are run down.

2) Really...
Forum: Audio/Stereo 09-14-2014, 10:38 AM
Replies: 13
Views: 505
Posted By MLA
Head-unit red (at the head unit, but could be any...

Head-unit red (at the head unit, but could be any color at the helm) turn-on to the ACC1 switched output. Bypass the key switch all together for the radio.
Forum: Audio/Stereo 09-13-2014, 05:45 PM
Replies: 13
Views: 505
Posted By MLA
I would worry less with how its currently wired,...

I would worry less with how its currently wired, and concentrate on how it needs to be wired to achieve your goal

You ACC rocker needs to have a constant B+ when the battery switch is on, or all the...
Forum: Audio/Stereo 09-08-2014, 10:30 AM
Replies: 13
Views: 505
Posted By MLA
Yes. Seems as if someone attempted to do what you...

Yes. Seems as if someone attempted to do what you are wanting to, but didnt quite get it. If it was wired correctly to the ACC1, it would not be effected by the key switch. its 12v input would be...
Forum: Audio/Stereo 09-08-2014, 06:42 AM
Replies: 13
Views: 505
Posted By MLA
You will need to isolate the head-units turn-on...

You will need to isolate the head-units turn-on wire and move it from the IGN terminal to the ACC terminal. Or, relocated it to a rocker switch.
Forum: Audio/Stereo 09-07-2014, 09:25 PM
Replies: 13
Views: 505
Posted By MLA
Are you talking about the key switch and a rocker...

Are you talking about the key switch and a rocker switch? I would prefer the head-unit turn-on to no be tied to the key switch.
Forum: Towers 09-07-2014, 06:01 PM
Replies: 1
Views: 135
Posted By MLA
looks like you need thicker inserts.

looks like you need thicker inserts.
Forum: Electrical 09-05-2014, 10:49 PM
Replies: 12
Views: 358
Posted By MLA
The typical 4 wire GM style IAC is a PWM...

The typical 4 wire GM style IAC is a PWM controlled motor, so there is not a constant voltage reading.
Forum: Electrical 09-05-2014, 09:45 PM
Replies: 12
Views: 358
Posted By MLA
An IAC motor issue will not alter the fuel/air...

An IAC motor issue will not alter the fuel/air ratio. It will not create a rough running engine, only too slow, too fast or correct idle speed.
Forum: General Discussion 08-29-2014, 07:53 PM
Replies: 13
Views: 767
Posted By MLA
replace it

replace it
Forum: Audio/Stereo 08-28-2014, 09:19 PM
Replies: 4
Views: 325
Posted By MLA
Not a huge difference going from the current 10W3...

Not a huge difference going from the current 10W3 @ 400W to the HT-10 @ 500W. So I would consider keeping the 600/1 and stepping up to a 12 4 ohm DVC.

Leave the 600/6 for in-boats with 2 open chnls...
Forum: Audio/Stereo 08-28-2014, 04:27 PM
Replies: 4
Views: 325
Posted By MLA
Is the W3 2 ohm or 4 ohm?

Is the W3 2 ohm or 4 ohm?
Forum: General Discussion 08-22-2014, 09:54 PM
Replies: 45
Views: 2,160
Posted By MLA
No, they are a franchise type deal. My friend...

No, they are a franchise type deal. My friend owns 2 since they were a Mail Boxes Etc.
Forum: General Discussion 08-22-2014, 06:11 PM
Replies: 22
Views: 879
Posted By MLA
Thats correct, but when you look at the cost of a...

Thats correct, but when you look at the cost of a 3 mil PUP compared to increasing your boat policy liability by a few hundred K above the min needed, you will quickly see that a PUP makes sense. In...
Forum: General Discussion 08-22-2014, 04:23 PM
Replies: 22
Views: 879
Posted By MLA
Get a PUP, typically way cheaper for way more...

Get a PUP, typically way cheaper for way more liability. They cover you on and off the water.
Forum: Audio/Stereo 08-20-2014, 01:45 PM
Replies: 4
Views: 324
Posted By MLA
If you are buying replacement woofers, providing...

If you are buying replacement woofers, providing they are still available, for those component sets, then yes, you can just reuse the tweeter and cross-over. If you are going to purchase a new set of...
Forum: Audio/Stereo 08-19-2014, 07:28 AM
Replies: 6
Views: 551
Posted By MLA
The CMD5 requires a standard 2" x 7" cutout. So...

The CMD5 requires a standard 2" x 7" cutout. So unless the one cutting that whole went hog wild, all you will need a thin ABS trim plate to cover the mounting screw holes left by the CMD5.
Forum: Electrical 08-17-2014, 11:54 AM
Replies: 14
Views: 399
Posted By MLA
Now we are getting somewhere, thanks for clearing...

Now we are getting somewhere, thanks for clearing that up.

Seth, does the meter you used to take those measurements with, read in tenths and hundredths? Where those voltage readings exact? Reason I...
Forum: Electrical 08-17-2014, 08:01 AM
Replies: 14
Views: 399
Posted By MLA
So its a diode? Thats what im trying to figure...

So its a diode? Thats what im trying to figure out?
Forum: Electrical 08-17-2014, 07:37 AM
Replies: 14
Views: 399
Posted By MLA
So its the factory installed VSR? On the main...

So its the factory installed VSR? On the main side of the VSR, you are reading alternator output and on the house battery side, you are dropping voltage? Whats the condition of that battery and its...
Showing results 1 to 25 of 385

 

All times are GMT -4. The time now is 12:48 PM.